Meridian 3100 - Manual
Meridian 3100 – Manual, read for free online in PDF format. We hope this helps you resolve any issues you may have. If you have further questions, please contact us through the contact form.
Table of Contents:
- Page 2 – Digital Signal Processing; Power amplifi ers; Copyright and acknowledgements
- Page 8 – Specifications
- Page 9 – Choosing a standard setting; To select a standard setting; Custom configuration
- Page 11 – Configuring sources; RD Radio; Configuring the frequency response; Setup; Store
- Page 13 – Radio; Changing the display; Display; Adjusting the volume; Mute; Muted
- Page 15 – Adjusting the sound; To change the treble or bass; Troubleshooting
3100
D S P L O U D S P E A K E R
I N S T A L L A T I O N
A N D U S E R G U I D E
Connecting a 3100 loudspeaker as a centre
speaker
/,
/
"1/*1/
"-
ΣääÊÕ`ëi>iÀÊqÊiÌÀi
iÀ`>Ê-ÕÀÀÕ`Ê*ÀViÃÃÀ
xÊi>`
"-
*1/Ê"1/*1/
/Ê *1/
£
Ó
/
"1/*1/
You can use a single 3100 loudspeaker as a centre speaker in a Meridian surround
system.
• Connect the speaker to the CENTRE digital output using an M5 lead, as shown in
the illustration.
Digital inputs and outputs
•
2 x cable inputs, 32–96kHz. FIFO locks at
44.1, 48, 88.2, or 96kHz ±150ppm.
•
PCM using IEC958, or MHR connection
support with auto-detection.
•
1 x 24-bit Multi-bit delta-sigma DACs
with 128x oversampling.
Signal processing
•
1 Motorola 56367 running at 150MHz.
•
3 x 24-bit Multi-bit delta-sigma DACs
with 128x oversampling.
•
Crossover linear-phase ±30º at 2.6kHz.
Output stages
•
Power amplifi ers: Complementary
bipolar design, with output-stage error
correction and twin loop design.
•
Bass/Mid: 75W.
•
Tweeter: 50W.
Acoustic
•
DSP3100: 2 way, vented box;
DSP3100HC: 2½ way, closed box.
•
DSP3100: 1 x 160mm (6.5");
DSP3100HC: 2 x 120mm (5.25"); doped
carbon fi bre high-effi ciency long-throw
drivers.
•
Treble drive unit: 1 x 25mm (1") Meridian
piston doped fabric dome.
Characteristics
•
Distortion typically <0.01%, or <0.02%
up to full power at all frequencies.
•
Noise and hum <-94dBr at all volume
settings.
•
Acoustic output typically >111dB spl @
1m.
•
Acoustic noise <15dB spl @ 1m.
•
Frequency response in room response
within 3dB, 45Hz-20kHz.
Control
•
2 x Meridian Comms.
•
9-pin D connector for RS232 PC control,
null modem, 9600 baud, 2N1, no HS.
Cabinet
•
Bonded aluminium panels.
•
MDF cloth-covered grille.
•
Silver/black fi nish.
•
DSP3100: 194 x 386 x 254mm (7.65 x 15.2
x 10") (W x H x D), 12kg (27lb).
•
DSP3100HC: 470 x 174 x 254mm (18.5 x
6.9 x 10") (W x H x D), 15kg (33lb).
Power
•
100-125; 200-250V AC 50-60Hz.
•
20VA standby; 600VA max.
Meridian Audio reserves the right to amend
product specifi cations at any time.
Specifications
"Loading the manual" means you need to wait until the file loads and becomes available for online reading. Some manuals are very large, and the time they take to appear depends on your internet speed.
Summary
About your Meridian DSP loudspeakers These instructions provide information about unpacking, connecting up, confi guring, and using your Meridian 3100 DSP loudspeakers. They apply to the DSP3100 left and right loudspeakers, and the DSP3100HC horizontal centre loudspeaker. Introduction Meridian DSP l...
3100 D S P L O U D S P E A K E R I N S T A L L A T I O N A N D U S E R G U I D E Connecting a 3100 loudspeaker as a centre speaker /, / "1/*1/ "- ΣääÊÕ`ëi>iÀÊqÊiÌÀi iÀ`>Ê-ÕÀÀÕ`Ê*ÀViÃÃÀ xÊi>` "- *1/Ê"1/*1/ /Ê *1/ £ Ó / "1/*1/ You can use a single 3100 loudsp...
Choosing a standard setting Unless you are using a pair of 3100 loudspeakers in a 2-channel system, you will need to confi gure them as described in this section. The DSP loudspeakers provide the following fi ve alternative standard settings, called Types, which confi gure all aspects of the DSP lou...
