McIntosh MSS630 - Manual - manualsarea.com

Page 2 - Please take a short time to read the information in this; A McIntosh MSS530 Loudspeaker System consists of a pair

2 Table of Contents Thank You .......................................................................... 2Please Take a Moment ....................................................... 2Technical Assistance .......................................................... 2Customer Service .....................

Page 3 - Safety Instructions; IMPORTANT SAFETY; PLEASE READ THEM BEFORE

3 Safety Instructions IMPORTANT SAFETY INSTRUCTIONS! PLEASE READ THEM BEFORE OPERATING THIS EQUIPMENT. General: 1. Read all the safety and operating instructions, con- tained in this owner’s manual, before operating thisequipment. 2. Retain this owner’s manual for future reference about safety and o...

Page 4 - Patented Technology

4 Performance Features Introduction ••••• Patented Technology The widely acclaimed McIntosh LD/HP ® (Low Distortion/ High Performance) Magnetic Circuit Design 1 dramatically reduces harmonic distortion. ••••• Special Woofer/Midrange Driver Design The Woofer/Midrange Driver utilizes injection moldedB...

Page 5 - Introduction, Performance Features and Overall Dimensions

5 Introduction, Performance Features and Overall Dimensions 5.4" 13.59cm 6.1" 15.49cm Front View of the MS20 Tweeter Driver Side View of the MS20 Tweeter Driver Rear View of the MS20 Tweeter Driver Front Viewof the MS530Woofer/MidrangeDriver Side Viewof the MS530Woofer/MidrangeDriver Side Vi...

Page 6 - Note: If the mounting surface opening is made too large the

6 Installation Mounting the Tweeter 1. Using the enclosed template as a guide, mark and drill the four pilot holesfor the mountingscrews. Drill themounting holes withan appropriate sizedrill bit. 2. Cut out the marked circle in the tem-plate, and using it asa guide, mark andcutout the circularhole f...

Page 7 - Installation; Using the Crossover as; Mounting the Crossover

7 Installation When selecting a Crossover mounting location, make surethere is adequate room for ventilation (there are openingson both sides of the Cross-over) and for making con-nections to it. Use the sup-plied screws for mountingthe Crossover to the vehicle. 1. Using the Crossover as a template,...

Page 8 - Press the connector ends of the supplied Woofer/; Note: There are two additional Tweeter Positive Terminal

8 Left Crossover NetworkInput Connection Side How to Connect a Two Way System How to Connect a Two Way System Right Woofer/Midrange Right Tweeter 1. Press the connector ends of the supplied Woofer/ Midrange Red/Black cables onto the matching Woofer/Midrange connecting lugs. 2. Attach the other ends ...

Page 9 - How to Connect a Three Way System

9 McIntosh 4 Channel Power Amplifier How to Connect a Three Way System How to Connect a Three Way System Left Crossover NetworkInput Connection Side Right Woofer/Midrange Right Tweeter Left Crossover NetworkOutput Connection Side Right Crossover NetworkInput Connection Side Right Crossover NetworkOu...

Page 10 - System Parameters

10 Specifications MSS630 System Specifications System Parameters Peak Power 120 Watts Continuous Power (EIA + H.P.) 60 Watts Frequency Response 80 Hz - 20kHz System Sensitivity 1 85 dB Nominal Impedance (Znom) 4 Ohms Crossover Frequency 2400 Hz Low Pass Slope 12 db/oct High Pass Slope 12 db/oct MS53...

Page 12 - Chambers Street

McIntosh Part No. 040826 McIntosh Laboratory, Inc. 2 Chambers Street Binghamton, NY 13903