Mazda 2006 MX-5 - Manual
Mazda 2006 MX-5 – Manual, read for free online in PDF format. We hope this helps you resolve any issues you may have. If you have further questions, please contact us through the contact form.
Table of Contents:
- Page 2 – PLACE FLAT TIPPED SCREWDRIVER INTO
- Page 3 – PLACE GUIDES
- Page 4 – PLACE FLAT TIPPED SCREWDRIVER
- Page 5 – WARRANTY INFORMATION; FIRMLY PRESS DOWN ON REAR
Page 1 of 5
CONSUMER NOTICE
: The information and instructions in this bulletin are intended for use by skilled technicians. Mazda technicians utilize the proper tools/
equipment and take training to correctly and safely maintain Mazda vehicles. These instructions should not be performed by “do-it-yourselfers.” Customers
should not assume this bulletin applies to their vehicle or that their vehicle will develop the described concern. To determine if the information applies,
customers should contact their nearest authorized Mazda dealership. Mazda North American Operations reserves the right to alter the specifications and
contents of this bulletin without obligation or advance notice. All rights reserved. No part of this bulletin may be reproduced in any form or by any means,
electronic or mechanical---including photocopying and recording and the use of any kind of information storage and retrieval system ---without permission in
writing.
© 2006 Mazda Motor of America, Inc.
Subject:
CENTER CONSOLE LID WILL NOT STAY CLOSED
Bulletin No:
09-033/06
Last Issued:
7/21/2006
Service Bulletin
Mazda North American Operations
Irvine, CA 92618-2922
2006 MX-5 - CENTER CONSOLE LID WILL NOT STAY CLOSED
APPLICABLE MODEL(S)/VINS
2006 MX-5
DESCRIPTION
On some vehicles, the center console lid may not stay in the closed position due to a broken latch.
Customers having this concern should have the console lid replaced using the following repair procedure.
REPAIR PROCEDURE
1. Verify customer concern.
2. Remove the center console from the vehicle. Refer to Workshop Manual section 09-17 CONSOLE
REMOVAL / INSTALLATION.
3. Remove the cup holder from the center console. Refer to Workshop Manual section 09-17 CONSOLE DIS-
ASSEMBLY / ASSEMBLY.
4. Slide open center console lid fully to rear position.
5. Identify rear guides for console lid.
1653a
REAR GUIDES
FRONT GUIDES
CENTER CONSOLE LID
"Loading the manual" means you need to wait until the file loads and becomes available for online reading. Some manuals are very large, and the time they take to appear depends on your internet speed.
Summary
Bulletin No: 09-033/06 © 2006 Mazda Motor of America, Inc. Last Issued: 7/21/2006 Page 2 of 5 6. Using a flat-tipped screwdriver, slide guides rearward to disengage tabs from sides of cup holder assembly as shown. 7. Repeat for other side. 8. Carefully lift console lid and guides from cup holder ass...
Bulletin No: 09-033/06 © 2006 Mazda Motor of America, Inc. Last Issued: 7/21/2006 Page 3 of 5 9. Remove guides from old console lid. NOTE: • Make note of sides of cup holder assembly guides are removed from for installation. Guides cannot be installed backward or on opposite sides. Attempting to do ...
Bulletin No: 09-033/06 © 2006 Mazda Motor of America, Inc. Last Issued: 7/21/2006 Page 4 of 5 12. Carefully lay lid and guides down to line up remaining tabs. 13. Using a flat-tipped screwdriver, slide guide forward to engage tabs to sides of cup holder assembly. 14. Slide center console lid to full...
