MartinLogan 40 - Manual

MartinLogan 40

MartinLogan 40 – Manual, read for free online in PDF format. We hope this helps you resolve any issues you may have. If you have further questions, please contact us through the contact form.

1 Page 1
2 Page 2
3 Page 3
4 Page 4
5 Page 5
6 Page 6
7 Page 7
8 Page 8
9 Page 9
10 Page 10
11 Page 11
12 Page 12
13 Page 13
14 Page 14
15 Page 15
16 Page 16
17 Page 17
18 Page 18
19 Page 19
20 Page 20
21 Page 21
22 Page 22
23 Page 23
24 Page 24
25 Page 25
26 Page 26
27 Page 27
28 Page 28
Page: / 28

Table of Contents:

  • Page 4 – onneCtion; Turn your amplifier; JUMPER CLIPS
  • Page 5 – SINGLE WIRE CONNECTION; Only after jumper; PASSIVE BI-AMPLIFICATION
  • Page 6 – from the tweeter and woofers); ssembly
  • Page 9 – • Check that all system components are turned
  • Page 11 – PeCiFiCAtions; Ported
  • Page 12 – MARTINLOGAN
  • Page 15 – g u i d e d e l ’ u t i l i s a t e u r
  • Page 18 – l’équipement n’est pas de la plus haute qualité.; PINCES DE DéMARRAGE; É t e i g n e z
  • Page 19 – RACCORD À UN FIL; Seulement; RACCORD À DEUX FILS
  • Page 21 – Bien que vos enceintes soient conçues pour offrir; ontAge
  • Page 22 – ) Couchez délicatement l’enceinte sur le côté.
  • Page 23 – • Vérifiez que toutes les composantes du système
  • Page 25 – PéCiFiCAtions; Antirésonnante; *Les spécifications peuvent changer sans préavis.
Loading the manual

u s e r ’ s m a n u a l

"Loading the manual" means you need to wait until the file loads and becomes available for online reading. Some manuals are very large, and the time they take to appear depends on your internet speed.

Summary

Page 4 - onneCtion; Turn your amplifier; JUMPER CLIPS

4 C onneCtion WARNING! Turn your amplifier off before making or breaking any signal connections! Use the best speaker cables you can. The length and type of speaker cable used in your system will have an audible effect. Under no circumstance should a wire of gauge higher (thinner) than #16 be used. ...

Page 5 - SINGLE WIRE CONNECTION; Only after jumper; PASSIVE BI-AMPLIFICATION

5 SINGLE WIRE CONNECTION Please take note of the jumper clips installed under the binding posts. These clips attach the high-frequency and low-frequency sections of the crossover together. Leaving these in place, connect the (+) wire from your amplifier to either red (+)binding post and the (–) wire...

Page 6 - from the tweeter and woofers); ssembly

6 amplification directly connected to the high- and low-frequency sections of the crossover. There are two different methods for bi-amping with two stereo amplifiers. The first and most common is referred to as Horizontal Bi-amping. The second method is referred to as Vertical Bi-amping. With either...

Other MartinLogan Models

All MartinLogan Other