MartinLogan Voyage - Manual

Page 2 - Contents & Introduction; ONTENTS; Contents

Contents and Introduction . . . . . . . . . . . . . . . . . . .2 Contents Introduction Installation . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .3 Placement Horizontal Installation Installing the Voyage Installing an IR Repeater . . . . . . . . . . . . . . . . . . . .9Removing the End ...

Page 3 - These instructions must be carefully followed to; Placement; NSTALLATION

To achieve maximum performance, it is recommended that the Voyage not be installed near a room corner or directly behind furniture. When used as a front left/right channel, it is recommended that the listening position be no closer to the wall then the distance between the speakers. Horizontal Insta...

Page 5 - Installation 5

1 Using a stud finder, locate the final speaker position between studs. WARNING! Absolutely no part of the template should overlap a stud. 2 Insert top push pin (provided). Level template. Insert bottom pushpin (provided). Recheck level. 3 Mark cutout through slots in template. Remove Template. 4 Us...

Page 9 - IR R; EPEATER; Installing an IR Repeater 9

WARNING! These instructions are written based on commonly available IR repeaters that mount in a 1 / 2 " diameter hole. Before beginning this installation, please refer to the instructions that came with your IR repeater to verify this hole size. If your IR repeater requires a hole size other th...

Page 10 - 0 Removing the End Caps for Painting

10 Removing the End Caps for Painting Required tools (not included): Philips head scrwedriver 1 Prepare a flat surface with a cushion and/or blanket to protect the Voyage. Place the Passage driver side down. WARNING! Be careful to put no weight on the tweeter globe. 2 Using a Phillips head screwdriv...

Page 11 - ATF Operation; DVANCED

ATF Operation The MartinLogan ATF transducer (based on RADIA planar technology) consists of a micro-thin, low-mass Kaladex diaphragm with an ultra-light, etched conductive alumi-num surface suspended between two high field strength neodymium super magnet arrays (see figure 17). When an electrical cu...

Page 12 - 2 Frequently Asked Questions and Troubleshooting; REQUENTLY; How do I clean my speakers?; Frequently Asked Questions

12 Frequently Asked Questions and Troubleshooting F REQUENTLY A SKED Q UESTIONS AND T ROUBLESHOOTING How do I clean my speakers? Just use a dust free cloth or a soft brush to remove the dust from your speakers. We recommend a specialty cloth (available at the Xtatic shop at www.martinlogan.com) that...

Page 13 - 0° tilt in all directions. 90° rotation.; Service; The appointed MartinLogan distributor for any given; ENERAL; Warranty and Registration

System Frequency Response 40–20,000 Hz ± 3 dB Sensitivity 91 dB/2.83 volts/meter (mounted on wall) Impedance 5 ohms Crossover Frequency 350, 3000 Hz Components Air core coils, polypropelene, metal film and low dissipa-tion electrolytic capacitors Woofer Type Two 8” (20.3cm) magnetically shielded hig...

Page 14 - LOSSARY; 4 Glossary of Audio Terms

AC. Abbreviation for alternating current. Active crossover. Uses active devices (transistors, ICs, tubes) and some form of power supply to operate. Amplitude. The extreme range of a signal. Usually mea- sured from the average to the extreme. Arc. The visible sparks generated by an electrical dis- ch...

Page 16 - the loudspeaker technology company

2101 Delaware Street, Lawrence, Kansas 66046, USA tel 785.749.0133 fax 785.749.5320 www.martinlogan.com M A R T I N L O G A N the loudspeaker technology company ©2004 MartinLogan. All rights reserved. Rev. #080604 ®

MartinLogan Voyage - Manual

Table of Contents:

Summary

Other MartinLogan Models