Magnadyne MRC-2U - Manual - manualsarea.com

Page 2 - Index

2 Index Introduction . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 3 Safety Information . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . ...

Page 4 - General Operations; Tuning in a Radio Station Using Seek:

4 Selecting a Source/Mode: To select a play source, press the SRC button until the desired source/mode is selected. Volume: Increase the volume by pressing the VOL+ button. Increase the volume by pressing the VOL- button. Increase Decrease General Operations Mute: Press the button to mute the volume...

Page 5 - Removing the Remote from Holder:; Hole

5 Remote Installation Inserting Strap: Insert strap through the remote holder with tabsfacing outward. Removing the Remote Removing the Remote from Holder: Press the release tab and slide out the remote.To reinstall, slide the remote into the holder untilit snaps into place. Release Tab Connecting S...

Page 6 - Wiring Diagram; Do Not Cut or Connect

6 Wiring Diagram Antenna Wire Do Not Cut or Connect Green LED (Speed-Up) Red LED (Slow-Down) Red Wire +12 Volt Switch Black Wire Ground Infrared Emitter Attach to radio’s infrared receiver. Note: Receiver’s housing is not waterproof and must be mountedin a dry location.

Page 7 - Learning the Radio’s Remote Code; Manufacturer’s Code Look-Up Table

Manufacturer Group Sub-Group Radio 1 Alpine 2 JVC 3 Pioneer 1 MobileVision and MB Quart 2 Kenwood 1 Sony Flashes the Number of Times the Switch is Pressed, Confirming Group Number 7 Step 1 Turn on the power to the receiver’shousing. Press and hold the button on the receiver for 3 seconds. The LED on...

Page 10 - Learning an Additional Aquavibe Marine Remote Controller Code

10 Step 1 Turn on the power to the receiver’shousing. Press and hold the button on the receiver until the LED turnson solid. Step 2 Solid LED Learning an Additional Aquavibe Marine Remote Controller Code Hold While still pressing the button on the receiver, press and release the SRC button on the re...

Page 11 - Clearing All the Aquavibe Marine Remote Controller Codes

Step 1 Turn on the power to the receiver’shousing. Press and hold the button on the receiver until the LED turnson solid then release button. Step 2 Solid LED Clearing All the Aquavibe Marine Remote Controller Codes Hold Push the receiver button 2 more times, holding on the lastpush. The LED will fl...

Page 12 - Warranty; cost are the sole responsibility of the purchaser.; authority to operate the equipment.

© Copyright 2008 Magnadyne Corporation MRC-2U-IM/UM Rev. A 4-28-08 Warranty ONE (1) YEAR LIMITED WARRANTY Magnadyne Corporation or its authorized agents will within one year from the date of sale to you, repair, replace or refund the retail sales price of said product or any part thereof, at the opt...

Magnadyne MRC-2U - Manual

Table of Contents:

Summary

Other Magnadyne Models