Lynx L42ATRF-LP - User Manual

6 | I N S TA L L AT I O N / U S E & C A R E VISIBLE LOSS OR DAMAGE Be certain any visible damage to the carton is noted on freight bill or express receipt and signed by the person mak-ing delivery. FILE CLAIM FOR DAMAGES IMMEDIATELY, regardless of extent of damage. CONCEALED LOSS OR DAMAGE If da...

I N S TA L L AT I O N / U S E & C A R E | 7 BUILT-IN INSTALLATIONS This built-in grill is designed for easy installation into ma-sonry enclosures. NOTE: Built-in grills are intended either for installation in a built-in enclosure constructed of non-combustible materials or for an installation in...

8 | I N S TA L L AT I O N / U S E & C A R E The guides, measurements and dimensions detailed below are designated to assist you with planning your outdoor kitchen. NOTE: Due to continuing product innovation, specifi cations are subject to change without notice. SPECIFICATIONS & INSTALLATION 3...

I N S TA L L AT I O N / U S E & C A R E | 9 WITH INSULATED JACKET INSTALLED MODEL A B C LIJ30 36.00 11.63 26.5 LIJ36 42.00 11.63 23.75 LIJ42 48.00 11.63 26.5 Installation into a combustible enclosure requires aninsulated jacket accessory. Not installing an insulatedjacket could result in a fi re,...

10 | I N S TA L L AT I O N / U S E & C A R E MAXIMUM RUNS FOR ALL APPLIANCES ON SUPPLY LINE Run Length 3/4” Pipe (in feet) Max BTU for all Appliances on line 10 360,000 20 245,000 30 198,000 40 169,000 50 150,000 60 135,000 70 123,000 80 115,000 MODEL-SPECIFIC BTU OUTPUTS & MAX. RUNS FOR APP...

I N S TA L L AT I O N / U S E & C A R E | 11 DIMENSIONS 30" 11" 9" REARMANIFOLDLOCATION 2 1 / 2 " 2 1 / 2 " 25 3 / 8 " 27 7 / 8 " 1 3 / 4 " 21 1 / 2 " 10 1 / 2 " 14 1 / 2 " 25 3 / 16 " 11" 3" 30" 32" 36" 35 1 / 2 " 36 1 / 2 ...

14 | I N S TA L L AT I O N / U S E & C A R E The grill arrives nearly ready to use and requires only minor assembly. By carefully following the uncrating and unpacking steps, you will improve your fi rst experience with the grill. Shipping weight on smaller units is app. 300 pounds and larger uni...

I N S TA L L AT I O N / U S E & C A R E | 15 Inside View, Orifi ce all the way into venturi UNPACKING & ASSEMBLY ... continued Heat Shield Removed, Orifi ce/Venturi Position • Ensure that all burners are properly seated on the burner valve orifi ce and sitting level with the legs in the frame s...

16 | I N S TA L L AT I O N / U S E & C A R E WARNING NEVER CONNECT A GAS LINE DIRECTLY TO THE GRILL. A PRESSURE REGULATOR MUST BE INSTALLED ON ALL GAS EQUIPMENT. ALL LOCAL CODES REQUIRE THAT THE PRESSURE REGULATOR SUPPLIED WITH YOUR GRILL IS USED. REMOVING OR FAILING TO INSTALL THE PRESSURE REGU...

I N S TA L L AT I O N / U S E & C A R E | 17 For freestanding units using natural gas, using a metal fl ex hose is recommended. This is available at your local hardware store or from yourdealer. LP GAS Grills set up for LP gas come equipped with an LP hose/ regulator assembly for connection to a ...

18 | I N S TA L L AT I O N / U S E & C A R E GAS CONNECTIONS ... continued Insert the regulator inlet into the cylinder valve and turn the black coupler clockwise until the coupler is hand tight. Do not over-tighten this connection. To disconnect the coupler, fi rst make sure the main cylinder va...

I N S TA L L AT I O N / U S E & C A R E | 19 NG AND BULK PROPANE CART INSTALLATION • Shut off the gas supply at the main valve. • Disconnect all plumbing (if already attached) from the grill and the gas supply valve. • Remove all the fi ttings from the grill manifold. • Install the side burner in...

20 | I N S TA L L AT I O N / U S E & C A R E Installation requires an outdoor 120VAC 15A GFI (Ground Fault Interrupter) electrical outlet adjacent to the grill. The GFI outlet features an internal breaker that reduces shock hazard. This type of outlet should be installed by a qualifi ed electrici...

I N S TA L L AT I O N / U S E & C A R E | 21 FINAL CHECKS LEAK TESTING Leak Test Procedure: • Create a soapy solution of 1 part soap and 3 parts water. • Confi rm that all control knobs are in the off position. • Turn on the fuel supply. For natural gas, turn the valve handle 1/4 turn to align wi...

22 | I N S TA L L AT I O N / U S E & C A R E FINAL CHECKS ... continued BURNER FLAME ADJUSTMENT The appearance of the Trident™ burner should be visu-ally checked. The ceramic tiles should be uniformly red to orange in appearance. There should be no lifting, fl uttering or lazy blue fl ames. Some f...

I N S TA L L AT I O N / U S E & C A R E | 23 CHECKLIST BEFORE EACH USE (FOR YOUR SAFETY) • Do you smell gas? If yes, shut off everything and call the gas company or a qualifi ed plumber to check for leaks, if not please continue. • Are you prepared to stay with the grill during the entire cooking...

24 | I N S TA L L AT I O N / U S E & C A R E 1. NEVER LEAVE THE GRILL UNATTENDED WHILE COOKING. 2. Ensure all tie-down wires have been removed from the burners. 3. Always use caution when operating the grill in a windy area. (See INDEX: “Grilling in Windy Conditions” for further details.) 4. Avo...

I N S TA L L AT I O N / U S E & C A R E | 25 Outdoor grills create more heat than interior kitchen ranges. That’s how they sear and grill steaks and other foods. These high-performance burners require a constant, steady supply of fresh air to mix with the fuel. Your grill pulls air in through th...

26 | I N S TA L L AT I O N / U S E & C A R E BEFORE YOUR FIRST USE There are a few must-check safety precautions to consider before you use your grill. Please be sure that: • All packing materials and tie-downs have been removed from the burners. (See INDEX: “Unpacking & Assembly” for furthe...

I N S TA L L AT I O N / U S E & C A R E | 27 ELECTRIC IGNITION Before proceeding, make sure you have completed the “Before Each Use” checklist. Follow these steps to light any of the burners on your grill: First, make sure all burner control knobs are set to OFF. For the Trident™ Burner: Push an...

28 | I N S TA L L AT I O N / U S E & C A R E PRE-HEATING Pre-heating your grill every time you use it is extremely im-portant. Pre-heating allows the briquettes to properly heat up, providing more even and more consistent cooking results. Pre-heat your grill by igniting all burners and setting t...

I N S TA L L AT I O N / U S E & C A R E | 29 HOW TO SEAR Searing locks in fl avor and juices while allowing the food’s outer surface to absorb smoke and food-born aromas produced when drippings are vaporized by the burner. The result is a restaurant-style fi nish … crisp, fl avorful outside with a ...

30 | I N S TA L L AT I O N / U S E & C A R E Then mount the skewer on the grill before lighting the rotis-serie infrared burner. Lighting the burner fi rst could result in burning your hands while trying to mount the skewer on the grill. It’s okay to remove the grill racks and even the briquette ...

I N S TA L L AT I O N / U S E & C A R E | 31 STAINLESS STEEL Our products are known for their attractive appearance. We achieve this by selecting only the fi nest grades of stainless steel and applying exacting workmanship. In order to maintain this attractive appearance over the life of the gril...

32 | I N S TA L L AT I O N / U S E & C A R E PROPER PLACEMENT OF EACH BURNER IS CRITI-CAL. AFTER CLEANING THEY MUST BE CENTERED ON THE BRASS ORIFICE, RESTING LEVEL WITHOUT ANY ROCKING. FAILURE TO MEET THESE CONDITIONS MAY CAUSE A VERY DANGEROUS CONDITION THAT CAN CAUSE PERSONAL INJURY AND PROPER...

I N S TA L L AT I O N / U S E & C A R E | 33 GRILL WON’T LIGHT First, confi rm that the grill is getting electricity by turning on the lights, then: Check The Igniters Your grill uses an electric ignition system that does not spark. Instead, the igniters should glow constantly when a control knob...

| I N S TA L L AT I O N / U S E & C A R E • Check the Regulator Make sure that the regulator & hose assembly is the one designed for and supplied with your grill and that it is correctly set up for the type of fuel you are using. The hose and regulator provided must be used if your grill is ...

I N S TA L L AT I O N / U S E & C A R E | 35 35 | I N S TA L L AT I O N / U S E & C A R E POTENTIAL PROBLEMS ... continued Pull on spring tabs to release light cover ROTISSERIE LIGHTS BUT GOES OUT AS SOON AS CONTROL IS RELEASED • Check Thermocouple The control knob must be held in for 30 to ...

36 | I N S TA L L AT I O N / U S E & C A R E CONTACTING CUSTOMER SERVICE If service is required, call your authorized service agency. Have the following information readily available.• Model number • Serial number • Date purchased • Name of dealer from whom purchased Clearly describe the problem...

I N S TA L L AT I O N / U S E & C A R E | 37 LYNX LIMITED WARRANTY I. Limited Lifetime Warranty The stainless steel grill body, ceramic grill burners, cooking grates,Trident TM burner and rotisserie infrared burner are warranted to be free from defects in material and workmanship when subjected ...

38 | I N S TA L L AT I O N / U S E & C A R E LYNX COMMON AREA LIMITED WARRANTY The Lynx Limited Warranty covers residentialinstallations only and is non-transferable to any other party. This warranty applies when the product is installed in common areas where more than a single party has rightfu...

Lynx Grills 62201 Hwy 82 West Greenwood, Mississippi 38930 USA 888-289-5969 www.lynxgrills.com 33526 Rev F (083021)