Lynx L30AG-LP - Manuals

Use&Care / Installation | 5 TABLE OF CONTENTS WARNINGS 4 USE&CARE GUIDELINES 6 BEFORE YOU START 7 IF SHIPMENT ARRIVES DAMAGED 7 IMPORTANT NOTES 7 BUILT-IN INSTALLATION 7 CLEARANCE TO COMBUSTIBLE MATERIALS 8 CUTOUT SPECIFICATIONS 9 UNPACKING & ASSEMBLY 10 GAS CONNECTIONS 11 Natural Gas 11...

Use&Care / Installation | 7 BEFORE YOU START WARNING • Never install this product into a combustible enclosure without an insulated jacket. Doing so could result in fi re, property damage and personal injury. • Never locate the grill under an uprotected roof or overhang, in a building, garage, sh...

8 | Use&Care / Installation BEFORE YOU START con’t CLEARANCE TO COMBUSTIBLE MATERIALS Minimum clearance from the sides and back of the grill to adjacent combustible construction below the counter top surface is 12” from the sides and back. Degagement minimal entre /es parois /aterales et l’arrie...

Use&Care / Installation | 9 CUTOUT SPECIFICATIONS W (Width) H (Height) D (Depth) 29.0 10.88 24.5 2-1/2” minimum clearance

10 | Use&Care / Installation UNPACKING & ASSEMBLY The grill arrives nearly ready to use and requires only minor assembly. By carefully following the uncrating and unpacking steps, you will improve the customer’s fi rst Lynx experience. Shipping weight on smaller units is app. 300 pounds and l...

Use&Care / Installation | 11 GAS CONNECTIONS WARNING NEVER CONNECT A GAS LINE DIRECTLY TO THE GRILL. A PRESSURE REGULATOR MUST BE INSTALLED ON ALL GAS EQUIPMENT. ALL LOCAL CODES REQUIRE IT AND LYNX SUPPLIES THE CORRECT REGULATOR WITH YOUR GRILL. REMOVING OR FAILING TO INSTALL THE PRESSURE REGULA...

12 | Use&Care / Installation GAS CONNECTIONS con’t For freestanding units using natural gas, Lynx recommends using a mobile fl ex gas line. Always keep the line away from the fi rebox. This is available at your local hardware store or from your dealer. LP GAS Grills set up for LP gas come equipped...

Use&Care / Installation | 13 GAS CONNECTIONS con’t Insert the regulator inlet into the cylinder valve and turn the black coupler clockwise until the coupler is hand tight. Do not over-tighten this connection. To disconnect the coupler, fi rst make sure the main cylinder valve is turned off . Gras...

14 | Use&Care / Installation GAS CONNECTIONS con’t NG AND BULK LP* CART INSTALLATION • Shutoff the gas supply at the main valve.• Disconnect all plumbing (if already attached) from the grill and the gas supply valve. • Remove all the fi ttings from the grill manifold if necessary. • Connect the g...

Use&Care / Installation | 15 ELECTRICAL CONNECTIONS WARNING: ELECTRICAL GROOUNDING • Product installation must meet local electric codes or, in the absence of local codes, the latest edition of the National Electrical Code ANSI/NFPA No. 70 or the Canadian Electrical Code CGA 1.662005. • Use only...

16 | Use&Care / Installation FINAL CHECKS DANGER To prevent fi re or explosion hazard, DO NOT smoke or allow any potential source of ignition (sparks, electrical arcing, etc) in the area while performing a leak test. Leak tests should be conducted outdoors only. Never conduct a leak test using fi ...

Use&Care / Installation | 17 SAFETY CHECKLIST • Do you smell gas? If yes, shut off everything and call the gas company or a qualifi ed plumber to check for leaks, if not please continue. • Are you prepared to stay with the grill during the entire cooking process? If not, gather what you need befo...

18 | Use&Care / Installation PRE-GRILL CHECKLIST LIGHTING YOUR GRILL COLD WEATHER WARNING: PROPANE Extremely cold temperatures may cause your Trident TM burners to light inside the burnersinstead of outside. Once lit, if you hear a ‘whooshing’ sound, immediately turn the burner knobs off to exti...

Use&Care / Installation | 19 IMPORTANT SAFETY PRECAUTIONS 1. NEVER LEAVE THE GRILL UNATTENDED WHILE COOKING 2. Ensure all zip ties have been removed from the burners. 3. Avoid wearing loose-fi tting garments or long sleeves while grilling. They could ignite. 4. Never touch the grill surface or im...

20 | Use&Care / Installation BASIC GRILLING PRE-HEATING COOKING ON THE GRIDDLE PLATE SETTINGS Pre-heating your grill every time you use it is extremely important. Pre-heating allows the griddle to properly heat up, providing more even and more consistent cooking results.Pre-heat your grill by ig...

Use&Care / Installation | 21 CLEANING YOUR GRILL (Including Required Maintenance) STAINLESS STEEL Lynx products are known for their attractive appearance. We achieve this by selecting only the fi nest grades of stainless steel and applying exacting workmanship. In order to maintain this attractiv...

22 | Use&Care / Installation CLEANING YOUR GRILL (Including Required Maintenance) TROUBLESHOOTING YOUR LYNX GRILL WARNING 1. Failure to perform required maintenance will void your warranty. 2. Scrape the griddle plate and discard the residue.3. Clean out the burner orifi ces and ensure they are f...

Use&Care / Installation | 23 POTENTIAL PROBLEMS con’t GLOW OR INSUFFICIENT HEAT Ensure that you've preheated the Trident TM burner for at least 10-15 minutes. Proper leveling during installation is critical. A grill that is out of level will cause erratic burner combustion and ineffi cient, unev...

24 | Use&Care / Installation CONTACTING CUSTOMER CARE Before calling Lynx Customer Care, please make sure you have the following information: • Model number • Date of purchase • Proof of purchase by the original owner • Serial number The serial number can be located on the rating plate which is ...

Use&Care / Installation | 25 LYNX LIMITED WARRANTY I. Limited Lifetime Warranty The stainless steel grill body, and Trident TM burnersare warranted to be free from defects in material andworkmanship when subjected to normal domestic useand maintenance for the lifetime of the original purchaser.T...

26 | Use&Care / Installation LYNX COMMON AREA LIMITED WARRANTY The Lynx Limited Warranty covers residentialinstallations only and is non-transferable to any other party. This 'non-residential' warranty applies when the product is installed in common areas where more than a single party has right...