Life fitness 9500HR - Manual
Life fitness 9500HR – Manual, read for free online in PDF format. We hope this helps you resolve any issues you may have. If you have further questions, please contact us through the contact form.
Table of Contents:
- Page 2 – Life Fitness Model 9500HR Treadmills; STEPS 13-16 cover LIFT ACTUATOR REMOVAL; Bolt
- Page 3 – STEPS 25 and 26 cover DECK and STRIDING BELT installation
- Page 4 – STEPS 31-33 cover BELT TENSIONING on NEW belts.
Life Fitness Model 9500HR Treadmills
How to…Install the Support Plate on Damaged Frame Cross-Member/Bracket
Tools required:
Hex Key Wrench Set, Socket Set, C-Clamps, Phillips Screwdriver
NOTE:
STEPS 1-12 cover Belt, Deck, and Wax Bag Removal.
1. Turn the unit power OFF, then unplug the POWER CORD at the electrical outlet.
2. Remove the front and rear FRAME CAPS on the right side of the unit.
3. Remove the right HANDRAIL FOOT COVER.
4. Remove the mounting bolts
securing right HANDRAIL to
the frame.
5. Before loosening the
STRIDING BELT,
mark the location of the
BELT TENSIONING BOLTS
or record the number of turns
for proper belt re-tensioning.
6. Loosen the STRIDING
BELT by turning the BELT
TENSIONING BOLTS
counterclockwise.
7. Carefully tilt the unit on its left side (user's left) and
remove the rear ROLLER GUARD.
8. Cover the end of the stationary
leg to protect the striding belt
during removal.
9. Remove the striding belt.
10. Carefully tilt the unit back to its
upright, normal operating position.
11. Remove the DECK SCREWS and
DECK.
12. Pinch-off the wax hose and
remove the WAX COVER, BAG,
and TRAY.
Mounting Bolts (4)
Frame
Washer (4)
Wax Bag
Tray
Cover
"Loading the manual" means you need to wait until the file loads and becomes available for online reading. Some manuals are very large, and the time they take to appear depends on your internet speed.
Summary
Life Fitness Model 9500HR Treadmills How to…Install the Support Plate on Damaged Frame Cross-Member/Bracket NOTE: STEPS 13-16 cover LIFT ACTUATOR REMOVAL and ASSESSEMENT OF DAMAGE to THE FRAMECROSS-MEMBER. 13. Unplug the LIFT ACTUATOR from the WIRE HARNESS. 14. Remove the upper nut, bolt, and washer...
Life Fitness Model 9500HR Treadmills How to…Install the Support Plate on Damaged Frame Cross-Member/Bracket NOTE: STEPS 21-24 cover how to adjust the lift actuator screw if moved or if incline error message is displayed. 21. Test the unit. If an incline error occurs then proceed to adjust the actuat...
Life Fitness Model 9500HR Treadmills How to…Install the Support Plate on Damaged Frame Cross-Member/Bracket NOTE: STEPS 31-33 cover BELT TENSIONING on NEW belts. 31. Prior to belt tensioning, place two pieces of tape 50” apart on the left and on the right edges of the striding belt as illustrated. 3...
