Page 2 - On Safety; Do not Open the Display.; Important Precautions
A1 This unit has been engineered and manufactured to ensure your personalsafety, however improper use may result in potential electrical shock or firehazards. In order to allow the proper operation of all safeguardsincorporated in this display, observe the following basic rules for itsinstallation, ...
Page 3 - On Installation; screen because over-spraying may cause electrical shock.; On Repacking; your local authority.
A2 Important Precautions On Installation Do not allow anything to rest upon or roll over the power cord, and do not place thedisplay where the power cord is subject to damage. Do not use this display near water such as near a bathtub, washbowl, kitchen sink,laundry tub, in a wet basement, or near a ...
Page 4 - Connecting the Display; Important; Connecting the stand; Place the monitor with its front facing downward on a soft cloth.
Stand Body Stand Base Stand Base A3 Connecting the Display Important This illustration depicts the general model of connection. Your monitor may differ fromthe items shown in the picture.Do not carry the product upside down holding only the stand base. The product mayfall and get damaged or injure y...
Page 5 - Disassembling the stand; Put a cushion or soft cloth on a flat surface.; Your monitor may differ from the items shown in the picture.
A4 Connecting the Display Disassembling the stand 1. Put a cushion or soft cloth on a flat surface. 2. Place the monitor face down on the cushion or soft cloth. 4. Loosen the screw, then take off the stand base from stand body. 5. Please pull the stand body lightly to separate it from the hinge body...
Page 6 - Positioning your display; Ergonomic
A5 Connecting the Display Before setting up the monitor, ensure that the power to the monitor, the computersystem, and other attached devices is turned off. Positioning your display 1. Adjust the position of the panel in various ways for maximum comfort. Tilt Range: -5˚~20˚ Ergonomic It is recommend...
Page 7 - Using the Computer
A6 Using the Computer 1. Make sure to turn off the computer and product. Connect the cable as below sketch mapform to . 1 3. Press button on the front switch panel to turn the power on.When monitor power is turned on, the 'Self Image Setting Function' is executed automatically. (Only RGB Mode) NOTE ...
Page 9 - Control Panel Functions; Use this button to enter or exit from the On Screen Display.; Front Panel Controls
A8 Control Function Control Panel Functions MENU Button Use this button to enter or exit from the On Screen Display. FUN Button Use this button to enter EZ ZOOMING , 4:3 IN WIDE , PHOTO EFFECT , SOUND items, for more information, refer to page A17-A18. Use this button to enter On Screen Display Sub-...
Page 10 - Use this button to turn the display on or off.
A9 Control Panel Functions This Indicator lights up as blue when the display isoperating normally(On Mode). If the display is inSleep Mode (Energy Saving), this indicator colorchanges to amber. Use this button to turn the display on or off. Power Button Power Indicator Use this button to select an i...
Page 11 - On Screen Display (OSD) Control Adjustment; Screen Adjustment; MENU Button
A10 On Screen Display (OSD) Control Adjustment Screen Adjustment Making adjustments to the image size, position and operating parameters ofthe display is quick and easy with the On Screen Display Control system. A short example is given below to familiarize you with the use of the controls.The follo...
Page 12 - On Screen Display(OSD) Selection and Adjustment
A11 NOTE The order of icons may differ depending on the model (A11~A20 ). On Screen Display(OSD) Selection and Adjustment The following table indicates all the On Screen Display control, adjustment,and setting menus. ● : Adjustable R : RGB Input * : only for RGB/DVI Input D : DVI Input ** : only for...
Page 13 - Press the MENU Button, then the main menu of the OSD appears.
A12 Sub-menus On Screen Display(OSD) Selection and Adjustment NOTE OSD (On Screen Display) menu languages on the monitor may differ from the manual. You were introduced to the procedure of selecting and adjusting an itemusing the OSD system. Listed below are the icons, icon names, and icondescriptio...
Page 14 - Main menu
A13 On Screen Display(OSD) Selection and Adjustment Main menu Sub menu Description BRIGHTNESS CONTRAST GAMMA BLACK LEVEL To adjust the brightness of the screen. To adjust the contrast of the screen. Set your own gamma value. : -50/0/50On the monitor, high gamma valuesdisplay whitish images and low g...
Page 15 - To move image left and right.
A14 On Screen Display(OSD) Selection and Adjustment Main menu Sub menu Description CLOCK PHASE SHARPNESS To minimize any vertical bars orstripes visible on the screenbackground.The horizontal screen size will alsochange. To adjust the focus of the display. This item allows you to removeany horizonta...
Page 17 - PIP; PIP Position
A16 On Screen Display(OSD) Selection and Adjustment Main menu Sub menu Description PIP To select PIP on or off.*It only supports D-Sub & HDMIcombination input signal. To select PIP Window position:• Top left• Bottom left• Bottom right• Top right*It operates only when PIP is on. PIP On/Off PIP Po...
Page 18 - EZ ZOOMING; The OSD screen will appear when you touch the; FUN; button on the left bottom of the
A17 A17 On Screen Display(OSD) Selection and Adjustment Main menu Sub menu Description EZ ZOOMING The OSD screen will appear when you touch the FUN button on the left bottom of the monitor. EZ Zoom lowers the display’s resolution insingle-step increments. Depressing the buttononce lowers the resolut...
Page 19 - PHOTO EFFECT
A18 On Screen Display(OSD) Selection and Adjustment Main menu Sub menu Description PHOTO EFFECT - NORMAL: The PhotoEffect function is disabled. - GAUSSIAN BLUR: This option is to add the effect to the screenthat the dark and sharp image becomesbrighter and more blurred. - SEPIA: This option changes ...
Page 20 - This is for animation images in videos or movies.
A19 On Screen Display(OSD) Selection and Adjustment Icons Menu Name Sub-menu Name Main menu Sub menu Description INTERNET DEMO MOVIE INTERNET GAME NORMAL STANDARD DEMO SPORTS The OSD screen will appear when you touch the button on the left bottom ofthe monitor. This is for animation images in videos...
Page 21 - Select the sub-menu using the
A20 On Screen Display(OSD) Selection and Adjustment Main menu Sub menu Description USER Select the sub-menu using the AUTO/SET button and save the YES value using the , buttons . ...HUE: Adjust the screen hue. ...SATURATION: Adjust the screen saturation. You can manually adjust brightness, ACE or RC...
Page 22 - Troubleshooting; Check the following before calling for service.; No image appears
A21 Troubleshooting No image appears Check the following before calling for service. No image appears Do you see a "OSD LOCKED" message on the screen? ● Is the power cord of the display connected? ● Is the power indicator light on? ● Is the power on and the power indicator blue orgreen? ● Is...
Page 23 - Display image is incorrect
A22 A22 Troubleshooting Display image is incorrect ● Display Position is incorrect. ● On the screen background, verticalbars or stripes arevisible. ● Any horizontal noise appearing in anyimage or charactersare not clearlyportrayed. • Press the AUTO/SET button to automatically adjust your display ima...
Page 24 - Have you installed the display driver?; Have you installed the; The screen color is
A23 A23 Troubleshooting Have you installed the display driver? ● Have you installed the display driver? ● Do you see an "Unrecognized monitor,Plug&Play (VESA DDC)monitor found"message? • Be sure to install the display driver from the display driver CD (or diskette) that comes with yourdi...
Page 25 - Specifications; Information in this document is subject to change without notice.
A24 A24 A24 Specifications NOTE Information in this document is subject to change without notice. Display Sync Input Video Input Resolution Plug&Play PowerConsumption Dimensions &Weight Tilt Range Swivel Range Power Input Environmental Conditions Stand Base Signal cable Power cord 24 inches ...
Page 26 - Indicator; LED Color
A25 Specifications Indicator On Mode Sleep Mode Off Mode blue amber Off LED Color MODE Preset Modes (Resolution) Display Modes (Resolution) Horizontal Freq. (kHz) Vertical Freq. (Hz) 123456789 10111213141516 *17 640 x 480640 x 480720 x 480720 x 400800 x 600800 x 600 1024 x 7681024 x 7681152 x 864128...
Page 27 - Digitally yours
