LG LDG3036ST - Manual - manualsarea.com

Page 2 - I N S TA L L AT I O N I N S T R U C T I O N S; INSTALLATION SAFETY INSTRUCTIONS; BEFORE YOU BEGIN; Read these instructions completely; • IMPORTANT

2 I N S TA L L AT I O N I N S T R U C T I O N S INSTALLATION SAFETY INSTRUCTIONS READ ALL INSTRUCTIONS BEFORE INSTALLATION BEFORE YOU BEGIN Read these instructions completely and carefully. Installation of this range must conform with local codes, or in the absence of local codes, with the National ...

Page 3 - ENGLISH; WARNING; CAUTION; READ ALL INSTRUCTIONS BEFORE INSTALLATION; WHAT TO DO IF YOU SMELL GAS

3 ENGLISH I N S TA L L AT I O N I N S T R U C T I O N S BEFORE YOU BEGIN Remove all tape and packing materials before using the range. Dispose of all plastic bags after unpacking the range. Never allow children to play with packing materials. IMPORTANT SAFETY INSTRUCTIONS Read these instructions com...

Page 5 - TOOLS YOU WILL NEED; PREPARING FOR INSTALLATION

5 ENGLISH I N S TA L L AT I O N I N S T R U C T I O N S READ ALL INSTRUCTIONS BEFORE INSTALLATION TOOLS YOU WILL NEED MATERIALS YOU MAY NEED • Gas line shut-off valve• Pipe joint sealant that resists action of natural and LP gases.• Flexible metal appliance connector (3/4” or 1/2” NPT x 1/2” I.D.) N...

Page 6 - DIMENSIONS AND CLEARANCES; DIMENSIONS

6 I N S TA L L AT I O N I N S T R U C T I O N S Provide proper clearances between the range and adjacent combustible surfaces. These dimensions must be met for safe use of your range. The location of the electrical outlet and pipe opening (see “GAS PIPE AND ELECTRICAL OUTLET LOCATIONS”) may be adjus...

Page 7 - LOCATION

7 ENGLISH I N S TA L L AT I O N I N S T R U C T I O N S Do not locate your range where it may be subject to strong drafts. Any openings in the floor or wall behind the range should be sealed. Make sure the openings around the base of the range that supply fresh air for combustion and ventilation are...

Page 8 - GAS PIPE AND ELECTRICAL OUTLET LOCATIONS; PROVIDE ADEQUATE GAS SUPPLY

8 I N S TA L L AT I O N I N S T R U C T I O N S GAS PIPE AND ELECTRICAL OUTLET LOCATIONS Your range is designed to operate at a pressure of 5” of water column on natural gas or 10” of water column on LP. Make sure you are supplying your range with the type of gas for which it is configured.This rang...

Page 9 - FLEXIBLE CONNECTOR HOOKUP; CONNECT THE RANGE TO GAS

9 ENGLISH I N S TA L L AT I O N I N S T R U C T I O N S FLEXIBLE CONNECTOR HOOKUP Pressure regulator Installer: Inform the consumer of the location of the gas shut-off valve Adapter Adapter Gas shut-off valve 1/2” or 3/4” Gas pipe Flex connector (6 ft. max.) Gas Flow into Range Shut off the range ga...

Page 10 - GROUNDING; ELECTRICAL CONNECTIONS; PREFERRED

10 I N S TA L L AT I O N I N S T R U C T I O N S GROUNDING IMPORTANT: FOR PERSONAL SAFETY, THIS APPLIANCE MUST BE PROPERLY GROUNDED. ELECTRICAL REQUIREMENTS 120 Volt, 60 Hertz, properly grounded dedicated circuit protected by a 15 or 20 Amp circuit breaker, or slow blow fuse. 3. ELECTRICAL CONNECTIO...

Page 11 - ASSEMBLE THE SURFACE BURNERS; ELECTRIC IGNITION; CHECK IGNITION OF SURFACE BURNERS

11 ENGLISH I N S TA L L AT I O N I N S T R U C T I O N S CAUTION Place the burner caps and heads on the cooktop. Make sure that the caps and heads are placed in the correct locations. There is one small, one medium, one large and one extra large burner head and cap. Make sure the hole in the burner ...

Page 12 - ADJUST THE SURFACE BURNER TO THE LOW

12 I N S TA L L AT I O N I N S T R U C T I O N S 1) Light all surface burners.2) Turn the knob on the burner being adjusted to “ LO ”. 3) Remove knob.4) Insert a small, flat bladed screwdriver into the valve shaft as shown in Fig. 1. On right front valve for model LDG3019ST there is a secondary adju...

Page 13 - AIR SHUTTER ADJUSTMENT FOR BAKE AND BROIL

13 ENGLISH I N S TA L L AT I O N I N S T R U C T I O N S To check ignition of the Bake burner, follow the steps below: 1) Remove all packing from inside the oven cavity. 2) Press "Bake" (350 will be shown in the display). 3) Press Start. It may take between 30 and 90 seconds for the burner t...

Page 14 - LEVELING THE RANGE; INSTALL THE BRACKET USING THE BRACKET

14 I N S TA L L AT I O N I N S T R U C T I O N S Install the oven shelves in the oven and locate the range where it will be installed.Check if the range is level by placing a spirit level or a cup, partially filled with water, on one of the oven shelves. If using a spirit level, take two readings— w...

Page 15 - WHEN ALL HOOKUPS ARE COMPLETE; CONVERTING TO LP GAS; (OR CONVERTING BACK TO NATURAL GAS FROM LP)

15 ENGLISH I N S TA L L AT I O N I N S T R U C T I O N S Make sure all controls are left in the off position. Make sure the flow of combustion and ventilation air to the range is unblocked. WHEN ALL HOOKUPS ARE COMPLETE This range leaves the factory set for use with natural gas. The conversion to LP...

Page 16 - M e m o

LG LDG3036ST - Manual

Table of Contents:

Other Manuals for LG LDG3036ST

Summary

Other LG Ranges Models