Page 4 - Headset
2 English 1. Overview Headset [1] Visual indicator [2] Answer/End button[3] Volume up/down[4] Ear hook[5] Mute button[6] Microphone[7] Reset button[8] Snap-on cover (replaceable) Base unit [9] Charge cradle[10] Visual indicator[11] Clear dial tone switch[12] AUX port[13] Telephone port[14] Handset p...
Page 5 - Fitting to ear
3 English 2. Fitting the he adset Fitting to ear 2.1 Open hinged ear hook as wide as possible. 1) 2.2 Hold headset to the ear so speaker fits comfortably and microphone points towards the mouth. 2.3 Close hinged ear hook over the ear. 2.4 Adjust ear hook for a comfortable fit. Fitting to left ear 2....
Page 6 - English; Unplug handset cord from; Setting up your de sk phone
4 English If your telephone has a headset port, go directly to 3.2b. 3.1 Unplug handset cord from your telephone and connect to the port on base unit marked with . 3.2a Connect enclosed telephone cord to the now empty handset port on telephone, and to the port on base unit marked with . 3.2b (Headse...
Page 7 - charge for a minimum; Clear dial tone
5 English 4.1 4.5 4.6 4.7 4.8 4.2 4.3 4.4 3.4 Place headset in charge cradle and charge for a minimum of 30 min. before use. A full charge takes about 2 hours. Visual indicator on headset will flash green while headset is charging, and light steady green when fully charged. The same procedure is to ...
Page 8 - Setting transmit volume
6 English Setting transmit volume 3.10 Make a call (see section 4) to someone who can act as a test person. 3.11 Adjust outgoing volume with transmit volume control on base unit. Switch through the 3 settings until test person confirms the appropriate volume. 1) Setting incoming volume 3.12 During a...
Page 9 - Setup; Pairing your headset with your mobile phone; Make sure the headset is off.
7 English 4. Setting up your mobile phone Setup Pairing your headset with your mobile phone NOTE: Before use, please charge your headset (see 3.4). Before using your Jabra M5390 Multiuse headset with a mobile phone, you need to pair it with your mobile phone. • Make sure the headset is off. • During...
Page 10 - Lift handset from telephone,; M aking a call from your de sk phone
8 English 5.1 5.2 5.3 5.4 5.1 5.2 5.3 5.4 5.1 5.2 5.3 5.4 5.1 5.2 5.3 5.4 5.5 5.6 5.5 5.6 5.1 Put on headset. 1) 5.2 Lift handset from telephone, or press telephone´s “line” button if connected to the headset port. Then tap Answer/End button to transfer the call to headset. 5.3 Wait for dial tone, t...
Page 11 - Answering a call from your de sk phone; During a call using telephone
9 English 6.1 Put on headset. 1) 6.2 Lift handset from telephone, or press telephone’s “line” button if connected to the headset port. Then tap Answer/End button to transfer the call to headset. 6.3 To end call, tap the Answer/ End button on the headset and replace handset on telephone, or press tel...
Page 12 - if the headset is placed in the base, simply remove it from the base.; During a call using the headset,
10 English 7. M aking and answering a call from your mobile phone Making and ending a mobile phone call • When you make a call from your mobile phone, the call will transfer to your headset automatically (this is subject to phone settings, see your mobile phone’s User Manual to find out how to activ...
Page 14 - Staying within range; Move back into range to; Fe ature s; Press Mute button on
12 English 6.1 6.2 6.3 6.4 6.5 Staying within range The sound in your headset will deteriorate if you move beyond range. 1) Move back into range to restore sound quality. If you move too far from your mobile phone, the call might be ended or re-routed to your mobile phone from the headset, depending...
Page 15 - Low battery
13 English 7.1 7.2 7.3 7.4 7.5 10 min 7.1 7.2 7.3 7.4 7.5 10 min 2) Important: If headset is out of range for more than 1 min., the link between base and headset will be terminated. Low battery 8.3 Approx. 10 minutes before the headset runs out of battery, the visual indicator on headset will start ...
Page 16 - Headset switch
14 English Headset switch 8.5 If the headset is absent, the headset switch must be activated in order to use the handset or, if the headset is in use with another Bluetooth ® device, the headset switch must be activated in order to use the handset. 7.1 7.2 7.3 7.4 7.5 10 min 8.5 Features: Range 70 m...
Page 17 - Then press reset button on
15 English 8.1 8.2 8.3 8.1 8.2 8.3 8.1 8.2 8.3 9.1 9.2 9.3 9. Re set/Pairing 9.1 Under start-up, keep pressing the Answer/End button for three seconds. Alternatively, remove the snap-on cover and press the reset button on the headset for three seconds.Visual indicator on headset will light constant ...
Page 18 - -enabled mobile phones connected to the Jabra M5390 Multiuse; Op erating device s in multiuse scenarios
16 English 10. Using the Jabra M5390 Multiuse headset with multiple Bluetooth ® -enabled devices Your Jabra M5390 Multiuse headset can be paired with up to 8 devices. However, only two can be connected (paired with the headset, turned on and in range) with the headset at one time. This could be any ...
Page 19 - function will work with the last device that was paired.
17 English 12. Switching between base and Jabra A335w Dongle in a multiuse scenario A typical multiuse scenario is to have the headset connected to one mobile phone and either the base or the dongle. If wanting to switch between base and dongle, while maintaining the mobile phone connection, just pr...
Page 20 - Maintenance; The “colour” indicator light will be on while charging; Battery information; M aintenance; Can I use wideband with a mobile phone or a desk phone?
18 English Maintenance The ear hook can be wiped with a dry or slightly damp cloth. The cords and base unit can be dry-dusted as required. Avoid getting moisture or liquids into any button sockets, receptors or other openings. Avoid exposing the product to rain. Children and product packaging The pa...
Page 21 - Setting up
19 English 9.x 9.x 9.x 9.x 15.1 9.x 9.x 9.x 9.x 15.2 9.x 9.x 9.x 9.x 15. App endix – G N 1000 Remote Handset Lifter (RHL) (optional acce ssory) The GN 1000 Remote Handset Lifter (RHL) is an optional acces-sory that automatically lifts and lowers your telephone’s handset when making, answering or end...
