Lennox H6977 - Manual
Lennox H6977 – Manual, read for free online in PDF format. We hope this helps you resolve any issues you may have. If you have further questions, please contact us through the contact form.
Table of Contents:
- Page 2 – Figure 3; Refer to; Step 11. Locate the wire harness behind the right hand side frame.; the shield upwards to align the slots to the screws and remove.; Refer to Figures 4 and 5.; Wire Shield; Figure 4; Bottom Side View; Figure 5; Upper Side View
- Page 3 – Figure 6; Cut Wire Ties If Provided; Figure 7; Twist And Tape; Figure 8; Pull To Replace; Figure 9; Pull Remote Receiver Cables Out
- Page 6 – DVD INSTALLATION INSTRUCTIONS
NOTE: DIAGRAMS & ILLUSTRATIONS NOT TO SCALE.
1
REFLECTIONS REMOTE CONTROL
REPLACEMENT KIT
HEARTH PRODUCTS
KITS AND ACCESSORIES
INSTALLATION INSTRUCTIONS FOR THE REFLECTIONS REMOTE CONTROL
REPLACEMENT KIT (KIT NUMBERS: H1454 AND H6977)
P/N 750,251M
REV. A 01/2008
GENERAL INFORMATION
This Remote Control Replacement Kit is to be used to replace the
Reflections Electric Fireplace’s Remote Control. The kit components are
shown below.
REPLACEMENT INSTRUCTIONS
Note: Depending on the type of control board in your fireplace, the
number of steps and components may vary. Following are the types of
control boards for identification:
If you have Kit Number H1094, it will be necessary to replace the board
and IR cables. In this case, complete all the Steps as outlined in these
instructions.
If you have Kit Numbers H1454 or H6977, it is not necessary to replace
the IR cables. In this case, skip Steps 11 through 21 and complete the
remaining process as outlined in these instructions.
Refer to the Reflections Fireplace Installation Instructions manual (No.
850,091M) for a visual aid on the following steps:
Step 1. Disconnect the electrical power to the fireplace.
Step 2. Remove the doors from the fireplace.
Step 3. Remove the reflective glass.
Step 4. Remove the logs.
Step 5. Remove the grate.
Step 6. Remove the ember bed.
Step 7. Remove the fireplace floor.
Step 8. Remove the DVD player. Make sure to label the “Video Out” and
“Sound Out” cables when disconnected from the DVD player.
Figure 1
(Kit Number H1094)
Plastic Holders
Control Board
Figure 2
IR Cables
(Kit Number H1454 And/Or H6977)
"Loading the manual" means you need to wait until the file loads and becomes available for online reading. Some manuals are very large, and the time they take to appear depends on your internet speed.
Summary
2 NOTE: DIAGRAMS & ILLUSTRATIONS NOT TO SCALE. Figure 3 Step 9. Locate the fireplace control board (Kit Number H1094) andremove it, including the plastic holders ( Refer to Figure 1 ). Step 10. Disconnect the IR cables (ribbon type cables). Refer to Figure 2. Step 11. Locate the wire harness beh...
NOTE: DIAGRAMS & ILLUSTRATIONS NOT TO SCALE. 3 Step 15. Locate the TV IR cable and cut about five (5) inches from theend ( see Figure 6 ). Step 16. Twist the connector end of the new IR cable to the ends of theold IR cable and wrap securely with duct tape. Refer to Figure 7. Note: Free all cable...
6 NOTE: DIAGRAMS & ILLUSTRATIONS NOT TO SCALE. Figure 17 Strap The DVD Player Figure 16 Attach A/V Cables And IR Transmitter Unit DVD INSTALLATION INSTRUCTIONS Refer to the DVD Replacement Kit Installation Instructions manual (No.750,250M) for additional aid on the following steps: Step 1. Befor...
