Lennox 2-MN53-VDLPM - Manual
Lennox 2-MN53-VDLPM – Manual, read for free online in PDF format. We hope this helps you resolve any issues you may have. If you have further questions, please contact us through the contact form.
Table of Contents:
- Page 2 – TABLE OF CONTENTS
- Page 3 – Table 1
- Page 4 – Table 2; LOCATION; il; Shelf Height
- Page 5 – Figure 5. All horizontal; APPLIANCE AND VENT CLEARANCES
- Page 6 – Side Elevation View
- Page 7 – Figure 8; EXTERIOR HORIZONTAL VENT TERMINATION CLEARANCE REQUIREMENTS
- Page 8 – Figure 9 Framing; FIREPLACE FRAMING SPECIFICATIONS; Framing should be; Note: The appliance 45; collar can be rotated about its axis to align for
- Page 9 – Unit Dimensions; FIREPLACE SPECIFICATIONS
- Page 10 – Step 3. INSTALL THE VENT SYSTEM; General Information; DO NOT; tor inside the fixed restrictor.; Select Venting System - Horizontal or Vertical; Exhaust Vent; and; Figure 18 for the
- Page 11 – Exception: Clearance
- Page 12 – Connection; collar unless rigid; Vent / 45 Degree Starter; Maximum
- Page 13 – Figure 22 ) installs in the exact
- Page 14 – VERTICAL VENT FIGURES/TABLES; WARNING: UNDER NO CIRCUMSTANCES MAY SEPARATE SECTIONS; TABLE A; with the termination, frame to 5” clearance where applicable.
- Page 15 – refer to Figure 15 and 16 on page 12). All of; Support
- Page 16 – TYPICAL HORIZONTAL VENT INSTALLATION; . Use a carpenter’s level to measure; If attic space is; refer to
- Page 18 – HORIZONTAL VENT FIGURES/TABLES
- Page 19 – CONNECTION NOT DIRECTLY AT APPLIANCE; See; Table 3 as an aid in venting component selection; for a particular range of exterior wall thicknesses.; CONNECTION DIRECTLY AT APPLIANCE
- Page 21 – Radius Minimum; VERTICAL OR HORIZONTAL VENTING USING; SECURE FLEX; KITS AND COMPONENTS; inch from the
- Page 22 – INTERMITTENT ELECTRONIC WIRING DIAGRAM
- Page 23 – Step 5. CONNECTING GAS LINE; Figure 38 for flex line; Figure 37. Failure to do so; see Figure; Flare Fitting; Piezo Ignitor
- Page 24 – INSTALLING THE GLASS DOOR; ELECTRONIC; MILLIVOLT; Step 7. CHECKING APPLIANCE OPERATION; Refer to; Figure 43 and loosen the set screw; place logs if removed for pilot inspection.; Figure 42 ) by lifting and pulling the; bottom panel forward.
- Page 25 – Burner Adjustment; Step 9. BURNER ADJUSTMENTS; Flame Appearance and sooting; burner to operate for at least 20 minutes.; refer to Figure 39 ) until the flame; appearance is as desired.
- Page 26 – INSTALLATION ACCESSORIES; li; ll; MANTEL CLEARANCES; COLD CLIMATE INSULATION
- Page 27 – INSTALLATION ACCESSORIES CONTINUED
- Page 28 – Step 1. Turn off the gas supply to the appliance.; GAS CONVERSION KITS
NOTE: DIAGRAMS & ILLUSTRATIONS NOT TO SCALE.
1
VENTED GAS FIREPLACE HEATERS - DIRECT VENT MODELS
P/N 850,043M REV. F 09/2008
MODELS
DIRECT VENT
MERIT
™
PLUS SERIES
This appliance may be installed in an aftermarket perma-
nently located, manufactured home (USA only) or mobile
home, where not prohibited by local codes. This appliance
is only for use with the type of gas indicated on the rating
plate. This appliance is not convertible for use with other
gases, unless a certified kit is used.
FOR YOUR SAFETY: Do not store or use gasoline
or other flammable vapors or liquids in the vicin-
ity of this or any other appliance.
FOR YOUR SAFETY: What to do if you smell gas:
• DO NOT light any appliance.
• DO NOT touch any electrical switches.
• DO NOT use any phone in your building.
• Immediately call your gas supplier from a
neighbor’s phone. Follow your gas suppliers
instructions.
• If your gas supplier cannot be reached, call the
fire department.
Installation and service must be performed by a
qualified installer, service agency or the gas
supplier.
POUR VOTRE SÉCURITÉ: Ne pas entreposer ni utiliser
d'essence ni d'autre vapeurs ou liquides inflammables
dans le voisinage de cet appareil ou de tout autre
appareil.
POUR VOTRE SÉCURITÉ: Que faire si vous sentez une
odeur de gaz:
• Ne pas tenter d'allumer d'appareil.
• Ne touchez à aucun interrupteur. Ne pas vous servir
des téléphones se trouvant dans le batiment où
vous vous trouvez.
• Evacuez la piéce, le bâtiment ou la zone.
• Appelez immédiatement votre fournisseur de gaz
depuis un voisin. Suivez les instructions du
fournisseur.
• Si vous ne pouvez rejoindre le fournisseur de gaz,
appelez le service dos incendies.
L'installation et service doit être exécuté par un qualifié
installeur, agence de service ou le fournisseur de gaz.
INSTALLATION
INSTRUCTIONS
OTL Report No. 116-F-47-5
WARNING: IF THE INFORMATION IN THIS MANUAL
IS NOT FOLLOWED EXACTLY, A FIRE OR EXPLOSION
MAY RESULT CAUSING PROPERTY DAMAGE, PER-
SONAL INJURY OR LOSS OF LIFE.
AVERTISSEMENT: ASSUREZ-VOUS DE BIEN SUIVRE
LES INSTRUCTIONS DONNÉ DANS CETTE NOTICE POUR
RÉDUIRE AU MINIMUM LE RISQUE D'INCENDIE OU
POUR ÉVITER TOUT DOMMAGE MATÉRIEL, TOUTE
BLESSURE OU LA MORT.
In the Commonwealth of Massachusetts:
• Installation must be performed by a licensed plumber or
gas fitter.
See Table of Contents for location of additional
Commonwealth of Massachusetts requirements.
INSTALLER: Leave this manual with the appliance.
CONSUMER: Retain this manual for future reference.
s
l
e
d
o
M
t
l
o
v
i
l
l
i
M
s
l
e
d
o
M
c
i
n
o
r
t
c
e
l
E
M
N
0
3
-
V
D
L
P
M
E
N
0
3
-
V
D
L
P
M
M
P
0
3
-
V
D
L
P
M
2
-
E
N
5
3
-
V
D
L
P
M
2
-
M
N
5
3
-
V
D
L
P
M
E
N
0
4
-
V
D
L
P
M
2
-
M
P
5
3
-
V
D
L
P
M
E
N
5
4
-
V
D
L
P
M
M
N
0
4
-
V
D
L
P
M
M
P
0
4
-
V
D
L
P
M
M
N
5
4
-
V
D
L
P
M
M
P
5
4
-
V
D
L
P
M
US
Portland
A French manual is available upon request. Order Form Number
850,043CF.
Ce manuel d’installation est disponible en francais, simplement
en faire la demande. Numéro de la pièce 850,043CF.
"Loading the manual" means you need to wait until the file loads and becomes available for online reading. Some manuals are very large, and the time they take to appear depends on your internet speed.
Summary
2 NOTE: DIAGRAMS & ILLUSTRATIONS NOT TO SCALE. Figure 1 TABLE OF CONTENTS Packaging ........................................ page 2 Introduction ..................................... page 2 General Information ......................... page 2 Location .......................................... p...
NOTE: DIAGRAMS & ILLUSTRATIONS NOT TO SCALE. 3 Note: Power venting of direct vent fireplacesmay result in the reduction of efficiencies byas much as ten percent. Consider this inmaking any venting and heating decisions inany installation application. % s e i c n e i c i f f E s l e d o M s a G l...
4 NOTE: DIAGRAMS & ILLUSTRATIONS NOT TO SCALE. Figure 2 Figure 3 *Note: 3 in. (76mm) above any horizontal/inclined vent component for the MPLDV30in all cases, and for the MPLDV35, MPLDV40& MPLDV45, when the vent center line isgreater than 48" (1219 mm) above the fire-place top wrapper su...
