La Crosse Technology WT-5431 Manual

Page 2 - Detailed Set-Up Guide; Program Mode; Features & Operations

2 TABLE OF CONTENTS Topic Page Inventory of Contents/ Additional Equipment 3 About WWVB 3 Quick Set-Up Guide 4 Detailed Set-Up Guide Battery Installation 5-6 Program Mode Programming Sequence 6 Function Buttons 6 Time Zone Setting 6-7 DST (Daylight Saving Time) Setting 7 Adjustable Snooze 7 Time Set...

Page 3 - Operation of these features is in section III.

3 INVENTORY OF CONTENTS 1) WT-5431 Alarm Clock 2) TX6U Remote temperature sensor 3) AC adapter/transformer (6V) 4) Instruction manual and warranty card. ADDITIONAL EQUIPMENT (not included) 1) Three fresh 1.5V AA batteries (optional for alarm clock) 2) Two fresh 1.5V AA batteries (for remote sensor) ...

Page 4 - outdoor remote

4 QUICK SET-UP GUIDE Hint: Use good quality Alkaline Batteries and avoid rechargeable batteries. 1. Have the indoor station and outdoor remote 3 to 5 apart. 2. Batteries should be out of both units for 10 minutes. 3. Place the batteries into the outdoor remote first then into the indoor station. (Al...

Page 5 - Replace the battery cover.; PROJECTION ALARM; Remove the battery cover.

5 Battery Cover DETAILED SET-UP GUIDE Important: Insert batteries into the sensor first, then into the alarm clock. Do not press any buttons until remote temperature is displayed. II. BATTERY INSTALLATION A. REMOTE TEMPERATURE SENSOR 1. Remove the battery cover. Observing the correct polarity, insta...

Page 6 - DISPL; TIME ZONE SETTING; SET”

6 is found during this period, the tower icon will not appear and the clock will search again at 12:00 am the next night. 6. Either wait for the WWVB reception or manually set the time and date, making sure to set the correct time zone. III. PROGRAM MODE To enter the Program Mode hold down the “SET”...

Page 9 - RADIO-CONTROLLED TIME AND DATE

9 IV. FEATURES & OPERATIONS A. FEATURES 1. Radio-controlled time and date 2. Projection of time and/or remote temperature 3. EL backlight 4. Six modes of date/seconds/temperature display 5. Indoor temperature 6. Remote outdoor temperature 7. Dual alarms 8. Adjustable snooze B. RADIO-CONTROLLED T...

Page 11 - TIME ALARM; SETTING THE ALARM

11 defect, but simply reflects the difference in measuring methods. The remote temperature is designed for changing temperature at a wide range. F. REMOTE TEMPERATURE 1. The projection alarm comes with a remote temperature sensor. When set up properly, the projection alarm will receive and display t...

Page 13 - MOUNTING WITH SCREWS; Where marked, start the screw holes into the mounting surface.; MOUNTING WITH ADHESIVE TAPE

13 V. MOUNTING THE REMOTE TEMPERATURE SENSOR The Remote Temperature Sensor can be mounted in two ways: 1) with the use of screws, or 2) using the adhesive tape. A. MOUNTING WITH SCREWS 1. Remove the mounting bracket from the Remote Temperature Sensor. The bracket should snap off easily. 2. Place the...