Kramer WP-306 - Manual
Kramer WP-306 – Manual, read for free online in PDF format. We hope this helps you resolve any issues you may have. If you have further questions, please contact us through the contact form.
The Kramer WP-306 Wall Plate
Congratulations on purchasing your Kramer
WP-306
Wall Plate
which is ideal for
boardrooms and presentation rooms.
The
WP-306
is a single-gang wall plate insert.
WP-306 Wall Plate US Version
WP-306 Wall Plate
.
Figure 1: WP-306 Wall Plate US Version Front and Rear View
Table 1: WP-306 Wall Plate US Version Front and Rear Features
# Feature
Function
1
ON
LED
Lights red when receiving power (when no signal is detected); lights
green when receiving a signal
2
HDMI IN
Connector
Connect to the HDMI digital source
3
IR OUT
3.5mm Mini Connector
Connect to a machine via an IR Emitter. Note, that the IR output is
only compatible with the
SV-552
4 RJ-45 Connector
Connect to the SV-552 Processor/Controller. Note that the WP-306
requires BC-DGKat524 or BC-DGKat-623 cable for connection
5 DC IN Power Connector
Connect to the 12V power supply (supplied free)
Wiring the Twisted Pair RJ-45 Connector
The US versions of the wall plates are equipped with RJ-45 terminals.
STP pinout using a straight pin to pin
cable with RJ-45 connectors. For STP cable, cable
shielding must be connected/soldered to the connector shield.
Note:
For cabling
WP-306
wall plates, use either Kramer
BCP-DGKat524
or
BCP-DGKat623
STP cables.
EIA /TIA 568B
PIN
Wire Color
1
Orange/White
2
Orange
3
Green/White
4
Blue
5
Blue/White
6
Green
7
Brown/White
8
Brown
Pair 1
4 and 5
Pair 2
1 and 2
Pair 3
3 and 6
Pair 4
7 and 8
Figure 2: RJ-45 Pinout (U.S.)
WP-306 Wall Plate EU/UK Versions
and
define the EU/UK version of the
WP-306 Wall Plate
.
Destination Belgium and Germany
Destination England and the rest
of Europe (excluding Belgium and
Germany)
Rear panel view
Figure 3: WP-306 Wall Plate EU/UK Version Front and Rear Views
Table 2: WP-306 Wall Plate EU/UK Version Front and Rear Features
#
Feature
Function
1
ON
LED
Lights red when receiving power (when no signal is
detected); lights green when receiving a signal
2
HDMI IN
Connector
Connect to the HDMI digital source
3
IR OUT
3.5mm Mini Connector
Connect to a machine via an IR Emitter. Note, that the IR
output is only compatible with the
SV-552
4 Terminal Block
Connect to SV-552. Note that the
WP-306
requires
BC-DGKat524 or BC-DGKat-623 cable for connection
5
GROUND
Connection
Ring tongue terminal and grounding screw
6
GND +12V
2-pin Power Terminal Block
Connect to the 12V power supply (included)
"Loading the manual" means you need to wait until the file loads and becomes available for online reading. Some manuals are very large, and the time they take to appear depends on your internet speed.
