Kramer VS-1211 - Manual

Table of Contents:

• Page 2 – KRAMER ELECTRONICS LTD.; Table of Contents; Section
• Page 3 – List of Illustrations; Figure; RS-232 Control Connector Wiring; List of Tables; DIP Switch Settings
• Page 4 – INTRODUCTION; audio input and output type.; Balanced Audio Family:; transition is hidden.
• Page 5 – switchers to be used in the most demanding applications.; Factors Affecting Quality of Results; Connection cables; - So often ignored, they should be of highest; Amplifying circuitry; distortion and low noise operation.; Distance between sources and acceptors; - Plays a major role in the final result. For long distances (over; Interference from neighboring electrical appliances; - These can have an adverse effect on signal quality.
• Page 6 – for remote connector.; Video Controls; Bottom accessible trimmers for video gain
• Page 7 – HOW DO I GET STARTED?; UNPACKING AND CONTENTS; Optional Accessories; VIDEO TESTER
• Page 8 – KRAMER “VS” SERIES SWITCHERS; and; Figure 1: RS-232 Control Connector Wiring
• Page 9 – Getting to Know Your Switcher; the “
• Page 11 – INSTALLATION; NOTE; are described and may be applied accordingly to the others.; CONNECTING TO AUDIO DEVICES; through the RCA type connectors located on the back of the unit.; DIP SWITCHES, JUMPERS AND TRIMMERS; available without removing the switcher cover.; It can be operated by touching one of the front panel switches.; conjunction with each other.
• Page 12 – Table : DIP Switch Settings
• Page 13 – Figure : Location of Internal Jumpers
• Page 14 – The Internal Trimmers; A PC that communicates with the switcher directly.
• Page 16 – CONNECTING TO A PC; Changing communication protocols; use the old protocol.; Additional software options; at the technical support section.; USING THE SWITCHER; be applied accordingly to the others.
• Page 17 – Selecting an Input on the Switchers; Using the PC Control Software; Section 9) and mark them accordingly for future reference.; Adding Outputs
• Page 18 – Figure : Connecting Two Switchers for adding More Outputs; Adding Inputs; If necessary, carefully remove the covers of the switchers to do so.
• Page 19 – Connect the sources to the appropriate switcher inputs.; Video Component and YC Switching; Assign unique machine numbers to each switcher.; TAKING CARE OF YOUR SWITCHER; inside unused or open connectors.; TROUBLESHOOTING
• Page 20 – Power and Indicators; Problem; Do not use the trimmers except in cases where the cable losses
• Page 21 – Do not disconnect the; Sometimes connectors work loose and have to be reinserted.
• Page 22 – Switching Malfunctions; source is a break in the connecting wire.
• Page 23 – Vertical Interval; MSB; Where; switch 7 on the front panel.; Several special codes are also valid:; input is selected on its front panel.
• Page 24 – LIMITED WARRANTY; Only the first purchase customer may enforce this warranty.