Page 2 - This page is intentionally left blank
Page 3 - Contents; Introduction; Figures
SPK-C613 – Contents i Contents 1 Introduction 1 2 Getting Started 2 2.1 Achieving the Best Performance 2 3 Overview 3 4 Your SPK-C613 4 5 Installing the Open-back Ceiling Speakers 6 5.1 Choosing the Best Location 6 5.2 Cutting the Ceiling Tile 6 5.3 Mounting the Open Back Ceiling Speakers 7 5.4 Arra...
Page 6 - Getting Started; Achieving the Best Performance
2 SPK-C613 - Getting Started 2 Getting Started We recommend that you: • Unpack the equipment carefully and save the original box and packaging materials for possible future shipment • Review the contents of this user manual • Use Kramer high-performance high-resolution cables Go t
Page 7 - Overview; speakers; SKIC; Figure 1
SPK-C613 - Overview 3 3 3 Overview The SPK-C613 speakers include a pair of high performance Open-back Ceiling speakers that can be mounted on the ceiling. The optional Kramer Suspended Ceiling Speaker Mounting Kit ( SKIC ) can safely secure the speakers to the ceiling as well. The SPK-C613 speakers ...
Page 9 - Each Open-back ceiling
SPK-C613 - Your SPK-C613 5 5 The following table defines the Open-back ceiling speaker hardware items (per speaker pair): Description A pair of ceiling speakers (one shown) Two grilles (one shown) Cutout template The following table defines the items that make up the optional Suspended Ceiling Speak...
Page 10 - Installing the Open-back Ceiling Speakers; Choosing the Best Location
6 SPK-C613 - Installing the Open-back Ceiling Speakers 5 Installing the Open-back Ceiling Speakers This section explains how to install the Open-back ceiling speakers, that is: • Choosing the best place to locate your speakers (see Section 5.1 ) • Cutting the ceiling tile (see Section 5.2 ) • Instal...
Page 11 - Mounting the Open Back Ceiling Speakers; grille openings and pulling it upward.
SPK-C613 - Installing the Open-back Ceiling Speakers 7 7 Do not nail or staple the speaker wires. If you are mounting the speakers onto a ceiling tile, remove the ceiling tiles where you plan to install the speakers. Use the template to trace and then cutout the speaker hole over an empty box. The o...
Page 12 - Figure 4; Connect the speaker wires to the speaker terminals.; Using the Suspended Ceiling Speaker Mounting Kit (Optional); To install the Open-back ceiling
8 SPK-C613 - Installing the Open-back Ceiling Speakers 3. Adjust each speaker to the appropriate tap setting before installing the grille (see Figure 4 ). Set the tap according to the power requirements of the speaker based on its location in the room (for example, a speaker located in a remote corn...
Page 13 - Array Installation; Figure 6; Support Ring
SPK-C613 - Installing the Open-back Ceiling Speakers 9 9 Figure 5: Installing the Open-back Ceiling Speakers 2. Place the tile rails on the tile and snap them into the two tabs on the C-ring. Align the rails so that the ends extend over the T-channel grid. 3. Insert a screw through each tab on the C...
Page 14 - Figure 7
10 SPK-C613 - Installing the Open-back Ceiling Speakers Figure 6: The Speaker Coverage Area The coverage angle of the speaker determines the coverage area and the number of speakers required in the array installation. Two patterns are usually used for array installations, square (see Figure 7 ) or h...
Page 15 - Figure 9
SPK-C613 - Installing the Open-back Ceiling Speakers 11 11 Figure 9 shows an example of parallel wiring in a square array installation: Figure 9: Square Layout Parallel Wiring
Page 16 - Painting the Speaker; Spray with color by holding the spray can at an angle of 45
12 SPK-C613 - Installing the Open-back Ceiling Speakers 5.5 Painting the Speaker You can paint the speakers before or after the speakers are installed. When painting before installation: • Clean the rim and grille with mineral spirits or other light solvent that is unlikely to damage the surface • S...
Page 17 - Technical Specifications
SPK-C613 - Technical Specifications 13 13 6 Technical Specifications Audio and Power DESCRIPTION: 2-way open ceiling speakers HIGH FREQUENCY DRIVER: 1/2" MYLAR dome tweeter LOW FREQUENCY DRIVER: 6.5” Polypropylene cone with rubber edge woofer IMPEDANCE: 8Ω DISPERSION COVERAGE: 120° @2000Hz CROSS...