Page 2 - List Of Illustrations; List Of Tables
KRAMER ELECTRONICS LTD. Table Of Contents Section Name Page 1 INTRODUCTION 1 1.1 A Word on Sync Signals 1 1.1.1 Horizontal Sync 1 1.1.2 Sync location 2 1.2 Video Sync Processors 3 1.3 Factors Affecting Quality of Results 3 2 Specifications 4 Specifications (cont.) 5 3 How Do I Get Started? 6 4 Unpac...
Page 3 - Kramer Electronics Ltd.; INTRODUCTION; Figure 1: Horizontal Sync
Kramer Electronics Ltd. 1 1 INTRODUCTION Congratulations on your purchase of this Kramer Electronics Sync processor. Since 1981 Kramer has been dedicated to the development and manufacture of high quality video/audio equipment. The Kramer line has become an integral part of many of the best producti...
Page 4 - Sync location varies according to video format, as follows:
Kramer Electronics Ltd. 2 Vertical sync, often referred to as the field sync (see Figure 2), is also a negatively directed set of pulses, found at the beginning of each video field (60 field/sec. in NTSC, 50 fields/sec. in PAL). Vertical sync is a more complicated signal than horizontal sync, which ...
Page 5 - Video Sync Processors; Kramer Electronics has a full line of Video; Sync Processors; that can perform sync stabilization, restoration; FACTOR EFFECT
Kramer Electronics Ltd. 3 Another twist to this format is that in most cases the logic-level syncs are separated and run each in its own channel, but there are cases where the logic-level syncs come composite – joined together in the same mix of directions. In the digital world – SDI, DV, MPEG and o...
Page 6 - SPECIFICATIONS; H and V TTL level syncs, any
Kramer Electronics Ltd. 4 2 SPECIFICATIONS SG-6N SG-7 Input 1 Composite video, 1Vpp/75 ohms on a BNC connector. INPUT CHANNEL 1: One composite sync >0.3Vpp / 75 ohm or 1 TTL level composite sync 5 Vpp/ 47k on a BNC type connector with Hi-Z/75ohm switch, at video frequencies only. INPUTS CHANNEL 2...
Page 7 - SPECIFICATIONS
Kramer Electronics Ltd. 5 SPECIFICATIONS SG-9 SG-11 SG-6003B Input 1 composite video 1Vpp/75 ohm on a BNC. 1 Green 0.7Vpp/75 ohm One Sync 0.3Vpp/75 ohm on BNCs. Output 1 restored composite video 1Vpp/75 ohm on a BNC. 1 Sync on Green 1Vpp / 75 ohm on a BNC. 1 Green 0.7Vpp / 75 ohm, One Sync 1Vpp / 75...
Page 8 - HOW DO I GET STARTED?; Mechanical Rack Adapter -
Kramer Electronics Ltd. 6 3 HOW DO I GET STARTED? The fastest way to get started is to take your time and do everything right the first time. Taking 15 minutes to read the manual may save you a few hours later. You don’t even have to read the whole manual. If a section doesn’t apply to you, you don’...
Page 9 - NOTE; For operation instructions refer to section 9.
Kramer Electronics Ltd. 7 5 SYNC PROCESSORS This section describes all the controls and connections of your machine. Understanding the controls and connections helps you realize the full power of your machine. 5.1 Getting to Know Your SG-6N Sync Stabilizer The KRAMER SG-6N Video Sync Stabilizer repl...
Page 10 - Getting to Know Your SG-7 Sync Transcoder
Kramer Electronics Ltd. 8 5.2 Getting to Know Your SG-7 Sync Transcoder The KRAMER SG-7 Universal Sync Transcoder interfaces between the widely used professional video sync formats - Composite sync, Horizontal sync, Vertical sync - Analog and TTL levels. In many video studios and professional applic...
Page 11 - Getting to Know Your SG-9 Video Black Burst Restorer; Function
Kramer Electronics Ltd. 9 5.3 Getting to Know Your SG-9 Video Black Burst Restorer The KRAMER SG-9 Video Black Burst Restorer replaces corrupted or missing horizontal and vertical syncs as well as color burst from a video signal with standard synchronization and color signals. In many cases the KRAM...
Page 12 - Getting to Know Your SG-11 Sync to Green Adder/Stripper
Kramer Electronics Ltd. 10 5.4 Getting to Know Your SG-11 Sync to Green Adder/Stripper The KRAMER SG-11 Sync to Green Adder/Stripper interfaces between the two most widely used professional Component Video formats - RGB with Sync On Green and RGBS. In many video studios and production centers there ...
Page 13 - Getting to Know Your SG-6003B Black Burst/Color Bar Generator; For operation instructions refer to section 8.
Kramer Electronics Ltd. 11 5.5 Getting to Know Your SG-6003B Black Burst/Color Bar Generator The KRAMER SG-6003B is a broadcast level Black Burst/Color Bar Generator for video studio applications. The SG-6003B provides three identical Black Burst outputs, a color Subcarrier output, a Color Bar outpu...
Page 14 - To select PAL or NTSC, simply select the required system using the
Kramer Electronics Ltd. 12 6 INSTALLATION 6.1 Rack Mounting The SG-7 and the SG-6003B can be rack mounted in a standard 19” (1U) EIA rack, and include rack “ears” at the ends of the front panel. To rack mount these machines, simply place the unit's ears against the rack rails of your rack, and inser...
Page 15 - TAKING CARE OF YOUR PROCESSOR; Figure 8: Stabilizing the Video Sync
Kramer Electronics Ltd. 13 removed in the same way by performing proper clamping. To clamp the DC level to -1V or 0V select the desired level using the -1V/0V switch located on the machine's rear panel. 8 TAKING CARE OF YOUR PROCESSOR Do not locate your processor in an environment where it is suscep...
Page 16 - Sync processor
Kramer Electronics Ltd. 14 9.2 Black Burst/Bar Generator Connections Figure 9 describes typical usage of a Black Burst/Bar Generator, where the SG-6003B functions as a test and alignment tool for the audio and video acceptors and can provide black or color reference bar for cameras that need a stabl...
Page 17 - Transcoding Various Sync Formats
Kramer Electronics Ltd. 15 Figure 10: Restoring Black Burst and Image Stability 9.4 Transcoding Various Sync Formats Transcoding between various video sync formats can be performed by the SG-7, as described in Figure 11. Perform the following steps (as necessary): 1) Connect a composite sync source ...
Page 19 - 0 TROUBLESHOOTING; NOTES; Please note that if the output signal is disturbed or; Power and Indicators; Problem Remedy; Locate the fuse holder inside your machine (see Figure
Kramer Electronics Ltd. 17 10 TROUBLESHOOTING NOTES 1. Please note that if the output signal is disturbed or interrupted by very strong external electromagnetic interference, it should return and stabilize when such interference ends. If not, turn the power switch off and on again to reset the machi...
Page 20 - Video Signal
Kramer Electronics Ltd. 18 Figure 12: SG-6N Fuse Location 10.2 Video Signal Problem Remedy No video at the output device 1. Confirm that your source and output devices are powered on and connected properly. The input of your machine should be of an identical signal format at the output of your sourc...
Page 21 - Only the first purchase customer may enforce this warranty.
Kramer Electronics Ltd. 19 LIMITED WARRANTY Kramer Electronics (hereafter Kramer) warrants this product to be free from defects in material and workmanship under the following terms. HOW LONG IS THE WARRANTY Labor and parts are warranted for three years from the date of the first customer purchase. ...
Page 22 - EXCLUSION OF DAMAGES; FCC Rules and Regulations:
Kramer Electronics Ltd. 20 EXCLUSION OF DAMAGES Kramer’s liability for any defective products is limited to the repair or replacement of the product at our option. Kramer shall not be liable for: 1) Damage to other property caused by defects in this product, damages based upon inconvenience, loss of...
Page 23 - The list of Kramer distributors appears on our web site:
Kramer Electronics Ltd. 3 Am VeOlamo Street. Jerusalem 95463, Israel Tel: (972-2)-654-4000. Fax: (972-2)-653-5369 e-mail: [email protected] The list of Kramer distributors appears on our web site: www.kramerelectronics.com From the web site it is also possible to e-mail factory headquarters....
