Kohler K-T7751-4-CP- Installation Manual
Kohler K-T7751-4-CP– Installation Manual, read for free online in PDF format. We hope this helps you resolve any issues you may have. If you have further questions, please contact us through the contact form.
Table of Contents:
- Page 2 – Observe all local plumbing and building codes.
- Page 3 – Remove the Pipe Plug; Turn off the main water supply.; Pipe Plug
- Page 4 – Install the Spout Supply Tube; For all other installations:; Install Spout Supply Tube
- Page 6 – Install the Handles; For regular handle assemblies:
- Page 7 – Complete the Installation; Turn on the main water supply and check for leaks.; Spout
- Page 8 – Guide d’installation; Garniture de robinet de baignoire sur comptoir; Outils et matériels; Respecter tous les codes de plomberie et de bâtiment locaux.; Clé à molette
- Page 9 – Retirer le bouchon du tuyau; Fermer l’alimentation d’eau principale.; AVERTISSEMENT : Risque de blessures corporelles.; Ne pas
- Page 10 – Installer le tube d’alimentation du bec; Retirer le renfort de plâtre du tube d’alimentation du bec.; Pour les installations sur comptoir recouvert de carrelage :; Faire; Pour toutes les; Jeter la rondelle en laiton.; Manchon; Installer le tube d'alimentation du bec; Rondelle en laiton
- Page 11 – Vis de retenue
- Page 12 – Installer les poignées; L’ensemble illustré peut ne pas être identique au; Pour les ensembles de poignées normales :; Appuyer sur le; Bouchon
- Page 13 – Terminer l’installation; Ouvrir l’alimentation d’eau principale et rechercher des fuites.; Bec
- Page 14 – Guía de instalación; Herramientas y materiales; Cumpla con todos los códigos locales de plomería y construcción.
- Page 15 – Desinstale el tapón de tubo; Cierre el suministro de agua.; ADVERTENCIA: Riesgo de lesiones personales.; Al girar o; Tapón
- Page 16 – Instale el tubo de suministro del surtidor; Retire el protector de yeso del tubo de suministro del surtidor.; Para instalaciones en cubierta con revestimiento de azulejo:; Deseche la arandela de latón.; Tornillos
- Page 17 – Instale el surtidor; Para evitar daño al sello de la base del surtidor, tenga; Arosello
- Page 18 – Instale las manijas
- Page 19 – Para ensambles de manija regulares:; Presione el tapón botón
- Page 20 – Termine la instalación; Cierre las válvulas del agua fría y caliente.; Surtidor
Installation Guide
Deck-Mount Bath Faucet Trim
M
product numbers are for Mexico (i.e. K-12345
M
)
Los números de productos seguidos de
M
corresponden a México (Ej.
K-12345
M
)
Français, page “Français-1”
Español, página “Español-1”
K-T7019
1011303-2-C
"Loading the manual" means you need to wait until the file loads and becomes available for online reading. Some manuals are very large, and the time they take to appear depends on your internet speed.
Summary
Tools and Materials Before You Begin Observe all local plumbing and building codes. Shut off the water supply. Install the required valves (K-300-K-NA, K-300-KR-NA, orK-301-K-NA) prior to installing the product. Refer to theinstallation instructions packed with the valves. Complete the finished deck...
1. Remove the Pipe Plug Make sure the valves are closed (cold = fully counterclockwise;hot = fully clockwise). Turn off the main water supply. WARNING: Risk of personal injury. Do not lean over the pipe plug when turning or removing the pipe plug. Thewater supply lines may be pressurized, causing wa...
2. Install the Spout Supply Tube Remove the plaster guard from the spout supply tube. Using a tube cutter, cut the spout supply tube 1-1/4 ″ (3.2 cm) above the finished surface. Using a file, remove all burrs from the spout supply tube. Thiswill prevent damage to the O-ring inside the sleeve. For ti...
