Kohler K-409-K-NA- Installation Manual
Kohler K-409-K-NA– Installation Manual, read for free online in PDF format. We hope this helps you resolve any issues you may have. If you have further questions, please contact us through the contact form.
Table of Contents:
- Page 2 – Solder
- Page 8 – Install the Transfer Valve; If installing to a finished deck:
- Page 9 – Install the Handshower
- Page 10 – Complete the Valve Installation; Installation Checkout
- Page 12 – Guide d’installation; Valve à deux/trois voies; Outils et matériels; ATTENTION : Risque d’endommagement du matériel.; ATTENTION : Risque d’endommagement du produit.; Soudure
- Page 14 – Plan des composants; Connexion tuyau
- Page 16 – Convertir à une valve deux voies
- Page 18 – Installer la valve transfert
- Page 19 – Installer la douchette
- Page 22 – Guía de instalación; Válvula de dos vías/tres vías; Herramientas y materiales; PRECAUCIÓN: Riesgo de daños a la propiedad.
- Page 24 – Disposición de los componentes; Ducha auxiliar
- Page 26 – Convierta a válvula de dos vías
- Page 28 – Instale la válvula de transferencia; Si se instala sobre una cubierta acabada:
- Page 29 – Instale la ducha de mano
Installation Guide
Two-Way/Three-Way Valve
M
product numbers are for Mexico (i.e. K-12345
M
)
Los números de productos seguidos de
M
corresponden a México (Ej.
K-12345
M
)
Français, page
″
Français-1
″
Español, página
″
Español-1
″
K-408
K-409
086847-2-AC
"Loading the manual" means you need to wait until the file loads and becomes available for online reading. Some manuals are very large, and the time they take to appear depends on your internet speed.
Summary
Tools and Materials Before You Begin CAUTION: Risk of property damage. When installed in a two-way configuration, the auxiliary outlet must be cappedoff to prevent possible leakage out of the unused auxiliaryoutlet, and the grey collar must be changed to the blacktwo-way stop collar. CAUTION: Risk o...
4. Install the Transfer Valve CAUTION: Risk of product damage. Excessive heat will damage the internal plastic components. IMPORTANT! Do not apply excessive heat while soldering. Direct the torch flame away from the brass body. IMPORTANT! Only apply direct heat to the connectors and extensions. IMPO...
Install the Transfer Valve (cont.) Remove the plaster guard and plated nut from the valve. Do notremove the cartridge. Remove the collar from the brass body. Thread the mounting nut down onto the brass body. Slide the washer onto the brass body until it is flush against themounting nut. Slide the va...