Kohler K-2822-1W-47- Installation Manual
Kohler K-2822-1W-47– Installation Manual, read for free online in PDF format. We hope this helps you resolve any issues you may have. If you have further questions, please contact us through the contact form.
Table of Contents:
- Page 2 – Cast iron lavatories are; Drill
- Page 3 – Install the concrete anchors included.; Existing Construction; Concrete Wall
- Page 4 – Construct the Supports; Bolt
- Page 6 – Install the Lavatory; Cast; CAUTION: Risk of personal injury or product damage.; You; Wall-Mount Bracket Installations
- Page 8 – Guide d’Installation; Lavabo; Outils et matériels; ATTENTION : Risque de blessures corporelles.; Les lavabos en; Perceuse
- Page 9 – Les murs et le sol doivent être d’équerre, d’aplomb, et nivelés.
- Page 10 – Construire le cadre appropriée avec des montants de 2x4.; Construction en béton coulé; Percer des orifices de 3/8; Construction existante; Mur en béton
- Page 11 – Construire les supports; Les étapes suivantes se basent sur un cadrage de; Boulon
- Page 13 – Installer le lavabo; Les lavabos en fonte sont très; Installations support mural
- Page 15 – Guía de instalación; Herramientas y materiales; PRECAUCIÓN: Riesgo de lesiones personales.; Los lavabos de; Taladro
- Page 17 – Taladre orificios de 3/8; Construcción existente; Pared de concreto
- Page 18 – Construya los soportes; Los pasos siguientes suponen que la estructura de postes de; Perno
- Page 20 – Instalaciones de soportes de montaje a la pared
Installation
Guide
Lavatory
M
product numbers are for Mexico (i.e. K-12345
M
)
Los números de productos seguidos de
M
corresponden a México (e.j.
K-12345
M
)
Français, page “Français-1”
Español, pagina “Español-1”
K-2822
1018372-2-B
"Loading the manual" means you need to wait until the file loads and becomes available for online reading. Some manuals are very large, and the time they take to appear depends on your internet speed.
Summary
Thank You For Choosing Kohler Company We appreciate your commitment to Kohler quality. Please take a fewminutes to review this manual before you start installation. If youencounter any installation or performance problems, please don’thesitate to contact us. Our phone numbers and website are listed ...
1. Preparation Existing Construction Remove the existing finished wall and wallboard materials from a36 ″ (91.4 cm) (H) x 24 ″ (61 cm) (W) area at the installation location. Make sure the existing framing is sound and secure.Repair as needed. New Construction Use 2x4 lumber to construct suitable stu...
2. Construct the Supports NOTE: The following steps assume 2x4 stud framing is nominal 3-1/2 ″ (8.9 cm) x 1-1/2 ″ (3.8 cm). Make appropriate rip cut modifications as necessary for other sized lumber. Cut two 2x4 support studs to 36 ″ (91.4 cm). Rip cut these support studs so they are 2-3/4 ″ (7 cm) ...
