Kodak 1C9753 - Manual

Part Number 1C9753

Kodak 10/100

NIC Faceplate

Mode Switches:

D1 and D2 are operation mode switches; they are shown in

Normal

Operation Mode for printing (D1 & D2 Up).

LEDs:

The GREEN LNK connectivity LED should come ON

when connected. The YELLOW NET Traffic LED should blink
intermittently as it detects traffic on the network. Both LEDs
should remain OFF if disconnected from the network.

Ethernet Address:

A unique NIC Ethernet address is assigned to each NIC

(i.e. 0040C8 1234AB). The first six digits are always 00:40:C8. The last six
digits are unique to each NIC.

Network Broadcasts:

The NIC uses its Ethernet address to advertise itself

on Macintosh via Appletalk and on Windows via NetBeui as “KDxxxxxx”
where “xxxxxx” are the last six digits of the address.

NIC Operating Mode Switches

Power cycle the printer whenever you change switch settings. When finished
with configuration, return the switches to

Normal

mode, then power cycle the

printer again for normal printing operation.

Kodak 10/100 NIC Quick ConÞguration

Reference Guide

Applicable printers: Kodak XLS 8400PS, Kodak XLS 8600/8600PS, Kodak
Professional

8657,

Kodak Digital Science

TM

8650/8650 PS color printers,

Kodak Digital Science

TM

desktop color proofer 9000, and

Kodak Digital

Science

TM

DCP 9300 proofer

Kodak p rinter and NIC documentation and software are available on the
Kodak Web site (www.kodak.com).

Important

: This 10/100 NIC is configured using remote, platform specific,

configuration utilities

ONLY

. Configuration parameters entered via the printer

front control panel and the corresponding printer front panel test print are not
applicable to this 10/100 NIC.

D1

D2

Mode

Description

Up

Up

Normal

Default. Does not allow a telnet connection.
Users can print to the unit.

Up

Down

Telnet
Diagnostic

Allows a telnet connection to change its
parameters. Users can also print.

Down

Down

Reset to
Defaults

This setting is used to reset the NIC to use
factory default configuration parameters.
Refer to Appendix C in the User Guide for
details.

Down

Up

Test Page A parameter test page is generated when

you power cycle the printer. Print jobs are
not accepted. NOTE: The printer must be in
PostScript mode. For raster-only printers,
obtain the parameters via a Telnet session.

Kodak

10/100 NIC

Normal

NET

LNK

D1 D2

Kodak 10/100 User Guide References:

Ch1: Introduction/Config Overview

Ch7: Windows NT 3.51

Ch2: NIC Hardware Installation

Ch8: Windows NT 4.0

Ch3: Windows - FastManage

Ch9: Apple/Macintosh

Ch4: Novell Netware

Ch10: Unix

Ch5: Windows for Workgroups

Ch11: Printing

Ch6: Windows 95

Ch12: Troubleshooting

Appendices:

A: Telnet Configuration Utilities

B: 3rd Party Network Applications and Utilities

C: Upgrading NIC Flash Firmware

D: 10/100 NIC Specifications

E: Technical Assistance

-4-