Knoll MVP44a - Manual
Knoll MVP44a – Manual, read for free online in PDF format. We hope this helps you resolve any issues you may have. If you have further questions, please contact us through the contact form.
Table of Contents:
- Page 2 – Key Features; Problem; Installation
- Page 3 – System layout considerations; stereo; Rooms are usually controlled by a MR60 keypad.; The keypads are; The MR60 contains an almost all; Never connect the MVP44a to 2 ohm loads.; 90-00 programming should be fully tested. Occasionally one
- Page 5 – The most important consideration when installing the
- Page 6 – MVP44a Activation
- Page 7 – See the diagram on page 7.
- Page 8 – MVP44a Rear Panel; Outputs; RJ45 plug color and pair wiring guide; MR60 keypad functions; RJ45 plug function identification
In Canada:
11791 Machrina Way #120
Richmond, B.C. V7A 4V3
Knöll Systems
tel (604) 272-4555
fax (604) 272-5595
Knöll Systems, Richmond, BC & Point Roberts WA
C
COPYRIGHT 1998-2003, Knöll Systems, All Rights Reserved
In America:
145 Tyee Drive, #1206
Point Roberts, WA 98281
Four stereo power amplifiers with
individual volume control electronics
and four input source selection
Limited Warranty
Knöll Systems warrants the its electronic products except projectors sold in Canada and the
USA by authorized Knöll dealers to be free from defects in materials and workmanship. This
warranty extends for three full years from the date of purchase by the consumer. Any
products returned freight prepaid to Knöll Systems and found to be defective by Knöll
Systems within the warranty period will be repaired or replaced at Knöll Systems option, at
no charge. Knöll Systems will not be responsible for the actual cost of installation or removal
of the product, nor for any consequential or incidental damages. Some states do not allow the
exclusion or limitation of incidental or consequential damages, so the above limitation or
exclusion may not apply to you. This warranty gives you specific legal rights. You may have
additional rights which vary from state to state. Knöll products sold outside of Canada and
the USA may be covered by warranties provided by an authorized Knöll distributor. Please
contact the distributor in the country that the Knöll product was purchased.
Printed in Canada
Version 3.3
INSTALLATION
MANUAL
MVP44a
systems
Specifications
MVP44a 8 Channel Power Amplifier
Inputs:
4 pairs of gold RCA jacks
Input impedance:
24 k ohms
Outputs:
Gold 5 way Binding posts
Output power:
50 watts RMS per channel (8 ohms)
Peak output power: 100 watts RMS per channel (8 ohms)
Ideal impedance:
6-8 ohms
Freq. response:
10 Hz - 40 kHz +/- 1 dB (1w)
S/N ratio:
over 105 dB A weighted 50 watts
THD distortion:
<0.1% 20 Hz to 20 kHz
IMD distortion
<0.01% 60 Hz 7 kHz 4:1 (SMPTE)
Trigger control:
12VDC output 60mA max.
Power:
750 watts 117 VAC
Dimensions:
17" x 3.5" x 10.5"
Weight:
22 lbs (10 kg)
Operating Temp:
-20C to +60C (-4F to +140F)
Caution:
Never listen to sound that is distorted. If distorted sound
is heard, turn the volume down immediately or speaker
and/or amplifier damage could occur that is not covered by the
warranty. If this problem persists, contact your dealer.
Complies with part 15 of the FCC rules. Operation is subject to:
1. This device may not cause harmful interference
2. This device must accept any interference received
including interference that may cause undesired operation.
It is very important to use a top quality
RJ45 8/8 crimper tool. We strongly
suggest using a cat 5 / RJ45 electronic
tester to verify the wire conductors.
"Loading the manual" means you need to wait until the file loads and becomes available for online reading. Some manuals are very large, and the time they take to appear depends on your internet speed.
Summary
2 Congratulations and thank you for choosing the Knöll MVP44a power amplifier. The MVP44a is designed to meet the amplifier needs of custom installed multi-zone systems where high quality sound is a specific requirement as well as ease of installation and operation. A six output zone model is availa...
System layout considerations The MVP44a is the heart of a whole home music system. A MVP44ais designed to work with 1-4 rooms or zones. Up to three MVP44a'scan be ganged together to allow up to 12 rooms or zones eachindividually controlling one or two pairs of enclosure or inwallspeakers. Connection...
12 5 Installation It is very important to use a top quality RJ45 8/8 crimper tool. We strongly suggest using a cat 5 / RJ45 electronic tester to verify the wire conductors. Installing the MVP44a should be relatively easy. With a bit ofplanning, the MVP44a will give trouble free service for years. 1....
