Klipsch 20M0499 - Manual

Klipsch Limited Warranty KLIPSCH, L.L.C. (“KLIPSCH”) warrants this product to be free from defects in materials and work-manship (subject to the terms set forth below). For a period of five (5) years from the date of purchase,KLIPSCH will repair or replace (at KLIPSCH’s option) this product or any d...

15. Dangerous Entry. Care should be taken that no foreign objects or liquids fall or are spilled inside the device. 16. Damage Requiring Service. The device should be serviced by a Klipsch authorized service center when: -The plug or power supply cord has been damaged.-Objects have fallen or liquid ...

We Want Your Klipsch Product to Look andSound as Good as When it Left the Factory.Please Check Promptly for Transit Damage. Each Klipsch product is individually tested for sonic quality and inspected for superior appearancebefore it leaves the Hope, Arkansas factory. Your loudspeaker left the factor...

Component Specifications KSW 15 Type: 15" bass reflex, tuned port enclosureAmplifier: Peak output power 800 watts into 16 ohms FTC Rated Power: 265 watts into 16 ohms 22-100Hz @ 1% THD maximum Auto Power On: 2 second ON delay, 15 minute OFF delay Frequency Response: 24-120Hz±3dBMaximum Acoustic ...

Figure B KSW 12 INPUT PANEL • Speaker Level Connections at Right / Main Speakers Limited Range• Line Level Connections at Left / Main Speakers Full Range• Optional LFE Connection, Compatible with Speaker and Line Level Hookups —— - - —— • One Channel Shown / Repeat for Opposite Channel

Figure C KSW 15 INPUT PANEL • Line Level Connections / Main Speakers Bass Filtered • Optional LFE Connection, Compatible with Speaker and Line Level Hookups —— - - —— • One Channel Shown / Repeat for Opposite Channel

Subwoofer Placement Your Klipsch subwoofer is designed to operate at frequencies below 120Hz, which are essentiallyomnidirectional (difficult to localize). There may be several options for placement of the subwoofer inyour room that will effect its frequency response and output level. Corner placeme...

Refer to Figure C. Depending upon the setting of the “HIGH PASS SELECT” switch, these outputswill remove frequencies below 50Hz or 100Hz from your main speakers. This type of hookup cre- ates a bi-amplified system, lowering distortion and increasing dynamic range. “LFE IN”/ “BYPASS IN” / KSW 15 ONLY...

“HIGH PASS SELECT” / KSW 15 ONLY This switch selects either “50Hz” or “100Hz” as the bass cutoff frequency for your main speakerswhen using line level connections. Refer to Figure C. This requires that your KSW 15 be connected toa system utilizing both the preamp output and the power amp input jacks...

• If the “HI LEVEL” connections are in use, a polarity reversal of one of the speaker wires coming from your amplifier will result in diminished output from the subwoofer. Refer to “About Speaker Wire Connections.” • If you experience a noticeable hum when the subwoofer is connected to your system, ...