Keurig B60 - Manual

Keurig

®

Brewer De-Scaling Instructions

Brewer Model: Elite B40 | Classic B44
Special Edition B60 | Platinum B70

To begin, you will need the following:
• 48 ounces of undiluted white vinegar
• Large ceramic mug (

do not use a paper cup

)

• Access to an empty sink

PREPARE

Step 1:

Empty the water in the Water Reservoir.

Step 2:

Disable “

Auto Off

” features.

FILL AND CLEAN

Step 1:

Pour approximately 48 ounces of the vinegar

into the Water Reservoir.

Step 2:

Place a large mug on the Drip Tray Plate and

run a brew cycle.

DO NOT USE A K-CUP

, just

press the BREW Button. Pour the contents of

the large mug into the sink.

Step 3:

Repeat the brew process without a K-Cup until

“

ADD WATER

” is indicated.

Step 4:

Now let the Brewer stand for at least 4 hours

while still on.

Step 5:

Discard any residual vinegar and rinse the

Water Reservoir thoroughly.

RINSE

Step 1:

Ensure the Water Reservoir is filled with fresh

water.

Step 2:

Place a large mug on the Drip Tray Plate and

water brew cycle. Pour the contents of the

large mug into the sink.

Step 3:

Repeat brew process until “

ADD WATER

” is

indicated.

Step 4:

You may need to perform additional water brew

cycles if you notice any residual taste.

NOTE:

If “DE-SCALE” is still displayed after

completing the procedure, repeat the

de-scaling procedure above.

Brewer Model: MINI Plus B31

© 2011 Keurig, Incorporated All Rights Reserved.

To begin, you will need the following:
• 20 oz. of undiluted white vinegar
• 12 oz. ceramic mug (

do not use a paper cup

)

• Access to an empty sink

FILL, CLEAN AND RINSE

Step 1:

First Vinegar Rinse

• Fill the Cold Water Reservoir with 10 oz. of undiluted

white

vinegar.

• Place the ceramic mug on the Drip Tray.

• Lift the Brewer Handle, but

DO NOT ADD A K-CUP

.

• After 5 seconds, lower the Brewer Handle.

• Press the flashing blue BREW Button. It will flash

red and then turn solid red.

• Once the vinegar is dispensed, discard hot contents

into

sink.

Step 2:

Second Vinegar Rinse

• Pour the remaining 10 oz. of vinegar into the Cold

Water

Reservoir.

• Place the ceramic mug on the Drip Tray.

• Lift the Brewer Handle, but

DO NOT ADD A K-CUP

.

• After 5 seconds, lower the Brewer Handle.

• Press the flashing blue BREW Button. It will then

flash

red.

• When it turns solid red, power off as it starts to

dispense.

• Allow Brewer to sit for 30 minutes.

• Power on the Brewer, lift and lower Brewer Handle,

then press BREW Button.

• Once the vinegar is dispensed, discard hot contents

into

sink.

Step 3:

Fresh Water Rinse

• Fill the Cold Water Reservoir with 10 oz. of fresh

water.

• Place the ceramic mug on the Drip Tray.

• Lift the Brewer Handle, but

DO NOT ADD A K-CUP

.

• Lower Brewer Handle and continue the brewing

process until the hot water is dispensed into the

mug. Discard hot contents into sink.

• Repeat this cleansing brew process three (3) more

times to cleanse the Brewer plumbing and to

remove any residual vinegar taste. The Brewer is

now ready for normal use again.