Keurig B100 - Manual
Keurig B100 – Manual, read for free online in PDF format. We hope this helps you resolve any issues you may have. If you have further questions, please contact us through the contact form.
Instructions for De-Scaling your Keurig
B100
Home Brewer with Vinegar
a. PREPARE
Step 1:
Make sure you have at least 64 ounces of white vinegar on hand. You will
also need an empty sink and a ceramic mug (do not use a paper cup.)
Step 2:
Turn power “OFF”, unplug Brewer and drain the Brewer following the
instructions below.
DRAINING YOUR KEURIG BREWER
CAUTION: Water is hot, please turn off brewer, unplug it and allow water to
cool before draining.
Step 1:
Make sure Brewer is unplugged! Carry Brewer to sink making sure that it
stays upright.
Step 2:
Remove the Drain Cap on rear of Brewer and, if present, remove Charcoal
Filter from the Water Fill Area.
Step 3:
Rest the rear of the Brewer flat on the counter with the drain positioned
over the sink and allow Brewer to drain. For best results, do not tilt beyond a 90°
angle.
Step 4:
Once water is drained,
replace the Drain Cap
.
b. FILL AND CLEAN
Step 1:
Plug Brewer in and turn power “ON”.
Step 2:
Pour approximately 64 oz of the vinegar into the Brewer until 4 beeps
signal the tank is full.
Step 3:
Wait about 6 – 8 minutes for the vinegar to heat up and the green
“READY” light to go on.
Step 4:
Place a ceramic mug in the Drip Tray and run a brew cycle. DO NOT USE
A K-CUP…just press the Brew button.
Step 5:
Repeat the brew process 4 or 5 times pouring the contents of the mug
back into the Brewer
after each cycle.
Step 6:
Now let the Brewer stand for 4 hours while still on.
Step 7:
Place a ceramic mug on the Drip Tray and run 4 brew cycles, pouring the
contents of the mug
into the sink
after each cycle.
Step 8:
Turn the brewer off, let the remaining vinegar cool, and drain the brewer as
instructed above.
CAUTION:
Vinegar may still be hot. Remember to replace the Drain Cap.
c. RINSE
Step 1:
Fill the brewer with hot tap water.
Step 2:
Power up brewer.
Step 3:
Wait about 6-8 minutes for the water to heat up and the Green “Ready”
Light to go on.
Step 4:
Place a ceramic mug on the Drip Tray and run a brew cycle.
Step 5:
Repeat brew process 4 times for a total of 5 cycles.
Step 6:
Drain the brewer as instructed above.
CAUTION:
Water may be hot. Remember to replace the Drain Cap.
Step 7:
You may need to rinse again to eliminate any residual taste.
For any additional questions regarding your B100 Single Cup Brewer, contact AT HOME
CUSTOMER SERVICE at 1-866-901-BREW (2739).
"Loading the manual" means you need to wait until the file loads and becomes available for online reading. Some manuals are very large, and the time they take to appear depends on your internet speed.
