Kenwood KAC-7251- Manual
Kenwood KAC-7251– Manual, read for free online in PDF format. We hope this helps you resolve any issues you may have. If you have further questions, please contact us through the contact form.
Table of Contents:
- Page 2 – English; Safety precautions; FCC WARNING; Cleaning the unit
- Page 3 – Installation
- Page 4 – Sets the boost level for bass control.; OPERATION switch
- Page 5 – signal is sent to the speaker output.
- Page 6 – Connection; • Stereo Connections:
- Page 8 – CENTER UNIT; RCA cable or Speaker level input connection; Cable Color of the connector
- Page 9 – Battery; Power wire connection; * Commercially available parts
- Page 10 – System examples; Right speaker
- Page 11 – Principle of Tri-mode
- Page 12 – Troubleshooting Guide; PROBLEM
- Page 13 – Specifications; Specifications subject to change without notice.; Audio Section; Rated Power Output; General
KAC-7251
KAC-7201
© PRINTED IN CHINA B64-2569-00/00 (KV/EV)
POWER AMPLIFIER
7
page 2-13
INSTRUCTION MANUAL
AMPLIFICATEUR DE PUISSANCE
7
page 14-25
MODE D’EMPLOI
AMPLIFICADOR DE POTENCIA
7
página
26-37
MANUAL DE INSTRUCCIONES
Take the time to read through this instruction manual.
Familiarity with installation and operation procedures will help
you obtain the best performance from your new power amplifier.
For your records
Record the serial number, found on the back of the unit, in the spaces
designated on the warranty card, and in the space provided below.
Refer to the model and serial numbers whenever you call upon your
KENWOOD dealer for information or service on the product.
Model KAC-7251/7201 Serial number
KAC-7251/7201(KE) 1English 02.11.14 10:30 AM Page 1
"Loading the manual" means you need to wait until the file loads and becomes available for online reading. Some manuals are very large, and the time they take to appear depends on your internet speed.
Other Manuals for Kenwood KAC-7251
Summary
2 English Safety precautions To prevent injury or fire, take the followingprecautions: • When extending the ignition, battery, or ground wires, make sure to use automotive-grade wires or other wires with a 5 mm 2 (AWG 10) or more to prevent wiredeterioration and damage to the wire coating. • To prev...
English 3 Installation • Do not install in the below locations; (Unstable location, In a location that interferes with driving, In a location that gets wet, In adusty location, In a place that gets hot, In a place that gets direct sunlight, In a location thatgets hit by hot air) • Do not install the...
4 English Controls / Indicator 1 2 3 4 5 (W) 20 40 10 1 LPF FREQUENCY control Sets the cutoff frequency when the FILTERswitch is set to LPF. 2 FILTER switch This switch allows to apply high-pass orlow-pass filtering to the speaker outputs. • HPF (High-Pass Filter) position: Only frequencies of 150 H...
