Kanto SUB8VMW - User Manual

Page 2 - Important Safety Precautions; This equipment is Class II; could void the user’s authority to operate the equipment.; Industry Canada Notice:

2 Important Safety Precautions • Read these instructions. • Keep these instructions. • Heed all warnings. • Follow all instructions. • Do not use this apparatus near water. • Clean only with a dry cloth. • Do not block any ventilation openings. Install in accordance with the manufacturer’s instructi...

Page 3 - Introduction; Thank you for choosing the; Power

3 Introduction Thank you for choosing the sub8 sealed powered subwoofer. sub8 was designed to augment the bass performance of your speakers in a stereo setup or in a home theater installation.Adding a subwoofer to your system extends the bass response produced by your existing speakers and improves ...

Page 4 - ” Paper Cone Driver; FRONT PANEL

4 Front & Rear Panels 1 8” Paper Cone Driver 1 FRONT PANEL

Page 5 - REAR PANEL; Volume Knob

5 Front & Rear Panels 2 1 6 7 5 4 3 REAR PANEL 1 Volume Knob 2 Low-Pass Filter Frequency Control3 Standby Power4 Phase Switch 5 Line Level Input 6 ON / OFF Switch 7 AC Input Connection (100 V - 240 V)

Page 6 - Setting Up and Connecting your Subwoofer; very close to room boundaries will enhance; ATTENTION

6 Setting Up and Connecting your Subwoofer Ensure that the ON/OFF Switch is in the OFF position before connecting any component.To some degree, positioning the subwoofer is less critical because it produces only non- directional low-frequency sounds. However, best results are obtained if the subwoof...

Page 7 - Setting up and Connecting your Subwoofer

7 HOME THEATER RECEIVER AMPLIFIER − Volume + OFF U AUX INPUT + - FRONT CENTER COMPONENT AUDIO AUDIO SUB WOOFER VIDEO SURROUND REAR SURROUND R R R L L R L L SPEAKERS L R PRE-OUT SUB WOOFER Sub Out Sub Out Setting up and Connecting your Subwoofer

Page 8 - Audio Troubleshooting Guide; Frequently asked questions about Kanto’s sub8.

8 Audio Troubleshooting Guide Frequently asked questions about Kanto’s sub8. • Ensure the power cable is connected to the subwoofer and power outlet. • Ensure that the power outlet is providing power.• Verify that the power switch on the rear of the subwoofer is in the “On” position. • Check the fus...

Page 10 - Specifications; Woofer

10 Specifications Woofer 8” paper cone Amplifier Type Class D Power Output 300 W peak power (150 W total RMS) Frequency Response 35 Hz – 175 Hz Low-Pass Filter 40 Hz - 120 Hz Phase Switch 0º and 180º Inputs 1 x RCA (L/R) Input Voltage / Frequency AC 100 V - 240 V 50/60 Hz Standby Power Consumption &...

Page 11 - Kanto Audio; HH

11 YU4 YU6 TUK SX26 SP32PL SP26PL SP32PL SP32PL / SP26PL SX22 YU Passive 5.25” YU YU Passive 4” Kanto Audio kantoaudio @kantoaudio Kanto Audio Kanto Living kantoaudio.com SE6 / SE4 / SE2 S6 / S4 / S2 SP6 / SP9HD H2 H1 HH

Page 12 - Limited Warranty to Original Purchaser

www.kantoaudio.com [email protected] Toll Free: 1-888-848-2643 21-F Limited Warranty to Original Purchaser Kanto Living Inc. (Kanto) warrants the equipment it manufactures to be free from defects in material for the limited warranty period of 2 years.If equipment fails because of such defects and Ka...

Kanto SUB8VMW - User Manual

Table of Contents:

Summary