JVC SP-F508 - Manual
JVC SP-F508 – Manual, read for free online in PDF format. We hope this helps you resolve any issues you may have. If you have further questions, please contact us through the contact form.
Table of Contents:
- Page 2 – Preparation; Attaching the base plate
- Page 3 – Connecting the speaker cord; Connection; Connecting the speaker system to the amplifier; Specifications
- Page 5 – Unpacking the speakers; Precautions for unpacking:; Take out the speaker grilles and base plates.; Remove the bottom protection.
LVT1278-001A
[UJ]
SP-F508
SPEAKER SYSTEM
INSTRUCTIONS
Thank you for purchasing a JVC speaker system.
Before you begin using these speakers, please read the instructions carefully to be sure you get the best possible performance.
If you have any questions, consult your JVC dealer.
Warnings, Cautions and Others
7
Precautions for installation
• Do not install the speakers on an uneven surface or in a place
subject to vibration; otherwise, they may fall over, causing
damage or injury.
– Take the occurrence of earthquakes or other
physical shocks into consideration when
selecting the installation place, and secure the
speakers thoroughly.
• To prevent deformation or discoloration of the
cabinet, do not install the speakers where they are
exposed to direct sunlight or high humidity, and
avoid installation near air conditioning outlets.
• Speaker vibrations may cause howling. Place the
speakers as far away from the player as possible.
• The speakers are magnetically shielded to avoid
color distortions on TVs. However, if not installed properly, it
may cause color distortions. So, pay attention to the following
when installing the speakers.
– When placing the speakers near a TV set, turn off the TV’s
main power switch or unplug it before installing the
speakers.
Then wait at least 30 minutes before turning on the TV’s
main power switch again.
Some TVs may still be affected even though you have followed
the above. If this happens, move the speakers further away
from the TV.
• Tuner reception may become noisy or hissing if a speaker is
installed near the tuner. In this case, leave more distance
between the tuner and the speakers or use an outdoor
antenna for better tuner reception without interference from
the speakers.
• Do not lean against the speakers, as the speakers could fall
down or break, possibly causing an injury. Especially be
careful that children do not lean against them.
7
Precautions for daily use
• To maintain the appearance of the speakers
Wipe with a dry, soft cloth if the cabinet should become dirty.
If very dirty, apply a small amount of water or neutral detergent
to the cloth and wipe clean, then wipe with a dry cloth.
• To improve the sound field
– It is recommended to leave a space of more than 50 cm
between the speakers and the wall.
– If the speakers are facing a solid wall or glass
door, etc., it is recommended to furnish the wall
with materials that absorb sounds, for example
by hanging up thick curtains, to prevent
reflections and standing waves.
• To use the speakers without any trouble
– Do not reproduce sounds at so high a volume that they are
distor ted; otherwise, the speakers may be damaged by
internal heat buildup.
– When moving the speakers, do not pull the speaker cords;
otherwise, the speakers may fall over, causing damage or
injury.
7
Checking the supplied accessories
• Base plates (2)
• Speaker grilles (2)
• Speaker cords (4 m, 2)
• Screws (M4 x 20 mm, 8)
If any item is missing, contact your dealer immediately.
SP-F508[UJ]f.p65
04.7.26, 4:10 PM
3
"Loading the manual" means you need to wait until the file loads and becomes available for online reading. Some manuals are very large, and the time they take to appear depends on your internet speed.
Summary
Preparation 7 Attaching the base plate To prevent the speaker from falling over, be sure to attach thesupplied base plate to each speaker. • Take care not to drop the base plate or speaker while assembling; otherwise, it may cause damage to the floor orinjury. • Ensure enough space for assembly and ...
RIGHT LEFT 7 Connecting the speaker cord Connect the speaker cord to the speaker as illustrated. • Make sure to match the polarity ( ª and · ); otherwise, the surround effect will become less effective. Connection 7 Connecting the speaker system to the amplifier Before connection— • Turn off the pow...
Unpacking the speakers Speaker cords and screws LV44076-001A [UJ] 3 Take out the speakers with its protections (at topand bottom), then stand them upright with topside down. Precautions for unpacking: • Have two persons unpack for safe unpacking and installation. • Place a large, thick cloth on the ...