JVC KD-R412 - Manual

5 ENGLISH Basic operations Control dial Ejects the disc Loading slot Remote sensor (for KD-R412/KD-R411)You can control this unit with an optionally purchased remote control, RM-RK50 ( 12). Display window Auxiliary input jack Detaches the panel When you press or hold the following button(s)... Butto...

6 ENGLISH Manual search [Hold] “M” flashes, then press the button repeatedly. When an FM stereo broadcast is hard to receive 1 2 ] <TUNER> ] <MONO> ] <MONO ON>Reception improves, but stereo effect will be lost. To restore the stereo effect, repeat the same procedure to select <M...

7 ENGLISH Manual presetting (FM/AM) You can preset up to 18 stations for FM and 6 stations for AM. Ex.: Storing FM station of 92.50 MHz into preset number “04.” 1 ] “92.50MHz” 2 “PRESET MODE” flashes. 3 ] Selects preset number “04.” “P04” flashes and “MEMORY” appears. Selecting a preset station or 1...

8 ENGLISH Stopping playback and ejecting the disc “NO DISC” appears.Press / SOURCE to listen to another playback source. Listening to a disc ~ ] Turn on the power. Ÿ All tracks will be played repeatedly until you change the source or eject the disc. Prohibiting disc ejection To cancel the prohibitio...

9 ENGLISH Selects folder of the MP3/WMA Selects track Fast-forwards or reverses the track Selecting a track/folder 1 2 For MP3/WMA discs, select the desired folder, then the desired track by repeating step 2 . • To return to the previous menu, press BACK . Caution on volume setting: Discs produce ve...

10 ENGLISH Listening to the USB device (For KD-R412/KD-R411/KD-R35) This unit can play MP3/WMA tracks stored in a USB device. ~ ] Turn on the power. Ÿ All tracks will be played repeatedly until you change the source or detach the USB device. If a USB device has been attached... Pressing / SOURCE tur...

11 ENGLISH Listening to the other external components You can connect an external component to the AUX (auxiliary) input jack on the control panel. Preparation: Make sure <AUX ON> is selected for the <SRC SELECT> = <AUX IN> setting. ( 16) • For details, refer also to the instructio...

12 ENGLISH 1 • Turns the power on if pressed briefly. When the power is on, pressing the button also mutes the sound or pauses. To cancel muting or resume playback, press the same button again. • Turns the power off if pressed and held. 2 • Changes the preset stations. • Changes the folder of the MP...

13 ENGLISH Selecting a preset sound mode You can select a preset sound mode suitable for the music genre. FLAT = NATURAL = DYNAMIC = VOCAL BOOST = BASS BOOST = USER = (back to the beginning) While listening, you can adjust the tone level of the selected sound mode. 1 2 Adjust the level (–06 to +06) ...

17 ENGLISH More about this unit Basic operations General • If you turn off the power while listening to a track, playback will start from where it had been stopped previously next time you turn on the power. • If no operation is done for about 60 seconds after pressing MENU button, the operation wil...

18 ENGLISH • Some CD-Rs or CD-RWs may not play back on this unit because of their disc characteristics, or for the following reasons: – Discs are dirty or scratched. – Moisture condensation has occurred on the lens inside the unit. – The pickup lens inside the unit is dirty. – The files on the CD-R/...

19 ENGLISH Playing MP3/WMA tracks from a USB device (for KD-R412/KD-R411/KD-R35) • While playing from a USB device, the playback order may differ from other players. • This unit may be unable to play back some USB devices or some files due to their characteristics or recording conditions. • Dependin...

20 ENGLISH To keep discs clean A dirty disc may not play correctly. If a disc does become dirty, wipe it with a soft cloth in a straight line from center to edge.• Do not use any solvents (for example, conventional record cleaner, spray, thinner, benzine, etc.) to clean discs. To play new discs New ...

21 ENGLISH Troubleshooting Symptom Remedy/Cause General Sound cannot be heard from the speakers. • Adjust the volume to the optimum level.• Make sure the unit is not muted/paused ( 5). • Check the cords and connections. “PROTECT” appears on the display and no operations can be done. Check to be sure...

24 ENGLISH Specifications AUDIO AMPLIFIER SECTION Maximum Power Output: Front/Rear: 50 W per channel Continuous Power Output (RMS): Front/Rear: 19 W per channel into 4 Ω, 40 Hz to 20 000 Hz at no more than 0.8% total harmonic distortion. Load Impedance: 4 Ω (4 Ω to 8 Ω allowance) Tone Control Range:...

FRANÇAIS ENGLISH GET0624-003A [E/EU] EN, FR 1009DTSMDTJEIN © 2009 Victor Company of Japan, Limited For canceling the display demonstration, see page 4. / Pour annuler la démonstration des affichages, référez-vous à la page 4. CD RECEIVER / RÉCEPTEUR CD KD-R412 / KD-R411 /KD-R35 / KD-R312 / KD-R311 I...

1 KD-R418 CD RECEIVER : INSTRUCTIONS/INSTALLATION 1009DTSMDTJEIN EN© 2009 Victor Company of Japan, Limited GET0632-001A [J] 1 Turn on the power. 2 3 Canceling the display demonstration 4 Select < DEMO OFF >. 5 6 Finish the procedure. Setting the clock 1 Turn on the power. 2 3 Select < CLOCK...

2 Listening to the radio ~ ] “FM” or “AM” Ÿ “ST” lights up when receiving an FM stereo broadcast with sufficient signal strength. Manual search “M” flashes, then press the button repeatedly. When an FM stereo broadcast is hard to receive 1 2 ] <TUNER> ] <MONO> ] <MONO ON> Reception...

4 Installation This unit is designed to operate on 12 V DC, NEGATIVE ground electrical systems . If your vehicle does not have this system, a voltage inverter is required, which can be purchased at JVC car audio dealers. Prepare these before installation.... Warnings • To prevent short circuits: – D...

6 Specifications AUDIO AMPLIFIER SECTION Power Output: 20 W RMS × 4 Channels at 4 Ω and ≤ 1% THD+N Signal-to-Noise Ratio: 80 dBA (reference: 1 W into 4 Ω) Load Impedance: 4 Ω (4 Ω to 8 Ω allowance) Tone Control Range: Bass: ±12 dB (60 Hz, 80 Hz, 100 Hz, 200 Hz) Q1.0, Q1.25, Q1.5, Q2.0 Middle: ±12 dB...

3 1 2 3 Repeat step 2 if necessary. • To return to the previous menu, press BACK . • To exit from the menu, press DISP or MENU . Category Menu item Selectable setting, [ Initial: Underlined ] DEMO DEMO • DEMO ON • DEMO OFF : Display demonstration will be activated automatically if no operation is do...

5 – EN Specifications AUDIO AMPLIFIER SECTION Power Output: 20 W RMS × 4 Channels at 4 Ω and ≤ 1% THD+N Signal-to-Noise Ratio: 80 dBA (reference: 1 W into 4 Ω) Load Impedance: 4 Ω (4 Ω to 8 Ω allowance) Tone Control Range: Bass: ±12 dB (60 Hz, 80 Hz, 100 Hz, 200 Hz) Q1.0, Q1.25, Q1.5, Q2.0 Middle: ±...

6 – EN Installation The following illustration shows a typical installation. If you are not sure how to install this unit correctly, contact your JVC car audio dealer or a company supplying kits. See “Electrical connections” below. Removing the unit Release the rear section first... 8 mm (3/8") ...