John Lewis JLDW 1225 - Manual

Description of the appliance 1. Upper basket2. Water hardness dial3. Salt container4. Detergent dispenser5. Rinse aid dispenser6. Rating plate7. Filters8. Lower spray arm9. Upper spray arm10. Worktop Visual signal • When the washing programme starts, a red visual signal shows on the floorbeneath the...

Control panel The controls are on the top on thecontrol panel. To operate with thecontrols, keep the appliance doorajar. 7 1 8 9 10 1. On/off button2. Programme guide3. Display4. Delay start button5. Programme buttons6. Energy save button7. Multi tab button8. Reset button9. Indicators10. Function bu...

• To activate or deactivate the rinse aid dispenser (only with the Multi tab functionactivated). • To activate or deactivate the acoustic signals. Switch on the appliance. Theappliance is in setting mode when: • The display shows two horizontal status bars. Switch on the appliance. Theappliance is n...

Programme Programme time(minute) Energy (kWh) Water (litre) 555° One hour 50 - 60 1.0 - 1.2 10 - 11 645° Glass 65 - 75 0.8 - 0.9 11 - 12 7Rinse hold 14 0.1 4 The consumption values are intendedas a guide. They depend on thepressure and the temperature of thewater, on the variations of the powersuppl...

4. Close the rinse aid dispenser. Press the lid until it locks into position. Adjusting the rinse aiddosage The factory set in position 3. You can set the rinse aid dosage betweenposition 1 (lowest dosage) and position 4(highest dosage).Turn the rinse aid selector ( 2 ) to increase or reduce the dos...

For washing in the dishwasher the following cutlery and dishes are not suitable: are of limited suitability: • Cutlery with wooden, horn, china or mother- of-pearls handles. • Plastic items that are not heat resistant.• Older cutlery with glued parts that are not temperature resistant. • Bonded cutl...

34 cm 9 x XXL 9 x 34 cm The cutlery basket Warning! Knives with long blades, stored in an upright position, are apotential hazard. Long and/or sharpitems of cutlery such as carving knivesmust be positioned horizontally in theupper basket. Take care whenloading or unloading sharp items suchas knives....

Caution! Ensure that the spray arms can rotate freely before you close theappliance door. Adjusting the height ofthe upper basket To load very large plates move the upperbasket to the higher position. 24 cm 28 cm 30 cm 28 cm 25 cm 21 cm 22 cm 34 cm Moving the upper basket to thehigher position 1. Pu...

Fill with detergent 20 30 MA X 1 2 3 4 + - 1. Press the release button ( 2 ) to open the lid ( 3 ) of the detergent dispenser. 2. Put the detergent in compartment ( 1 ). 3. If the washing programme has a prewash phase, put a small quantity of detergenton the inner side of the appliance door. 4. If y...

2. Press the delay start button until the display shows the number of theselected washing programme.• The programme number flashes for a few seconds and then the time of thewashing programme comes on. 3. Close the appliance door. The washing programme starts automatically. Warning! Interrupt or canc...

• Water may appear on the sides and the door of the appliance as the stainless steelwill eventually become cooler than thedishes. Maintenance and cleaning Cleaning the filters The filters must be checked and cleanedfrom time to time. Dirty filters will degradethe washing result. Warning! Before clea...

C 9. Put the filter ( A ) into position in filter ( B ). Turn the filter ( A ) clockwise until it locks. Caution! Never use the appliance without filters. Incorrectrepositioning and fitting of the filterswill produce poor washing resultsand will result in damage to theappliance. Spray arms Caution! ...

Something not working The appliance does not start or it stopsduring operation.Certain problems are due to the lack ofsimple maintenance or oversights, which canbe solved with the help of the indicationsdescribed in the table, without calling out anengineer. With some malfunctions, the displayshows ...

Technical data Dimensions Width 596 mm Height 850 mm Depth 597 mm Water supply pressure Minimum 0.5 bar (0.05 MPa) Maximum 8 bar (0.8 MPa) Electrical connection Information on the electrical connection (voltage, overall powerand fuse) is given on the rating plate on the inner edge of theappliance do...

Removing the appliance worktop 1. Remove the appliance worktop by unscrewing the two rear retainingscrews (1) 2. Pull the worktop from the back of the appliance (2). 3. Lift the worktop (3) and slide it out of the front slots. Insert the appliance once the levelling hasbeen done.When inserting the a...

Water connection Water inlet connection This appliance may be fed with either hot(maximum 60 °C) or cold water.Nevertheless we advise you use a coldwater supply. A hot water supply is notalways efficient with heavily soiled crockeryas it shortens the washing programmes a lot.For making the connectio...

Electrical connection The manufacturer accepts no liabilityfor failure to observe the followingsafety precautions. Warning! Safety standards require the appliance to be earthed.Prior to using the appliance for thefirst time, ensure that the ratedvoltage and type of supply on therating plate match th...

Repairs - after sales service Your appliance comes with a three yearwarranty. If it is not working correctly referto "Something not working". If a fault occurswhich you can not resolve through followingthe advice and information contained withinthis instruction manual, the next step is tocon...