John Lewis JLBIWM 1402 - Manual

5 Description of the appliance 1 Detergent dispenser drawer 2 Control panel 3 Door handle 4 Rating plate 5 Filter 6 Adjustable feet Detergent dispenser drawer Prewash Main wash Fabric softener Child safety feature This machine incorporates a special child safety featureto prevent small children from...

6 1 Programme selector dial The programme selector dial is divided into thefollowing sections: • Cottons, • Synthetics,• Delicates• Wool / Hand washing • Special programmes from “ Soak ” to “ 30 Minute wash ” • Reset/Off programme Off The selector dial can be turned either clockwiseor anticlockwise....

7 Rinse hold: when you choose this option, the machine will not drain the water of the last rinse, thiswill ensure the minimum of creasing to laundry. At the end of the cycle, the lights corresponding to theoptions “ Rinse hold ” and the “ Door lock ” are on, the “ Start/Pause ” button light goes ou...

9 Using the washing machine Before the first wash, run a cotton cycle at 90°C,without any laundry in the machine, to remove anymanufacturing residue from the drum and tub. Pour 1/2a measure of detergent into the main compartment ofthe dispenser drawer and start the machine . WASHING 6 KG OF WHITE CO...

11 will show a flashing zero. The “ Door lock ” light is on. Before starting a new washing phase, it is necessary toempty the water by selecting the “ Drain ” programme. This programme cannot be used for very delicate fabrics as silk or wool. Rinse With this programme it is possible to rinse and spi...

12 Hints & tips on washing Do NOT overload the machine. Weigh the laundry the first few times you use the appliance. The average weights of the most common items arelisted below as a guide: 1000g = 1 kg Sheet 700-1000 g Pillow case 100-200 g Tablecloth 400-500 g Serviette 50-100 g Tea towel 70-1...

13 Wash care symbols Wash care labels inside garments recommend how to launder your clothes with the best results. The care labellingcode is in line with care labelling used in the rest of Europe. The symbols used make it easy to select the correctprogramme on your washing machine. WASHING SYMBOL BL...

14 Washing programmes The “ Economy Cottons 60° ” with a load of 6 kg, is the reference programme for the data entered in the energy label, in compliance with EEC 92/75 standards. * This data is given purely as an indication: the consumption values may vary in relation to the quantity and typeof lau...

17 • When no more water comes out, unscrew the pump cover and remove it. Always keep a rag nearby to dryup spillage of water when removing the cover. • Remove any objects from the pump impeller byrotating it. • Refit the cap on the emergency emptying hose and place the latter back in its seat. • Scr...

18 Something not working Please carry out the following checks before contacting your local Service Force agent. IMPORTANT: If you call out an engineer to a fault listed below, or to repair a fault caused byincorrect use or installation, a charge will be made even if the appliance is under guarantee...

19 Symptom The door will not open Solution ● The water level is too high. ● The machine is heating the water. ● The drum is turning. ● The Door pilot light is still on. Spinning starts late or themachine does not spin ● The electronic balance control device has cut in because the laundry isnot evenl...

21 21 Unpacking All transit bolts and packing must be removed before using the appliance. Keep all packaging away from children. You are advised to keep all the transit bolts for re-usein case the machine is to be transported again. After removing all the packaging, with assistancecarefully lay mach...

22 The appliance has an inlet hose, with female 3/4” BSPthread connector. If this connection is not compatiblewith the plumbing of the existing installation, a varietyof connectors are available from good hardware storesand plumbers merchants to suit most domesticplumbing. Any alteration to your exi...

23 If your drain hose looks like this (see below) you donot require the “U” piece”. Just push the hose firmlyinto the standpipe. 2. Onto a sink outlet spigot. If the outlet spigot has not been used before, removeany blanking plug that may be in place. Push the drain hose onto the spigot and secure w...

24 Electrical connection Any electrical work required to install this applianceshould be carried out by a qualified electrician orcompetent person. WARNING: THIS APPLIANCE MUST BEEARTHED. The manufacturer declines any liability should this safety measure not beobserved. Should the appliance power su...

27 In the event of your appliance requiring service, or ifyou wish to purchase spare parts, please contact ourextended warranty administrators by telephoning: 0870 01 07887 They will give you details for your local Service ForceCentre. Service Force are the appointed nationalappliance repair agents ...