JL Audio FS110-W5 - Manual

1. Unpack the FS110-W5 and

determine where it will be

mounted. Consider access to the

opposite side of the mounting

surface for securing mounting

bolts and visual confirmation

you are not drilling through any

wires, hoses or even the hull of

the vessel. In addition, consider

the structural integrity of the

mounting surface itself and that

installation does not interfere with

water drainage, hatch lids, or any

moving parts on the vessel.

2. Using a Phillips-head screwdriver,

remove the 3 Stainless-Steel screws

that mount the woofer to the

enclosure and remove the woofer.

3. Mark the enclosure for the

location of the mounting holes.

There should be at least 2

mounting bolts used to secure the

enclosure (3 or more mounting

bolts are recommended for extra

strength and stability). On the

inside of the enclosure, ensure

there is ample room around the

mounting points for the mounting

hardware (not included).

4. In addition to the mounting holes,

one additional hole must be

marked for the entry of the speaker

wire into the enclosure. For this

hole, consider the most clean and

protected wire run (this may mean

the top or back of the enclosure).

5. Drill a pilot hole into the

enclosure at each of the marks

made in Step 3. Enlarge each

pilot hole to the appropriate

diameter, as dictated by the

mounting hardware and speaker

cable used.

6. Once all of the holes are drilled

through the enclosure, hold it

in the exact mounting location

determined in Step 1. Using the

holes drilled in Step 5 as a guide,

mark the mounting surface so

that corresponding enclosure

mounting holes can be drilled.

7. At each mark made in Step 6, drill

pilot holes and then appropriately-

sized mounting holes into the

mounting surface.

8. Run the wire into the enclosure

leaving 18" within the enclosure

so that the woofer can be easily

wired and mounted. Fill the hole

through which the wire is run

with silicone caulk to both seal

the enclosure and protect the

wire from abrasion.

9. Securely mount the enclosure

using the mounting hardware and

seal the enclosure at the mounting

holes with a silicone caulk.

10. Make the terminal connections to

the woofer observing the correct

polarity and set the woofer in the

enclosure’s woofer mounting hole.

Orient the woofer’s logo so it is

appropriate for the installation

and so that each of the woofer’s

mounting holes line up with the

pre-drilled holes in the enclosure.

Re-mount the woofer using the

3 Stainless-Steel screws removed

in Step 2 and the 3 additional

Stainless-Steel screws included

with the enclosure.

11. You have completed the

installation of your FS110-W5.

Enjoy your new Enclosed Marine

Subwoofer System.

For questions concerning installation of

this product, contact JL Audio Technical

Support during regular business hours at

(954) 443-1100.

The FS110-W5 is designed to be a universal-application Subwoofer

System. The exact mounting procedure employed will vary based

on the requirements of the installation. The steps outlined in these

instructions take most considerations into account and should be

read thoroughly prior to beginning your installation.

FS110-W5

Installation Instructions

(all models)

SKU#011292_02_09

Reccomended Hardware/Mounting

(Stainless-Steel)

ENCLOSURE WALL

MOUNTING SURFACE

Fender Washer

Fender Washer

Lock Washer

Hex Nut

Hex Head Bolt

Silicone Sealant