JL Audio 300w - Manual
JL Audio 300w – Manual, read for free online in PDF format. We hope this helps you resolve any issues you may have. If you have further questions, please contact us through the contact form.
Table of Contents:
- Page 2 – JL AUDIO
- Page 3 – Power ConneCtions; ” and “; Fuse requirements; Disconnect the negative battery post; JL AUDIO
- Page 4 – JL AUDIO
- Page 5 – JL AUDIO
- Page 6 – 0 JL AUDIO
- Page 7 – Precise Frequency Selection Chart; “Filter Freq” amP Filter; Recommended Fuse Value:; midrange application). Do not use attenuated; target aC Voltage; 2 JL AUDIO
- Page 8 – 4 JL AUDIO
- Page 11 – (do not send product for repair to this address); international warranties:; by that country’s distributor and not by JL Audio, Inc.
Thank you for purchasing a JL Audio amplifier for
your automotive sound system.
Your amplifier has been designed and manufactured to exacting
standards in order to ensure years of musical enjoyment in your vehicle.
For maximum performance, we highly recommend that you have
your new amplifier installed by an authorized JL Audio dealer. Your
authorized dealer has the training, expertise and installation equipment
to ensure optimum performance from this product. Should you
decide to install the amplifier yourself, please take the time
to read this manual thoroughly so as to familiarize yourself
with its installation requirements and setup procedures.
If you have any questions regarding the instructions in this
manual or any aspect of your amplifier’s operation, please contact your
authorized JL Audio dealer for assistance. If you need further assistance,
please call the JL Audio Technical Support Department
at (954) 443-1100 during business hours.
owner’s manual
"Loading the manual" means you need to wait until the file loads and becomes available for online reading. Some manuals are very large, and the time they take to appear depends on your internet speed.
Summary
Planning Your installation It is important that you take the time to read this manual and that you plan out your installation carefully. The following are some considerations that you must take into account when planning your installation. Cooling efficiency Considerations: The outer shell of your J...
Power ConneCtions Before installing the amplifier, disconnect the negative (ground) wire from the vehicle’s battery. This will prevent accidental damage to the system, the vehicle and your body during installation. The G1300’s “ +12VDC ” and “ Ground ” connections are designed to accept 8 AWG - 4 AW...
inPut Voltage range: A wide range of signal input voltages can be accommodated by the G1300’s input section (200mV – 8V). This wide range is split up into two sub-ranges, accessible via a switch located to the left of the Input Connectors. The “ Low ” position on the “ Input Voltage ” switch selects...
