Jet M-708448 - Manual - manualsarea.com

Page 3 - WARNING

3 WARNING 1. Read and understand the entireinstruction manual before attemptingassembly or operation. 2. This sander is designed and intended foruse by properly trained and experiencedpersonnel only. If you are not familiarwith the proper and safe operation of asander, do not use until proper traini...

Page 4 - Grounding Instructions; Repair or replace a damaged or worn cord immediately.

4 Grounding Instructions Caution: This tool must be grounded while in use to protect the operator from electric shock. In the ev ent of a malfunction or breakdown, grounding prov ides a path of least resistance for electriccurrent to reduce the risk of electric shock. This tool is equipped with an e...

Page 6 - Table of Contents

6 Specifications: EHVS-80CS Stock Number................................................................................................................................ 708448Fence ..........................................................................................................................

Page 8 - Assembly; Main unit is heavy! Use great care and

8 Assembly 1. Remov e all contents from the shippingcontainer. 2. Clean all rust protected surfaces with a mildsolv ent. Do not use paint or lacquer thinner,gasoline, or mineral spirits; these will damage painted surfaces. 3. Attach the four rubber pads (A, Fig. 1) to thebottoms of the side panels w...

Page 10 - Removing the belt guard exposes more of; Horizontal Sanding; The fence can be secured in place by; Vertical Sanding; Adjust; Contour Sanding; The end guard should; Sanding Platen Angle Adjustment

10 WARNING Removing the belt guard exposes more of the sanding belt! Replace the belt guards immediately after completing any sanding that requires it’s removal! Failure to comply may cause serious injury! Horizontal Sanding W ith the sanding platen locked in the horizontalposition, the remov able f...

Page 12 - Motor Mount Tracking Adjustment

12 3. Insert the driv er with the round shaft,supplied with the machine into the microadjusting nut (A, Fig. 11) and turn awayfrom you to loosen. 4. Turn the micro adjusting screw (B, Fig. 11)in ¼ turn increments until the belt tracksev enly on the rollers when rotated by hand. 5. Tighten the micro ...

Page 13 - Table Adjustment; Troubleshooting

13 Table Adjustment WARNING Do not position table below sanding belt! Keep an overlap of at least 1/16” between table and sanding belt to avoid material and/or fingers getting caught! Failure to comply may cause serious injury! 1. Loosen two lock knobs (A, Fig. 13). 2. Raise or lower work table to d...

Page 14 - Table and Motor Assembly

Page 15 - Parts List For The EHVS-80CS Sander

15 Parts List For The EHVS-80CS Sander Table and Motor Assembly Index Part No. No. Description Size Qty. 1 .......... EHVS80CS-01 ................. Base .............................................................. ................................. 12 .......... 994532 ................................

Page 18 - Stand Assembly; Index

18 Stand Assembly Index Part No. No. Description Size Qty. 1 .......... TS-0680031 ..................... Flat W asher................................................... 5/16” ......................... 222 .......... TS-0720081 ..................... Lock W asher .........................................

Jet M-708448 - Manual

Table of Contents:

Summary

Other Jet Models