Jet DC-650CRC - Manual - manualsarea.com

Page 2 - Warranty and Service

2 This manual has been prepared for the owner and operators of the JET DC-650 Series Dust Collectors. Its purpose, aside from machine operation, is to promote safety using accepted operating and maintenance procedures. To obtain maximum life and efficiency from your dust collector and to aid in usin...

Page 3 - Table of Contents

3 Table of Contents Warranty and Service ........................................................................................................................................... 2 Table of Contents.......................................................................................................

Page 6 - DC-650 Series Dust Collector

6 Introduction This manual is provided by JET covering the safe operation and maintenance procedures for models DC-650 Series Dust Collectors. This manual contains instructions on installation, safety precautions, general operating procedures, maintenance instructions and parts breakdown. This machi...

Page 7 - Unpacking; Contents of the Shipping Carton

7 Unpacking 1. Remove all contents from the shipping carton. 2. Report any damage to your distributor. 3. Do not discard any shipping material until after the dust collector has been assembled and is running properly. Contents of the Shipping Carton DC-650A Contents 1 – Base 1 – Owner's Manual 1 – W...

Page 8 - Assembly; Motor Housing and Support Canister

8 Assembly The dust collector must be disconnected from the power source during assembly. Failure to comply may result in serious injury! Motor Housing and Support Canister 1. Place the impeller housing (A, Fig. 1) on the floor with the motor (B, Fig. 1) facing upwards as shown. 2. Attach the fan (C...

Page 9 - Collector Bag Installation – DC-650A/ARC

9 Filter Bag Installation – DC-650A/ARC 1. Thread an M6 hex nut onto the filter bag support rod, followed by an M6 flat washer and M6 lock washer (A, Fig. 5). Thread the support rod (B, Fig. 5) into the motor/fan housing and tighten nut against the housing. 2. Place the retaining strap (C, Fig. 5) t...

Page 10 - Collector Bag Installation – DC-650C/CRC

10 Canister Installation – DC-650C/CRC 1. Place the canister filter so that it fits snugly over the housing and tighten the four knobs (A, Fig. 7). 2. Mount handle (B, Fig. 7) to the arm (C, Fig. 7) with a M8 flat washer (D, Fig. 7), M8 lock washer (E, Fig. 7), and a M8 hex nut (F, Fig. 7). 3. Threa...

Page 11 - Turning the Machine On & Off; Setting the Timer

11 Electrical Connections All electrical connections must be done by a qualified electrician. All adjustments or repairs must be done with the dust collector disconnected from the power source, unplugged. Failure to comply may result in serious injury! The DC-650 series dust collectors are rated at ...

Page 12 - Maintenance

12 Maintenance Never perform maintenance on this machine before turning switch off and removing plug from power source. Failure to comply may cause serious injury! Cleaning the Filter Bag – DC-650A/ARC Wearing a particle mask/respirator for protection against fine dust particles during cleaning is h...

Page 13 - Parts; Replacement Parts

13 Parts Replacement Parts Replacement parts are listed in the Parts List on the following pages. To order parts or reach our service department, call 1-800-274-6848 between 7:00 a.m. and 6:00 p.m. (CST), Monday through Friday. Having the Model Number and Serial Number of your machine available when...

Page 15 - Parts Breakdown

15 Parts Breakdown for DC-650C/CRC Models for DC-650A/ARC Models

Page 17 - Wiring Diagrams

Page 19 - Notes