Jet DC-1100MK - Manual - manualsarea.com

Page 2 - Warranty and Service

2 Warranty and Service Walter Meier (Manufacturing) Inc., warrants every product it sells. If one of our tools needs service or repair, one of our Authori zed Service Centers located throughout the Unite d States can give you quick service. In most cases, any of these Walter Meier Authori zed Servic...

Page 3 - Table of Contents

3 Table of Contents Warranty and Ser vice .................................................................................................................................2 Table of Contents ................................................................................................................

Page 5 - Introduction

5 20. Make your workshop child proof with padlocks, master switches or by removing starter keys. 21. Give your work undivided attention. Looking around, carrying on a conversation and “ horse-play” are careless acts that can result in serious injury. 22. Do not use the dust collector for anyt hing e...

Page 6 - Specifications

6 Specifications DC-1100BK (Base Machine with 30 Micron Filter Bag Kit) ..............................................................708636K DC-1100MK (Base Machine with 5 Micron Filter Bag Kit)............................................................. 708636MK DC-1100CK (Base Machine with Canis...

Page 7 - Unpacking; Shipping Content; Base Unit

7 Unpacking The table below lists the shipping cartons that are included with the models of the DC-1100 Dust Collector. 1. Locate your particular model and verify that you have received all of the correct cartons. 2. Check contents of each carton against the s hip- ping content listings on this and ...

Page 8 - Canister Filter Kit; 0-Micron Bag Filter Kit; -Micron Bag Filter Kit

8 Canister Filter Kit (SN 708639B) 1 – Handle (O) 1 – Canister Filter (P) 1 – Snap Ring (Q) 5 – Collector Bags (R) 1 – Canister Filter Hardware Bag (SN DC1100-CHP) Contains: (2) M10 Hex Nuts (S) (2) M10 Flat Washers (T) (1) M10 Lock Washer (U) (4) Knobs (V) Canister Filter Kit Contents Canister Filt...

Page 9 - Base Unit Assembly; Base; Connector Housing

9 Base Unit Assembly Base 1. Install four casters to the underside of the base as pictured in Fig. 2. Referring to Figure 1: 2. Thread the hex nut (B) onto the caster shaft. Then slide the lock washer (A) over the caster shaft. Thread t he caster shaft into the t hreaded hole on the underside of the...

Page 10 - Hose

10 6. Install the housing (A, Fig. 5) to two support legs (B, Fig. 5) using four M8 x 16 hex cap bolts, eight M8 flat washers, and four M8 hex nuts (C, Fig. 5). Be sure hose opening faces fan housing. Note: For filter bag models only – Before attaching third s upport bracket place the hanger bracket...

Page 11 - Filter Bag Kit Assembly; Filter Bag Installation

11 Filter Bag Kit Assembly If you purchased a DC-1100BK, or DC-1100MK Dust Collector, this section describes the assembly and installation of the contents of the Filter Bag Kit (SN 708636F or 708636MF). Filter Bag Installation Referring to Figure 7: 1. Place the hanger (A) on the hanger bracket (B)....

Page 12 - Canister Kit Assembly; Canister Filter; Collector Bag

12 Canister Kit Assembly If you purc hased Model DC-1100CK Dust Collector, this section describes the assembly and installation of the contents of the Canister Kit (SN 708639B). Canister Filter 1. Mount the handle onto the canister filter with two M10 hex nuts, two M10 flat washers, and a M10 lock w...

Page 13 - Electrical Connections; Turning the Machine On & Off; All Models

13 Electrical Connections All electrical connections must be done by a qualified electrician. All adjust ments or repairs must be done with the dust collector disconnected from the power source, unplugged. Failure to comply may result in ser ious injury! The DC-1100 dust collectors (all models) are ...

Page 14 - Changing Operating Frequency

14 Changing Operating Frequency If several devic es are controlled by the same type remote control unit, each remote control unit can be set to operate at its’ own unique operating frequency as follows: Referring to Figure 14: 1. Unplug t he DC-RC Remote Power Control unit. 2. Remove the back covers...

Page 15 - Maintenance; Removing the Collector Bag–DC-1100BK; Motor

15 Maintenance Never perform maintenance on this machine before turning switch off and removing plug from power source. Failure to comply may cause serious injury! Cleaning the Filter Bag – DC-1100BK and DC-1100MK Wearing a particle mask or respirator for protection against fine dust particles dur i...

Page 16 - Parts Breakdown – DC-1100 Dust Collectors

Page 17 - Parts List – DC-1100 Dust Collectors

17 Parts List – DC-1100 Dust Collectors Ordering Replacement Parts To order parts or reach our ser vice department, call 800-274-6848, Monday t hrough Friday (see our website for bus iness hours, www.waltermeier.com). Having t he Model Number and Serial Number of your mac hine available when you cal...

Page 21 - Wiring Diagram – DC-1100 Dust Collectors

Jet DC-1100MK - Manual

Table of Contents:

Summary

Other Jet Models