Jet 719T WMH - Manual

7 Unpacking Remove mortiser and stand from the shipping cartons. Check for damage and ensure all parts are intact. Any damage should be reported immediately to your distributor and shipping agent. Read the manual thoroughly to familiarize yourself with the correct assembly and maintenance procedures...

8 Assembly Do not connect the machine to power source until completely assembled. Read and understand the entire manual. Securing Machine to Stand The mortiser should be secured to the stand with four M8 x 45 hex cap screws and M8 lock washers (provided) using the holes in the base. Make sure there ...

10 Electrical Power Connection Do not operate this machine in damp locations. A separate electrical circuit should be used for your machines. This circuit should not be less than #12 wire and should be protected with a 20 Amp time lag fuse. If an extension cord is used, use only 3-wire extension cor...

11 Adjustments 90 ° Chisel to Worktable Calibration Referring to Figure 7: Place a square (E) so it rests against the worktable (B) and chisel (A). If the chisel to table angle is 90 ° , no calibration is necessary. If calibration is required: 1. Loosen the bolt (C) that allows the tilting base to p...

12 6. Reinstall the chisel bushing (F) and secure it loosely with the lock screw (E). 7. Reinstall the chisel and bit (refer to the Installing Chisel and Bit section ) . Depth Stop Rod Adjustment Referring to Figure 9: A depth stop rod (A) is provided to limit the depth of the chisel. To adjust: 1. ...

13 Chisel Parallel to Workpiece Referring to Figure 11: The chisel can be adjusted parallel to the workpiece as follows: 1. With the left handwheel (A), move the table back far enough to insert the workpiece (B) between the chisel (D) and fence . 2. Loosen the lock screw (C). This will allow the chi...

14 Do not have the chisel slot against the blind end of the mortise, as the chips will not be able to clear the chisel. This can cause overheating and possible breakage of chisel or bit. When cutting deep mortises, make the cut in several stages of approximately 1" each, to allow chips to clear....

15 three turns of the cutter in a carpenter's brace chuck should be enough to sharpen the chisel, as shown in Figure 16. Use a small, triangular, smooth file to relieve the inner corners of the chisel (Figure 17). Remove any burrs from the outside of the chisel with a fine oilstone. Lubrication All ...

16 719T Mortiser Parts List Index No. Part No. Description Size Qty ................. 2474002T ................. 719T Mortiser Assy (Items 1 thru 120) .............. ................................................. 1 1 ............... 719T-101.................. Fixed Base .............................

18 Index No. Part No. Description Size Qty 114 ........... TS-1491021 ............. Hex Cap Screw .................................................... M10 x 20 .................................. 4 115 ........... 719T-1115................ Tilting Bracket ................................................

19 719T Mortiser Stand Parts List Index No. Part No. Description Size Qty ................. 6294235T ................. Stand Assembly (Items 1 thru 8).......................... ................................................. 1 1 ............... 719T-201.................. Stand .......................

20 Optional Accessories Index No. Part No. Description ................. 6294232 ................... Chuck Extension Adaptor Kit (Items 1 thru 3)...... ................................................... 1 ............... 6294210 ................... Drill Adaptor Shaft .................................