JBL S7150 - Manual - manualsarea.com

Page 4 - CAUTION; PRECAUTIONS

1.1 Important SafeguardsFor Audio Products PLEASE READ CAREFULLY ALL THEFOLLOWING IMPORTANT SAFEGUARDSTHAT ARE APPLICABLE TO YOUR EQUIPMENT 1. Read instructions – All the safety and operating instructions should be read before the product isoperated. 2. Retain instructions – The safety and operating...

Page 5 - Outdoor Antenna Grounding –; GROUND CLAMPS

1.0 5 PRECAUTIONS 17. Outdoor Antenna Grounding – If an outside antenna is connected to the receiver, be surethe antenna system is grounded so as to provide some protection against voltagesurges and built-up static charges. Article810 of the National Electrical Code,ANSI/NFPA 70, provides informatio...

Page 8 - THX; INTRODUCTION

Introduction Congratulations on your purchase of this JBLSynthesis S7150 power amplifier! You have purchaseda product that embodies the best of what JBL haslearned about the emotional power of audioreproduction in over fifty years of preeminence in thefield. This amplifier has been designed and craf...

Page 10 - Manual On; Wire Run Length

10 3.0 OPERATION AND CONTROLS 3.0 OPERATION ANDCONTROLS 3.1 S7150 1. Power Switch Pushing this button is all that is required to turn on theS7150 if it is not part of a Synthesis system and the Manual On/Auto On switch (rear panel) is in the Manual On position. If the amplifier is used as part of a ...

Page 11 - position allows the amplifier to enter the

S7150 WARNING: serial number ATTENTION: VOIR LE CAHIER D' INSTRUCTION 15A 120V 50/60Hz 1800W Ch. 1 Output Ch. 2 Output Ch. 3 Output Ch. 4 Output Ch. 5 Output Ch. 6 Output Ch. 7 Output ON OFF MANUAL ON AUTO ON IN OUT SPKR-1 SPKR-2 Ch. 1 Input Ch. 2 Input Ch. 3 Input Ch. 4 Input Ch. 5 Input Ch. 6 Inpu...

Page 12 - OPERATION AND

8. IN/OUT DIN Jacks If you are using the amplifier as part of a JBL SynthesisSystem, it is necessary to use these jacks to interconnectto other system components, so that control signals(power on/off and music/cinema mode switching) canbe transmitted from one unit to the next, starting at thesurroun...

Page 13 - General Information; switches; INTERCONNECTIONS IN

General Information A Synthesis Two or Three installation incorporates a totalof two power amplifiers; one S7150 and one S800. Allseven channels on the S7150 are to be used for drivingthe left, center, right, both side, and both rear speakers. Use the simplified connection diagrams on the followingp...

Page 14 - Top

14 Power VCR DVD V-Disc TV Aux CD Tuner Tape Rec / Zone 2 Effect 2- Channel Mute JBL SDP-3COPYRIGHT 1999 SDP-3 Digital Surround Processor / Controller S D P - 3 S D E C - 2 5 0 0 A S 8 0 0 S 7 1 5 0 SDEC-2500A S 8 0 0 Top #1 #2 #3 #4 4.1 Synthesis Two & Three Suggested Rack Mounting Order 4.0 CO...

Page 15 - NOTES

SDP-3 SDEC-2500A WARNING – To reduce the risk of fire or electric shock, do not exposethis appliance to rain or moisture.Do not remove cover. No userserviceable parts inside. Referservicing to qualified service personnel. SDEC-2500ADigital Equalizer ControllerJBL, INC. Northridge CAMade in USA R-AMB...

Page 18 - TROUBLESHOOTING

Problem: Amplifier does not turn on. Neither the red nor blue indicator lights are on. Make sure that the amplifier is plugged in, and verify that thereis the proper voltage at the wall outlet. Problem: The red indicator lights, but the blue indicators do not light up when the power switch is depres...

Page 19 - 50W per channel into 8 ohms, all channels driven; SPECIFICATIONS

Rated Power Output 150W per channel into 8 ohms, all channels driven THD < 0.03% 20Hz - 20kHz Input Impedance 28k ohms Sensitivity 1V in = 100 watts out (THX Standard) 1.25V in = 150 watts out Frequency Response ( at 1 W ) 20Hz - 20kHz + 0, – 0.25dB S/N Ratio ( A-weighted at rated power ) ≥ 100dB...

JBL S7150 - Manual

Table of Contents:

Summary

Other JBL Models