Jasco 19200 - Manual
Jasco 19200 – Manual, read for free online in PDF format. We hope this helps you resolve any issues you may have. If you have further questions, please contact us through the contact form.
Table of Contents:
- Page 2 – Chime Tune Setting; Single Push Button Kit:; If you purchased a kit with a single push button, the; Dual Push Button Kit:; If you purchased a kit with two push buttons, one push
- Page 4 – Note
- Page 5 – Jumpers 1-6 are used to select 1 of 64 possible home security codes.; Push Button Mounting Instructions; Avoid mounting the push button on metal surfaces, as it may result; a. Removing the back cover
- Page 6 – feet from the chime unit location.
- Page 8 – Operation; Slide power switch to “High” or “Low” to power the chime.
- Page 9 – is a trademark of
GE Model 19200
www.jascoproducts.com
Wireless Portable Chime
Installation Instructions for Wireless Portable
Door Chime Kit
Required Tools:
Small flat blade screwdriver, drill, drill bit, and phillips
screwdriver.
Included Hardware:
(2) 3x20mm screws
(2) Double sided adhesive pads
The portable wireless door chime Kit has two components:
Portable Chime (receiver) Push-Button (Transmitter).
How To Install The Batteries
1. On the bottom of the portable chime you will find a round battery release
tab. Push the tab inward and slide the cover in the direction of the arrow.
The battery cover will slide off.
"Loading the manual" means you need to wait until the file loads and becomes available for online reading. Some manuals are very large, and the time they take to appear depends on your internet speed.
Summary
Battery Release Tab 2. Install 4 C-cell batteries (we recommend Alkaline Batteries) 3. Remove back of wireless push button and install the 12-volt battery (included) as shown below. Chime Tune Setting All wireless chimes may have more than one push button. The chime tune for each push button is set ...
Each component has jumpers for setting the house security code: The chime and pushbutton must be set to the same house security code for the combination to operate together. Note : The push button has 3 additional jumpers that are used to set the chime tune that will play. The chime tune jumpers do ...
3. Locate the House Security Code door and screw located on the back of the AC Chime. Remove the screw and take off the door. 4. Locate the chime and pushbutton jumpers shown below. Push Button Jumpers Chime Jumpers in battery compartment 5. Jumpers 1-6 are used to select 1 of 64 possible home secur...
