Page 2 - Copyright Notice
R o b u s t P a n e l P C A P C - 9 1 7 2 i Copyright Notice This document is copyrighted, 2007. All rights are reserved. The original manufacturer reserves the right to make improvements to the products described in this manual at any time without notice. No part of this manual may be reproduced, c...
Page 3 - ii; Acknowledgments; Intel
R o b u s t P a n e l P C A P C - 9 1 7 2 ii Acknowledgments Intel ® and Pentium ® are registered trademarks of Intel ® Corporation. IBM, PC/AT, PS/2 are trademarks of International Business Machines Corporation. Microsoft Windows ® is a registered trademark of Microsoft Corporation. All other produ...
Page 4 - iii; Packing List
R o b u s t P a n e l P C A P C - 9 1 7 2 iii Packing List Before you begin operating your PC, please make sure that the following materials have been shipped: 1 APC-9172 Robust Panel PC 2 Easy stand 1 Waterproof sponge 12 Panelmount clips & screws 1 Screw bag 1 CD-ROM for manual (in PDF format)...
Page 5 - iv
R o b u s t P a n e l P C A P C - 9 1 7 2 iv Safety & Warranty 1. Read these safety instructions carefully. 2. Keep this user's manual for later reference. 3. Disconnect this equipment from any AC outlet before cleaning. Do not use liquid or spray detergents for cleaning. Use a damp cloth. 4. Fo...
Page 6 - FCC Safety
R o b u s t P a n e l P C A P C - 9 1 7 2 v d. The equipment does not work well, or you cannot get it to work according to the user’s manual. e. The equipment has been dropped and damaged. f. The equipment has obvious signs of breakage. 15. DO NOT LEAVE THIS EQUIPMENT IN AN ENVIRONMENT WHERE THE STO...
Page 7 - vi
R o b u s t P a n e l P C A P C - 9 1 7 2 vi Below Table for China RoHS Requirements 产品中有毒有害物质或元素名称及含量 AAEON Panel PC/ Workstation 有毒有害物质或元素 部件名称 铅 (Pb) 汞 (Hg) 镉 (Cd) 六价铬 (Cr(VI)) 多溴联苯 (PBB) 多溴二苯醚 (PBDE) 印刷电路板 及其电子组件 × ○ ○ ○ ○ ○ 外部信号 连接器及线材 × ○ ○ ○ ○ ○ 外壳 × ○ ○ ○ ○ ○ 中央处理器 与内存 × ○ ○ ○ ○ ○ 硬盘 × ○ ○ ○...
Page 8 - vii; Contents; Chapter 1 General Information
R o b u s t P a n e l P C A P C - 9 1 7 2 vii Contents Chapter 1 General Information 1.1 Introduction................................................................ 1-2 1.2 Features .................................................................... 1-3 1.3 Specifications ............................
Page 9 - viii; Appendix A I/O Information
R o b u s t P a n e l P C A P C - 9 1 7 2 viii Appendix A I/O Information A.1 I/O Address Map ....................................................A-2 A.2 Memory Address Map ............................................A-3 A.3 IRQ Mapping Chart ................................................A-4 A.4 D...
Page 10 - General; Chapter; Information
R o b u s t P a n e l P C A P C - 9 1 7 2 Chapter 1 General Information 1- 1 General Chapter 1 Information
Page 11 - Best performance for multimedia solution
R o b u s t P a n e l P C A P C - 9 1 7 2 Chapter 1 General Information 1-2 1.1 Introduction APC-9172 is first Core 2 Duo industrial board in AAEON Panel PC product line. It features a PGA478 socket that can accommodate Core 2 Duo Processor, supporting FSB up to 400/533/667MHz. Best performance for ...
Page 12 - All-in-one SBC supports Socket 478 based Intel
R o b u s t P a n e l P C A P C - 9 1 7 2 Chapter 1 General Information 1- 3 1.2 Features 17” TFT SXGA (1280 x 1024) LCD All-in-one SBC supports Socket 478 based Intel ® Core 2 Duo Processor Anti-vibration disk drive bay for HDD Water-proof and anti-scratch IP-65 certified aluminum front panel with ...
Page 13 - System
R o b u s t P a n e l P C A P C - 9 1 7 2 Chapter 1 General Information 1-4 1.3 Specifications System Construction Heavy-duty steel chassis & IP-65 certified aluminum front panel (or optional stainless steel front panel) CPU Socket 478 based Intel ® Core 2 Duo Processor up to 2.0G with FSB 400/5...
Page 14 - Mechanical and Environment
R o b u s t P a n e l P C A P C - 9 1 7 2 Chapter 1 General Information 1- 5 (Type I/II), Secure Digital, Multi Media Card, Memory Stick (PRO) and Smart Media USB ports 4 USB 2.0 ports on rear panel; 1 USB 2.0 port on front panel (Lockable by BIOS) Because of USB chipset limitation, front USB port a...
Page 15 - Power Supply
R o b u s t P a n e l P C A P C - 9 1 7 2 Chapter 1 General Information 1-6 Operating humidity 10 to 90% @35 ° C, non-condensin Vibration 1.5G / 5~500Hz (Random/ operation) Shock 15G peak acceleration (11 msec. duration)/ operation EMC CE/FCC Class A Power Supply AC input 250W: Output rating: 250W I...
Page 17 - Hardware
R o b u s t P a n e l P C A P C - 9 1 7 2 Chapter 2 Hardware Installation 2-1 Hardware Installation Chapter 2
Page 18 - Safety Precautions
R o b u s t P a n e l P C A P C - 9 1 7 2 Chapter 2 Hardware Installation 2 - 2 2.1 Safety Precautions Always completely disconnect the power cord from your board whenever you are working on it. Do not make connections while the power is on, because a sudden rush of power can damage sensitive electr...
Page 19 - COM 4 is reserved for touch screen.
R o b u s t P a n e l P C A P C - 9 1 7 2 Chapter 2 Hardware Installation 2 - 3 2.2 COM1~4 RS-232/422/485 Serial Port Connector (CN16) 5 1 9 6 COM 4 is reserved for touch screen. P i n S i g n a l P i n S i g n a l 1 DCD1 2 DSR1 3 RXD1 4 RTS1 5 TXD1 6 CTS1 7 DTR1 8 RI1 9 GND
Page 20 - HDD Installation; Screw up the HDD onto HDD Bracket
R o b u s t P a n e l P C A P C - 9 1 7 2 Chapter 2 Hardware Installation 2 - 4 2.3 HDD Installation Step 1: Screw up the HDD onto HDD Bracket Step 2: Fasten the 4 pieces of anti- vibration Rubbers on the HDD bracket. Step 3: Screw two brackets with four screws to fasten Anti-vibration Rubbers.
Page 23 - Easy Stand Installation; There’re two L-shaped easy stands come with the product. Refer to
R o b u s t P a n e l P C A P C - 9 1 7 2 Chapter 2 Hardware Installation 2 - 7 2.5 Easy Stand Installation There’re two L-shaped easy stands come with the product. Refer to the following illustration to install it. 1. Fix the L-shaped easy stands with the screws on both sides of the monitor. See th...
Page 24 - Panelmount Kit Installation; Some screw sets will come with the product for user to mount the
R o b u s t P a n e l P C A P C - 9 1 7 2 Chapter 2 Hardware Installation 2 - 8 2.6 Panelmount Kit Installation Some screw sets will come with the product for user to mount the monitor on the wall. See the steps below along with the illustration. Step 1 : Bore the screw into the screw nut. Step 2 : ...
Page 25 - Waterproof Sponge Installation; The following illustration shows you how to lodge the waterproof
R o b u s t P a n e l P C A P C - 9 1 7 2 Chapter 2 Hardware Installation 2 - 9 2.7 Waterproof Sponge Installation The following illustration shows you how to lodge the waterproof sponge in the back of the monitor set. 1. Lodge the Sponge in the back of the monitor set. 2. Locate the monitor set on ...
Page 26 - BIOS
R o b u s t P a n e l P C A P C - 9 1 7 2 Chapter 3 BIOS Installation 3-1 Chapter BIOS 3 Installation
Page 27 - System test and initialization; System configuration verification
R o b u s t P a n e l P C A P C - 9 1 7 2 Chapter 3 BIOS Installation 3-2 3.1 System test and initialization These routines test and initialize board hardware. If the routines encounter an error during the tests, you will either hear a few short beeps or see an error message on the screen. There are...
Page 28 - This entry appears if your system supports PnP/PCI.
R o b u s t P a n e l P C A P C - 9 1 7 2 Chapter 3 BIOS Installation 3-3 3.2 Award BIOS Setup Awards BIOS ROM has a built-in Setup program that allows users to modify the basic system configuration. This type of information is stored in battery-backed CMOS RAM so that it retains the Setup informati...
Page 30 - Driv
R o b u s t P a n e l P C A P C - 9 1 7 2 Chapter 4 Driver Installation 4 - 1 Chapter Driv 4 er Installation
Page 32 - Step 2 –VGA
R o b u s t P a n e l P C A P C - 9 1 7 2 Chapter 4 Drivers Installation 4 - 3 4.1 Installation Insert the APC-9172 CD-ROM into the CD-ROM drive and install the drivers from Step 1 to Step 6 in order. Step 1 – Install INF Driver 1. Click on the Step 1-INF folder 2. Double click on infinst_autol.exe ...
Page 33 - Step 6 –TOUCH
R o b u s t P a n e l P C A P C - 9 1 7 2 Chapter 4 Driver Installation 4 - 4 2. Double click on WDM_A395.exe 3. Follow the instructions that the window shows 4. The system will help you install the driver automatically Step 5 – Install Card Reader Driver 1. Click on the Step 5 –Card_Reader folder 2...
Page 34 - Appendix
R o b u s t P a n e l P C A P C - 9 1 7 2 Appendix A I/O Information A-1 I/O Information Appendix A
Page 36 - A.2 Memory Address Map
R o b u s t P a n e l P C A P C - 9 1 7 2 Appendix A I/O Information A-3 A.2 Memory Address Map
Page 37 - A.3 IRQ Mapping Chart
R o b u s t P a n e l P C A P C - 9 1 7 2 Appendix A I/O Information A-4 A.3 IRQ Mapping Chart A.4 DMA Channel Assignments
