Integra DTR-80.2/70.2 - Manual
Integra DTR-80.2/70.2 – Manual, read for free online in PDF format. We hope this helps you resolve any issues you may have. If you have further questions, please contact us through the contact form.
Table of Contents:
- Page 2 – Check the network connection before update.; Limitation of liability
- Page 3 – Updating the Firmware via Network; In this procedure, on-screen display may vary; Before you start; Turn off Zone 2 and Zone 3.
- Page 5 – No Update; ” is displayed on the front display of the AV; Errors during update via network; Error Code Description; Others
- Page 6 – Updating the Firmware via USB
- Page 7 – to light up the
- Page 8 – Do not use; Press
- Page 9 – Troubleshooting; If “; ” is displayed on the front display of the; Onkyo CORPORATION; The Americas
1
Firmware Update for the DTR-80.2/70.2 and DHC-80.2
We are pleased to offer this firmware update for the best possible performance of your AV Receiver.
A firmware update is now available through the Network or USB connections on the DTR-80.2/70.2 and
DHC-80.2.
The 11/10/10 update addresses the following:
DTR-80.2/70.2 and DHC-80.2
1. Improves the playback of particular wav files
2. Corrects intermittent activation of Auto Power Down function during playback in NET/USB mode
The 10/27/10 update addresses the following:
DTR-80.2/70.2 and DHC-80.2
1. Stabilizes "Now Initializing" process to activate [NET/USB] mode in a busy network;
2. Improves the playback speed of particular VR (Variable Bit Rate) mp3 files.
3. Changes the timing of volume operation start. (thereby avoiding problems of no sound output after power is
turned on from Standby mode with network control enabled).
The 09/17/10 update addresses the following:
DTR-80.2/70.2 and DHC-80.2
1.
Improves Audyssey MultEQ XT32 processing.
Please carry out auto speaker setup again by using Audyssey MultEQ XT32 after upgrade.
2.
Enhances the operability and display of network/USB-related functions
The latest update includes all prior updates.
We hope you enjoy the improved functionality this update provides to your AV Receiver.
"Loading the manual" means you need to wait until the file loads and becomes available for online reading. Some manuals are very large, and the time they take to appear depends on your internet speed.
Summary
2 Firmware Update for DTR-70.2/DTR-80.2 and DHC-80.2 There are the following methods to update the firmware: via network and via USB storage. Please choose either one that suits your condition. Before you start, carefully read the update procedure. It will take about 30 minutes to update the firmwar...
3 Updating the Firmware via Network DTR-70.2, DTR-80.2 and DHC-80.2 allow you to update firmware using network connection on rear panel. * In this procedure, on-screen display may vary depending on the model. • Make sure the AV receiver/controller and TV are turned on and Ethernet cable is connected...
5 Troubleshooting Case1: If “ No Update ” is displayed on the front display of the AV receiver/controller, the firmware has already been updated. You do not need to do anything further. Case2: If an error occurs, “ Error!! *-** No media ” is displayed on the front display of the AV receiver/controll...
