Ingersoll Rand 2925Ti - Manual
Ingersoll Rand 2925Ti – Manual, read for free online in PDF format. We hope this helps you resolve any issues you may have. If you have further questions, please contact us through the contact form.
Table of Contents:
- Page 2 – WARNING; Lubrication; Ingersoll Rand; Disassembly; General Instructions; Disassembly of the Quick-Change Anvil; NOTICE; Disassembly of the Impact Mechanism; NOTICE; ” and the bottom Hammer “B; NOTICE
- Page 3 – Assembly; inner
- Page 4 – Install the assembled Front End Plate and Bearing over; Assembly of the Reverse Valve; Install the Reverse Valve in the reverse valve bushing; Slide the Reverse Lever Spring (20) over the shaft of the; Assembly of the Impact Mechanism
- Page 5 – Assembly of the Quick-Change Anvil
- Page 6 – Trouble; Low power; complete; Incorrect assembly of the motor.
- Page 7 – Notes
- Page 8 – Company
04584348
Edition 2
April 2006
Air Impact Wrench
2925Ti Series
Maintenance Information
Save These Instructions
"Loading the manual" means you need to wait until the file loads and becomes available for online reading. Some manuals are very large, and the time they take to appear depends on your internet speed.
Summary
EN-2 04584348_ed2 WARNING Always wear eye protection when operating or performing maintenance on this tool.Always turn off the air supply and disconnect the air supply hose before installing, removing or adjusting any accessory on this tool, or before performing any maintenance on this tool. Note: W...
04584348_ed2 EN-3 3. Hold the Hammer Frame firmly and, without disturbing the Hammers, gently lift the Anvil, simultaneously rotating it clockwise about 1/8 of a turn, from Hammer Frame. 4. With Anvil removed, lift out the two Hammer Pins. NOTICE The twin Hammers are now free to slide from the Hamme...
EN-4 04584348_ed2 (Dwg. TPD1921) NOTICE If more power is needed for forward operation than for reverse operation, install the Cylinder with exhaust ports to the RIGHT of top dead center (1 o’clock position). 7. Install the assembled Front End Plate and Bearing over the front, splined end of the Roto...
