Infinity TSS-SUB500 - Manual

Page 2 - CONTENTS; TSS-Sub500 Specifications; Crossover Frequency:

Note: The TSS-Sub500 is part of the TSS-500 system Satellite loudspeakers: (Charcoal) order Infinity part# TSS-SAT500CHR (Platinum) order Infinity part# TSS-SAT500PLT Center channel: Call Infinity Systems parts department (Charcoal) (Platinum) CONTENTS BASIC SPECIFICATIONS . . . . . . . . . …………………....

Page 4 - 00W Powered Sub/ Plate Amp

TSS-Sub500 100W Powered Sub/ Plate Amp LINE VOLTAGE Yes/No Hi/Lo Line Unit Notes US 120VAC/60Hz Yes 108-132 Vrms Normal Operation Europe 220-240VAC, 50-60Hz Yes 220-240 Vrms Normal Operation Parameter Specification Unit QA Test Limits Conditions Notes Amp Section Type (Class AB, D, other) AB AB n/a ...

Page 6 - Rear Panel

5 TSS-500 S UBWOOFER C ONTROLS Rear Panel A Few Suggestions We recommend that you do not operate your speakers orsubwoofer with the bass, treble and loudness controls set to full boost. This will place undue strain on your electronics andspeakers and could damage them. The volume control setting on ...

Page 7 - If you have a Dolby

6 TSS-500 S UBWOOFER C ONNECTIONS If your receiver/processor does not contain a Dolby Digital or DTS processor but has asubwoofer output: If you have a Dolby ® Digital or DTS ® receiver/ processor with a low-frequency-effects (LFE) or subwoofer output: SUBWOOFER OR LFE OUTPUT TSS-Sub500/230 RECEIVER...

Page 8 - PERATION; Surround Modes; Power On; Final Positioning; AINTENANCE AND

7 TSS-500 O PERATION Surround Modes When using the TSS-500 in a Dolby Digital or DTS home theatersystem, make sure all speakers are set to “Small”. When using thesystem in a Dolby Pro Logic ® home theater system, make sure the receiver’s center channel mode is set to “Normal.” Some Dolby Digital-equ...

Page 10 - Test Set Up and Procedure

Test Set Up and Procedure Equipment needed: • Function/signal generator/sweep generator • Integrated Amplifier • Multimeter • Speaker cables General Unit Function (UUT = Unit Under Test) 1) From the signal generator, connect one line level (RCA) cable to the Subwoofer Line Level Input jacks L/R on t...

Page 12 - Troubleshooting Flow Chart; yes

TSS500 Troubleshooting Flow Chart no yes yes yes no yes yes LED red LED light blue yes yes no yes yes no no yes yes yes no no yes yes yes no yes yes AMP no signal out DC voltage check ±Vcc Check +/-15v Led light blue or red Check fuse, transformer, D110,D115 etc Check RLY101,D102,Q113,114 Check Q107...

Page 21 - PREAMP PCB

TSS-Sub500 (120v) Electrical Parts List Part Number Description Qty Reference Designator PREAMP PCB Resistors 110-16102j26 Resistor 1K 1/6W ±5% CF 26mm 4 R213,214,215,254 110-16103j26 Resistor 10K 1/6W ±5% CF 26mm 13 R212,216,217,220,221,222,225,228,226,232, 235,240,248 110-16104j26 Resistor 100K 1/...

Page 23 - LIMITER PCB

Part Number Description Qty Reference Designator POWER/MAIN PCB 192-202b772y TransistorKSD772Y PNP 1 Q119 192-991d669a TransistorHI-SINCERITY HSD669A NPN 1 Q106 192-992b649t Transistor HSB649T PNP 1 Q105 197-00kb1405 diode 4A500V KBL405 BRIDGE 1 D110 197-101n4002 diode IN4002 1 D104 Miscellaneous 16...

Page 24 - MISCELLANEOUS/MECHANICAL

Part Number Description Qty Reference Designator MISCELLANEOUS/MECHANICAL 333-EVA-00783 EVA W 198*12*2.0T 2 333-EVA-00807 EVA L 274*12*2.0T 2 333-EVA-00826 EVA W 198*12*1.0T 2 333-EVA-00835 EVA L 274*12*1.0T 2 320-RUB-00033 rubber foot pad 25*21*4t 4 337-CU-00101 copper foil 65L*50W 1 306-ABS-00177 ...

Infinity TSS-SUB500 - Manual

Table of Contents:

Summary

Other Infinity Models