Infinity Oreus HCS - Manual

Page 2 - About This Manual; Table of Contents

O REUS O WNER’S G UIDE P LANNING Y OUR S YSTEM I NTRODUCTION About This Manual To start enjoying your new Oreus HCS, read and then follow allinstructions listed in this guide, as well as those found in theowner’s manuals of associated components in your audio system.Save all instructions for future ...

Page 4 - Your speaker should now look like this.; Feed speaker cable through the foot; Attach the base to the wall using suitable screws.

2. The foot can be attached to the speaker at two different positions.The first position allows the speaker to be used vertically (normal forsatellites), while the second allows it to be used horizontally (normalfor the center channel). Note the blanking plug which f ills theunused pivot hole on the...

Page 5 - SSEMBLING THE

8. Put the pivot back into place. Re-fit the cover plate and replacethe two fixing screws. Do not fully tighten the screws at this stagebecause you will need to rotate the pivot later in the assemblyproceedure to angle your speakers correctly. Attach the foot to the speaker 1. Remove the two screws ...

Page 6 - Attaching the stand to the speaker; NSTALLING; Your speaker should now look like this.

4. Fit the blanking plug into the unused f oot pivot locationhole and then re-f it the rear cover on the speaker and tightenthe f ixing screws. Attaching the stand to the speaker 1. Remove the two screws and take off the rear cover plate fromthe speaker. Use the hex key supplied to loosen the screws...

Page 7 - Connection tips

S PEAKER- L EVEL S UBWOOFER C ONNECTIONS Connection tips S e p a r a t e a n d s t r i p t h e e n d s o f t h e s p e a k e r w i r e a s s h o w n .Speakers and amplif iers/receivers have corresponding (+) and(–) terminals. T h e ( + ) l e a d o f t h e s p e a k e r w i r e i s n o t e d w i t h ...

Page 8 - PERATION; With LFE Connection

O PERATION With LFE Connection If you ar e using the LFE input, the subwoof er's CROSSOVERcontrol is NOT active, because this function is controlled by yoursurround processor. When using the LFE input, set the subwoofer's VOLUME control to"Max" and calibrate the subwoofer level along with th...

Page 9 - DO NOT ATTEMPT ANY REPAIRS!; ROUBLESHOOTING; Oreus HCS; PECIFICATIONS

If the subwoofer sound is distor ted, stops playing or other wiseseems to be malfunctioning, f irst determine if the problem is inthe subwoofer or the wiring and/or other audio components.If the problem also affects the satellite speakers, the cause is mostlikely in your electronics. If it is only n...

Infinity Oreus HCS - Manual

Table of Contents:

Summary

Other Infinity Models