IBM ETX-DB-ATX - Manual
IBM ETX-DB-ATX – Manual, read for free online in PDF format. We hope this helps you resolve any issues you may have. If you have further questions, please contact us through the contact form.
Table of Contents:
- Page 2 – Introduction
- Page 3 – Installation; This chapter gives instructions about how to set up the
- Page 4 – Unpacking Precautions; JP4 DESCRIPTION; Clear CMOS Setup
- Page 5 – WatchDog Timeout Active Selector; JP7: WatchDog Active Select; Ethernet Controller Setting; Connection; This chapter describes how to connect peripherals, switches; ETX Connector X1
- Page 6 – ETX Connector X2; ETX Connector X3; and Keyboard
- Page 7 – ETX Connector X4; PIN SIGNAL; Floppy Disk Drive Connector; PIN
- Page 8 – CN14: 40-pin Secondly IDE Interface Connector
- Page 9 – DESCRIPTION; USB Port Connector; CN5: External USB Connector; IrDA Infrared Interface Port; CN16: IrDA connector; VGA Connector
- Page 10 – PSLOT1: PCI Slot 1; PCI Routing List; SIGNAL
- Page 11 – ISA BUS Interface
ETX-DB-ATX
ETX MODULE BASEBOARD
PCB V1.2
Manual Revision
1.0
April 11, 2002
Copyright 2003 by ICP Electronics Inc. All Rights Reserved.
The information in this document is subject to change without prior notice in order to
improve reliability, design and function and does not represent a commitment on the part
of the manufacturer.
In no event will the manufacturer be liable for direct, indirect, special, incidental, or
consequential damages arising out of the use or inability to use the product or
documentation, even if advised of the possibility of such damages.
This document contains proprietary information protected by copyright. All rights are
reserved. No part of this manual may be reproduced by any mechanical, electronic, or
other means in any form without prior written permission of the manufacturer.
Trademarks
ETX-DB-AT X is a registered trademark of ICP Electronics Inc. IBM PC is a registered
trademark of International Business Machines Corporation. Intel is a registered
trademark of Intel Corporation. Other product names mentioned herein are used for
identification purposes only and may be trademarks and/or registered trademarks of their
respective companies
ETX-DB-ATX
2
Contents
1. Introduction .........................................................................4
1.1 Specifications............................................................................. 4
1.2 W hat Yo u Have .......................................................................... 5
2. Installation ...........................................................................6
2.1 ETX-DB-ATX Board Layout ....................................................... 6
2.2 Unpacking Precautio ns ............................................................. 8
2.3 LCD Vcc Voltage Selector ......................................................... 8
2.4 Clear CMOS Setup .................................................................... 8
2.5 WatchDog Timeout Active Selector ........................................... 9
2.6 Internal B uzzer E nable/Disable ................................................. 9
2.7 Ethernet Controller Setting ........................................................ 9
3. Connection ........................................................................ 10
3.1 ETX Connector X1................................................................... 10
3.2 ETX Connector X2................................................................... 11
3.3 ETX Connector X3................................................................... 12
3.4 ETX Connector X4................................................................... 13
3.5 Floppy Disk Drive Co nnector .................................................. 14
3.6 PCI E-IDE Disk Drive Connector............................................. 15
3.7 Parallel Port ............................................................................. 16
3.8 Serial Ports .............................................................................. 16
3.9 USB Port Connector ................................................................ 17
3.10 IrDA Infrared Interface Port ................................................... 18
3.11 TV-OUT Interface Port ........................................................... 18
3.12 VGA Connector...................................................................... 18
3.13 LCD/LVDS Interface Connector ............................................ 19
3.14 LAN RJ45 Co nnector ............................................................ 19
3.15 AUDIO JACK ......................................................................... 20
"Loading the manual" means you need to wait until the file loads and becomes available for online reading. Some manuals are very large, and the time they take to appear depends on your internet speed.
Summary
ETX-DB-ATX 3 3.16 PCI BUS Interface ................................................................. 20 3.17 ISA BUS Interface ................................................................. 22 3.18 ATX power connector ............................................................ 23 3.19 Front Pan...
ETX-DB-ATX 5 * ISA interface: One ISA slots. * 10/100Mbps Ethernet Controller: Intel 82551QM or Realtek RTL8100 IEEE802.u 100 BASE-TX standard Dual Auto-sensing interface to 10MBps or 100MBps networks. On board RJ45 connectors provide for easy connection. * Power connector: standard ATX power connec...
ETX-DB-ATX 7 ETX-DB-ATX Layout CN16 A T X PWER JP7 Battery ISA1 CN9 JP6 Digital IO PSLOT2 PSLOT1 X1 X2 CN1 CN10 CN20 CN13 CN14 CN3 USB3 ET X-D B -A T X V1 .2 COM2 CN1 1 X3 X4 CN2 CN8 CN5 CN6 CN12 JP4 CN15 IR CN4 CN7 CN21 USB2 KB/MS USB COM1 LPT1 VGA AUDIO 48 BIT LVDS CN17 JP10 ETX-DB-ATX 8 2.2 Unpac...
