Husqvarna 7021F - Manual

5 FUEL VALVE LEVER KNOW YOUR LAWN MOWER READ THIS OWNER'S MANUAL AND SAFETY RULES BEFORE OPERATING YOUR LAWN MOWER. Compare the illustrations with your lawn mower to familiarize yourself with the location of various controls and adjustments. Save this manual for future reference. MEETS CPSC SAFETY R...

6 TO CONVERT MOWER Your lawn mower was shipped ready to be used as a mulcher. To convert to bagging or discharging: REAR BAGGING (See Fig. 5) • Lift rear door of the lawn mower and place the grass catcher frame hooks onto the door pivot pins. • To convert to mulching or dis charg ing operation, remo...

7 PIVOT PINS REAR DOOR GRASS CATCHER HANDLE CATCH ER FRAME HOOK FIG. 5 OPERATION SIDE DISCHARGING (See Fig. 6) • Rear door must be closed. • Open mulcher door and install dis charge defl ector under door as shown. • Mower is now ready for discharging operation. • To convert to mulching or bagging op...

8 OPERATION MOWING TIPS CAUTION: Do not use de-thatcher blade attachments on your mower. Such at-tachments are hazardous, will damage your mower and could void your warranty. • Under certain conditions, such as very tall grass, it may be necessary to raise the height of cut to reduce pushing effort ...

9 OPERATION • Avoid cutting your lawn when it is wet. Wet grass tends to form clumps and interferes with the mulching action. The best time to mow your lawn is the early afternoon. At this time the grass has dried, yet the newly cut area will not be exposed to direct sunlight. • For best results, ad...

10 ➁ ENGINE OIL ➀ HANDLE BRACK ET MOUNT ING PINS ➀ REAR DOOR HINGE ➀ MULCHER DOOR HINGE PIN ➀ WHEEL ADJUSTER (ON EACH WHEEL) LUBRICATION CHART ➀ SPRAY LUBRICANT ➁ SEE “ENGINE” IN MAINTENANCE SECTION • At least once a year, replace the spark plug, clean or replace air fi lter element and check blade ...

11 MAINTENANCE TO REPLACE BLADE (See Fig. 11)1. Position the blade adapter on the engine crank shaft. Be sure key in adapter and crankshaft key way are aligned. 2. Position blade on the blade adapter aligning the two (2) holes in the blade with the raised lugs on the adapter. 3. Be sure the trailing...

12 CAUTION: To avoid serious injury, before performing any service or adjustments: 1. Release control bar and stop engine. 2. Make sure the blade and all moving parts have completely stopped. 3. Disconnect spark plug wire from spark plug and place where it cannot come in contact with plug. 6. Wait o...

14 STORAGE ENGINE Maintenance, re pair, or re place ment of the emission con- trol de vic es and sys tems, which are be ing done at the cus tom ers expense, may be performed by any non-road engine repair es tab lish ment or individual. Warranty repairs must be performed by an authorized engine man u...

15 TROUBLESHOOTING POINTS Does not start 1. Dirty air fi lter. 1. Clean/replace air fi lter. 2. Out of fuel. 2. Fill fuel tank. 3. Stale fuel. 3. Empty fuel tank and refi ll tank with fresh, clean gasoline. 4. Water in fuel. 4. Empty fuel tank and refi ll tank with fresh, clean gasoline. 5. Spark pl...