Husqvarna 350BF - Manual - manualsarea.com

Page 2 - English; FEDERAL EMISSION CONTROL WARRANTY STATEMENT

English 2 YOUR WARRANTY RIGHTS AND OBLIGATIONS The EPA (The US Environmental Protection Agency), CARB (California Air Resources Board), Environment Canada and Husqvarna Forest & Garden are pleased to explain the emissions control system warranty on your 2007 and later small nonroad engine. In U....

Page 3 - Contents

English 3 Safety . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 4 SAFETY FIRST . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 4Notes on types of warnings . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 4 Wa...

Page 4 - SAFETY FIRST; Symbols; Warning labels on the machine

English 4 SAFETY FIRST Instructions contained in warnings within this manual and warning seals marked with a symbol on the blower concern critical points which must be taken into consideration to prevent possible serious bodily injury, and for this reason you are requested to read all such instructi...

Page 5 - WORKING CONDITIONS; Safety Precautions

English 5 For safe operation and maintenance, symbols are carved in relief on the machine. Using to these indications, please be careful not to make a mistake. (a) The port to refuel the "MIX GASOLINE" Position: FUEL TANK CAP (b) The direction to close the choke Position: INTAKE CUP (c) The ...

Page 6 - WORKING CIRCUMSTANCE; WORKING PLAN

English 6 1. Refrain from operating the blower if you are tired, ill, or upset, or if you are under the influence of alcohol, drugs or medication 2. To reduce the risk of hearing loss associated with sound levels, hearing protection is required. 3. To reduce the risk of injury associated with thrown...

Page 7 - USING THE PRODUCT

English 7 BEFORE STARTING THE ENGINE Each time before starting the engine, inspect the entire unit to see if every part is in good order and is securely tightened in place. If any damage is found in the fuel line, the exhaust line, or the ignition wiring, do not use the blower until it has been repa...

Page 8 - MAINTENANCE; TRANSPORTATION

English 8 MAINTENANCE 1. In order to maintain your product in proper working order, perform the maintenance and checking operations described in the manual at regular intervals. 2. Always be sure to turn off the engine and disconnect the spark plug before performing any maintenance or checking proce...

Page 9 - DISPOSAL

English 9 1. Frame 2. Harness 3. Engine Cover 4. Volute Case, Cover 5. Net 6. Fan 7. Air Cleaner 8. Recoil Starter 9. Fuel Tank 10. Pad11. Spark Plug Cap12. Shock Absorber (Spring) 13. Band (stopper)14. Shock Absorber (Rubber)15. Choke Lever 16. Control handle17. Stop Switch with Throttle Position S...

Page 13 - Technical data

English 13 • The data shown above are those in the case of one straight pipe. • Specifications are subject to change without notice. • This spark ignition system complies with the Canadian standard ICES-002. Note 1: Noise emissions in the environment measured as sound power (L WA ) in conformity wit...

Page 14 - FLEXIBLE HOSE AND SWIVEL JOINT; Assembly

English 14 ■ FLEXIBLE HOSE AND SWIVEL JOINT 1. Connect the blower and swivel joint with flexible hose. Clamp both ends of the flexible hose securely with the hardware supplied with the unit. (1) Flexible hose (2) Swivel joint (3) Clamp (large) (4) Clamp (small) NOTE A light lubricant may be used to ...

Page 15 - BLOW PIPES; HARNESS

English 15 ■ BLOW PIPES Conect the swivel joint, straight pipe and pipe end. Push the pipes together and turn them so they lock in relation to one another until the connection is locked. NOTE A light lubricant may be used to ease assembly of blower tube. NOTE If longer tube is required, the second s...

Page 16 - FUEL; HOW TO MIX FUEL; FUELING THE UNIT; Fuel

English 16 ■ FUEL WARNING - Gasoline is very flammable. Avoid smoking or bringing any flame or sparks near fuel. Make sure to stop the engine and allow it cool before refueling the unit. Select outdoor bare ground for fueling and move at least 10ft (3m) away from the fuel-ing point before starting t...

Page 17 - STARTING ENGINE; Operation

English 17 ■ CONTROL ARM [350BF/370BFS/380BFS] - Hold the upper end of the control arm in hand and, while pulling it away from the unit, rotate arm forward (counter-clockwise in the direction of the arrow) until it clicks. (The first position) And if you want, you can rotate arm further until it cli...

Page 18 - ADJUSTING IDLE SPEED

English 18 ■ ADJUSTING IDLE SPEED [130BT] - The idling speed is set for 3000 rpm at the factory. If it is necessary to adjust the idle speed, use the adjustment screw on the top side of carburetor. (1)Idling Adjustment Screw [350BT/BF] [370BTS/BFS] [380BTS/BFS] - The idling speed is set for 2200 rpm...

Page 19 - AIR CLEANER; Maintenance

English 19 Maintenance, replacement, or repair of the emission control device and systems may be performed by any non-road engine repair establishment or individual. WARNING Make sure that the engine has stopped and is cool before performing any service to the blower. Contact with rotating blower fa...

Page 20 - FUEL FILTER; SPARK ARRESTER

English 20 [370BTS/BFS] [380BTS/BFS] (F31) 1. Unscrew 2 knob bolts and remove the air cleaner cover. Then remove the prefilter mounted inside the air cleaner cover. (1)Knob Bolt(2) Prefilter (3)Inner Case [380BTS/BFS](4) Paper Filter 2. Wash the prefilter in fresh, non flammable cleaning solution (e...

Page 21 - COOLING SYSTEM; SHOLDER STRAP; Storage

English 21 ■ COOLING SYSTEM - To keep the working temperature as low as possible the machine is equipped with a cooling system. (1) Cooling fins on the cylinder. Clean the cooling system with a brush once a week, more often in demanding conditions. A dirty or blocked cooling system results in the ma...