Huffy Universal Elevator Mount - Manual
Huffy Universal Elevator Mount – Manual, read for free online in PDF format. We hope this helps you resolve any issues you may have. If you have further questions, please contact us through the contact form.
Table of Contents:
- Page 2 – WARNING; HEIGHT
- Page 3 – ROOF MOUNTING; SLANT ROOF
- Page 6 – washers here on spring
- Page 7 – HEIGHT ADJUSTMENT
- Page 8 – FOR POLE MOUNTING ONLY
- Page 9 – FLAT SURFACE MOUNTING
- Page 11 – HARDWARE IDENTIFIER; PARTS LIST
1
10/01
P/N 211125A
Customer Service Center
N53 W24700 South Corporate Circle
Sussex, WI 53089
U.S.A.
A Huffy Company
Required Tools and
Materials:
NOTE: Due to various mounting
methods, additional tools and
materials may be required.
• Two People
• Tape Measure
• Pencil
• Wrenches: (Two) 7/16”, 1/2”,
9/16”, 3/4”
or Large and Small Adjustable
Wrenches
• Step Ladder 8 ft. (2.4 m)
• Drill & Bit (3/8”)
• Carpenter Level
Universal Elevator Mount Owners Manual
printed on recycled paper
Toll-Free Customer Service Number for U.S:
1-800-558-5234
and Canada Only:
1-800-284-8339
Internet Address:
http://www.huffysports.com
WRITE IN YOUR MODEL NUMBER:
SAFETY INSTRUCTIONS
FAILURE TO FOLLOW THESE SAFETY INSTRUCTIONS MAY
RESULT IN SERIOUS INJURY,
PROPERTY DAMAGE AND WILL VOID WARRANTY.
Owner must ensure that all players know and follow these
rules for safe operation of the unit.
To ensure safety, do not attempt to assemble this system without
following the instructions carefully. Check entire box and inside all
p a c k i n g m a t e r i a l f o r p a r t s . B e f o r e b e g i n n i n g a s s e m b l y , r e a d t h e
instructions and identify parts using the hardware identifier and parts
l i s t i n t h i s d o c u m e n t . P r o p e r a n d c o m p l e t e a s s e m b l y , u s e a n d
supervision are essential for proper operation and to reduce the risk of
accident or injury. A high probability of serious injury exists if this
system is not installed, maintained, and operated properly.
• This equipment is intended for home recreational use only and NOT
excessive competitive play.
•
Read and understand the warning label enclosed with hardware. It is
the responsibility of the customer to mount this label. It should be
affixed to the pole, wall, or door near playing area, at a height between
4-6 feet (1.2 -1.8 m) above ground level and in a location visible to all
players.
•
During assembly, if using a ladder use extreme caution. Two people are
recommended for this operation.
•
If technical assistance is required, contact Huffy Sports.
•
Adult supervision is recommended when adjusting height.
Most injuries are caused
by misuse and/or
not following instructions.
Use caution when using this unit.
IMPORTANT!
Have questions...don’t go back to the store!
We appreciate your purchasing one of our many fine products. We are sure that you will be very satisfied with your selection. Although
great care and effort have been taken, occasionally problems may occur. To ensure prompt and correct handling of any problems, or to
answer any questions, please contact our Toll-Free Customer Service Number listed below.
Service will be quicker if you have your
Model Number (found on carton) and assembly instructions ready when calling. PLEASE WRITE YOUR MODEL NUMBER IN
THE SPACE PROVIDED ABOVE.
"Loading the manual" means you need to wait until the file loads and becomes available for online reading. Some manuals are very large, and the time they take to appear depends on your internet speed.
Summary
2 P/N 211125A 10/01 WARNING FAILURE TO FOLLOW THESE WARNINGS MAY RESULT IN SERIOUS INJURY AND/OR PROPERTY DAMAGE. Owner must ensure that all players know and follow these rules for safe operation of the unit. See instruction manual for proper installation and maintenance.Use caution when performing ...
3 10/01 P/N 211125A IMPORTANT! WRITE DOWN MODEL NUMBER FROM BOX ON PAGE 1 OF THIS OWNERS MANUAL 1. ROOF MOUNTING 2. 3 4 Secure struts (3) to upper holes on u-channel (2). NOTE: Position flat side of strut on u-channel. Tighten until snug. SLANT ROOF FLAT ROOF Install angle brackets (6 and 7) to lowe...
6 P/N 211125A 10/01 Assemble elevator tubes (17) to backboard bracket (8). 22 19 18 17 Backboard and Rim NOT Included 8 17 13. Starting with nuts flush against bracket (8), secure rim and bracket to backboard. NOTE: Mounting nuts and bolts not included. Bend bracket (8) to line up with holes in back...